Organic matter transformation ratio, hydrocarbon expulsion efficiency and shale oil enrichment type in Chang 7_(3) shale of Upper Triassic Yanchang Formation in Ordos Basin, NW China

The major enrichment type of shale oil in the Chang 7_(3) shale of Upper Triassic Yanchang Formation in the Ordos Basin is unknown.This paper analyzes the organic matter transformation ratio,hydrocarbon expulsion efficiency and roof/floor sealing conditions of the Chang 7_(3) shale,and evaluates the major enrichment type of shale oil in this interval.The average organic matter transformation ratio of the Chang 7_(3) shale is about 45%;in other words,more than 50%of the organic matters have not transformed to hydrocarbons,and the lower the maturity,the greater the proportion of untransformed organic matters.The cumulative hydrocarbon expulsion efficiency of the transformed hydrocarbon is 27.5% on average,and the total proportion of untransformed organic matters plus retained hydrocarbons is greater than 70%.The relative hydrocarbon expulsion efficiency of the Chang 7_(3) shale is 60%on average,that is,about 40% of hydrocarbons retain in the shale.The Chang 7_(3) shale corresponds to Chang 7_(1+2) and Chang 8 sandstones as the roof and floor,respectively,and is further overlaid by Chang 6 shale,where extensive low porosity and low permeability–tight oil reservoirs have formed in the parts with relatively good porosity and permeability.Moreover,the Chang 7_(3) shale is tested to be in a negative pressure system(the pressure coefficient of 0.80–0.85).Therefore,the roof/floor sealing conditions of the Chang 7_(3) shale are poor.The retained hydrocarbons appear mostly in absorbed status,with low mobility.It is concluded that the medium–high mature shale oil is not the major enrichment type of shale oil in the Chang 7_(3) shale,but there may be enrichment opportunity for shale oil with good mobility in the areas where the sealing conditions are good without faults and fractures and oil reservoirs are formed off Chang 7_(1+2),Chang 6 and Chang 8.Furthermore,low–medium mature shale oil is believed to have great potential and is the major enrichment type of shale oil in the Chang 7_(3) shale.It is recommended to prepare relevant in-situ conversion technologies by pilot test and figure out the resource availability and distribution.

Evaluation of Source Rock Potential for Hydrocarbon Generation in Shallow Offshore, Lamu Basin, Kenya

The ever-increasing demand for oil and gas has driven its exploration in rather extreme conditions. In Lamu offshore, which is hitherto underexplored, most of the wells already drilled turned out dry save for a few wells with hydrocarbon shows despite the promising reservoir properties and related geological structures. This, therefore, necessitated a source rock evaluation study in the area to ascertain the presence and potential of the source rock by integrating the geochemical data analysis and petroleum system modeling. The shallow Lamu offshore source rock quantity, quality, and maturity have been estimated through the determination of the total organic carbon (TOC) average values, Kerogen typing, and Rock-Eval pyrolysis measurements respectively. Geochemical data for Kubwa-1, Mbawa-1, Pomboo-1, and Simba-1 were evaluated for determining the source rock potential for hydrocarbon generation. Petroleum system modeling was applied in evaluating geological conditions necessary for a successful charge within a software that integrated geochemical and petrophysical characterization of the sedimentary formations in conjunction with boundary conditions that include basal heat flow, sediment-water interface temperature, and Paleo-water depth. The average TOC of 0.89 wt % in the study area suggests a fair organic richness which seems higher in the late cretaceous (0.98 wt %) than in the Paleocene (0.81 wt %). Vitrinite reflectance and Tmax values in the study area indicate the possible presence of both mature and immature source rocks. Type III Kerogen was the most dominant Kerogen type, and gas shows are the most frequent hydrocarbon encountered in the Lamu Basin with a few cases registering type II/III and type II. The charge properties (i.e. Temperature, transformation ratio, and Vitrinite reflectance) over geologic time at each of the wells have been estimated and their spatial variation mapped as seen from the burial history and depth curves overlaid with temperature, transformation ratio, and Vitrinite reflectance respectively. From the upper cretaceous maturity maps, the results seem to favor near coastal regions where average TOC is about 1.4 wt %, Vitrinite reflectance is more than 0.5%, transformation ratio is more than 10%, and temperatures range from 80°C to 160°C. The results postulate the absence of a definitive effective source rock with a likelihood of having cases of potential and possible source rocks. Moreover, greater uncertainty rests on the source rock’s presence and viability tending toward the deep offshore. Geochemical analysis and petroleum system modeling for hydrocarbon source rock evaluation improved the understanding of the occurrence of the possible and potential source rocks and processes necessary for hydrocarbon generation.

Arrival time measurements of first arrival phases P and PKIKP using the method of fixed scale wavelet transformation ratio

The arrival times of first teleseismic phases are difficult to be measured precisely because of slowly and gradually changed onsets and weak amplitudes. The arrival times measured manually are usually behind the real ones. In this paper, using the ratio method of fixed scale wavelet transformations improved by us, the arrival times for the first arrival phases (such as P and PKIKP) at the teleseismic and far-teleseismic distances were measured. The results are reasonable and reliable based on the analysis and discussion of the reliabilities and errors.

Molar ratio induced crystal transformation from coordination complex to coordination polymers

Coordination complex of a copper cyanurate(Cu(Ⅱ)-CA) was transformed into coordination polymers upon the stimulus of extra Cu(Ⅱ) through “directed Ostwald ripening”. By increasing the molar ratio of Cu(Ⅱ) to CA, we obtained two coordination polymers with selective coordination sites: Cu(Ⅱ)-κ N(HCA)κ NCu(Ⅱ) and Cu(Ⅱ)-κ N(HCA)κ O-Cu(Ⅱ), which display disparate magnetic interactions.

EFFECT OF QUENCHING TEMPERATURE ON SHAPE MEMORY EFFECT OF Fe-18Mn -5Si-8Cr-4Ni ALLOY

The effects of quenching temperature on shape memory effect and microstructure of Fe 18Mn 5Si 8Cr 4Ni shape memory alloy have been studied. The results show that both the shape recovery ratio and the recovery strain increased as quenching temperature increased, the amount of stress induced ε martensite in the process of cold work decreased with the increase of quenching temperature, the shape recovery ratio and the recovery strain reached maximum at 650℃, and then decreased rapidly with the further increase of quenching temperature,the stress induced ε martensite wholly disappeared at 1023K. But when the quenching temperature is higher than 1023K, the further increase of quenching temperature had little effect on shape recovery ratio, the amount and size of thermal induced ε martensite would increased with the further increase in quenching temperature. The shape memory effect can be improved by the moderate amount of pre exist ε martensite in the matrix before deforming.

Circulating Fluidized Bed Gasification of Low Rank Coal：Influence of O2/C Molar Ratio on Gasification Performance and Sulphur Transformation

To promote the utilization efficiency of coal resources,and to assist with the control of sulphur during gasification and/or downstream processes,it is essential to gain basic knowledge of sulphur transformation associated with gasification performance.In this research we investigated the influence of O_2/C molar ratio both on gasification performance and sulphur transformation of a low rank coal,and the sulphur transformation mechanism was also discussed.Experiments were performed in a circulating fluidized bed gasifier with O_2/C molar ratio ranging from 0.39 to 0.78 mol/mol.The results showed that increasing the O_2/C molar ratio from 0.39 to 0.78 mol/mol can increase carbon conversion from 57.65%to 91.92%,and increase sulphur release ratio from 29.66%to63.11%.The increase of O_2/C molar ratio favors the formation of H_2S,and also favors the retained sulphur transforming to more stable forms.Due to the reducing conditions of coal gasification,H_2S is the main form of the released sulphur,which could be formed by decomposition of pyrite and by secondary reactions.Bottom char shows lower sulphur content than fly ash,and mainly exist as sulphates.X-ray photoelectron spectroscopy(XPS)measurements also show that the intensity of pyrite declines and the intensity of sulphates increases for fly ash and bottom char,and the change is more obvious for bottom char.During CFB gasification process,bigger char particles circulate in the system and have longer residence time for further reaction,which favors the release of sulphur species and can enhance the retained sulphur transforming to more stable forms.

Optimization of Agrobacterium tumefaciens-Mediated Transformation Systems in Tea Plant(Camellia sinensis)

In this study, an efficient plant regeneration protocol in vitro and transformation by Agrobacterium-mediated method of Camellia sinensis was achieved, which would lay the foundation for genetic improvement of tea plant by genetic engineering technology. The cotyledon callus of C.sinensis were used as the receptors for transformation by Agrobacterium tumefaciens EHA105 containing PS1aG-3. Some factors which affected the result of Agrobacterium-mediated transformation of C. sinensis were studied on the basis of GUS transient expression system. The optimum system of Agrobacterium-mediated transformation was that the cotyledon callus were pre-cultured for 3 d, and then infected by EHA105 for 15 min followed by 3 d co-culture in the dark on the YEB medium containing 150 μmol·L^(-1) acetosyringone(AS). The transient expression rate of GUS gene was 62.6%. After being delayed selective culture for 3 d, infected callus were transferred into the differentiation medium and the root induction medium both of which were supplemented with 100 mg·L^(-1) spectinomycin, and then resistant seedlings of C. sinensis were obtained. The conversion rate was 3.6%.