可编程约瑟夫森电压基准(programmable Josephson voltage standard,PJVS)通过生成阶梯波构建交流量子电压,其产生量子电压台阶过程中,会伴生过渡过程,导致电压台阶两端数据的准确性较低。常见的数据处理方法是将过渡过程的数据剔除,仅...可编程约瑟夫森电压基准(programmable Josephson voltage standard,PJVS)通过生成阶梯波构建交流量子电压,其产生量子电压台阶过程中,会伴生过渡过程,导致电压台阶两端数据的准确性较低。常见的数据处理方法是将过渡过程的数据剔除,仅利用量子电压台阶上平稳区的数据,实现交流量子电压量值的复现。针对常用的3σ(σ为数据标准差)准则、片段采样方法等数据筛选准则,该文提出一种由量子电压台阶中心双向延拓并最小化A类测量不确定度的平稳区与过渡区判据,通过自动识别量子电压台阶的平稳区与过渡区,提升PJVS电压阶梯波复现交流电压量值的准确性。实验结果表明:该文提出的数据平稳区与过渡区的判据具有较高的鲁棒性和交流电压复现准确性,在2.5 kHz范围内,可使量子电压阶梯波信号复现交流电压幅值的偏差和A类测量不确定度均优于2.5×10-6。研究成果可有效提升量子电压阶梯波信号的测算准确性。展开更多
The superconducting quantum interference device（SQUID） amplifier is widely used in the field of weak signal detection for its low input impedance, low noise, and low power consumption. In this paper, the SQUIDs with...The superconducting quantum interference device（SQUID） amplifier is widely used in the field of weak signal detection for its low input impedance, low noise, and low power consumption. In this paper, the SQUIDs with identical junctions and the series SQUIDs with different junctions were successfully fabricated. The Nb/Al-AlOx/Nb trilayer and input Nb coils were prepared by asputtering equipment. The SQUID devices were prepared by a sputtering and the lift-off method.Investigations by AFM, OM and SEM revealed the morphology and roughness of the Nb films and Nb/Al-AlOx/Nb trilayer.In addition, the current–voltage characteristics of the SQUID devices with identical junction and different junction areas were measured at 2.5 K in the He^3 refrigerator. The results show that the SQUID modulation depth is obviously affected by the junction area. The modulation depth obviously increases with the increase of the junction area in a certain range. It is found that the series SQUID with identical junction area has a transimpedance gain of 58 Ω approximately.展开更多
In this paper, the positive influence of a uni-traveling-carrier （UTC） structure to ease the contract between the respon- sivity and working speed of the InP-based double hetero-junction phototransistor （DHPT） is ...In this paper, the positive influence of a uni-traveling-carrier （UTC） structure to ease the contract between the respon- sivity and working speed of the InP-based double hetero-junction phototransistor （DHPT） is illustrated in detail. Different results under electrical bias, optical bias or combined electrical and optical bias are analyzed for an excellent UTC-DHPT performance. The results show that when the UTC-DHPT operates at three-terminal （3T） working mode with combined electrical bias and optical bias in base, it keeps a high optical responsivity of 34.72 A/W and the highest optical transition frequency of 120 GHz. The current gain of the 3T UTC-DHPT under 1.55-μm light illuminations reaches 62 dB. This indicates that the combined base electrical bias and optical bias of 3T UTC-DHPT can make sure that the UTC-DHPT provides high optical current gain and high optical transition frequency simultaneously.展开更多
In this paper we study the traffic states and jams in vehicular traffic merging and bifurcating at a junction on a two-lane highway. The two-lane traffic model for the vehicular motion at the junction is presented whe...In this paper we study the traffic states and jams in vehicular traffic merging and bifurcating at a junction on a two-lane highway. The two-lane traffic model for the vehicular motion at the junction is presented where a jam occurs frequently due to merging, lane changing, and bifurcating. The traffic flow is called the weaving. At the weaving section, vehicles slow down and then move aside on the other lane for changing their direction. We derive the fundamental diagrams (flow-density diagrams) for the weaving traffic flow. The traffic states vary with the density, slowdown speed, and the fraction of vehicles changing the lane. The dynamical phase transitions occur. It is shown that the fundamental diagrams depend highly on the traffic states.展开更多
文摘可编程约瑟夫森电压基准(programmable Josephson voltage standard,PJVS)通过生成阶梯波构建交流量子电压,其产生量子电压台阶过程中,会伴生过渡过程,导致电压台阶两端数据的准确性较低。常见的数据处理方法是将过渡过程的数据剔除,仅利用量子电压台阶上平稳区的数据,实现交流量子电压量值的复现。针对常用的3σ(σ为数据标准差)准则、片段采样方法等数据筛选准则,该文提出一种由量子电压台阶中心双向延拓并最小化A类测量不确定度的平稳区与过渡区判据,通过自动识别量子电压台阶的平稳区与过渡区,提升PJVS电压阶梯波复现交流电压量值的准确性。实验结果表明:该文提出的数据平稳区与过渡区的判据具有较高的鲁棒性和交流电压复现准确性,在2.5 kHz范围内,可使量子电压阶梯波信号复现交流电压幅值的偏差和A类测量不确定度均优于2.5×10-6。研究成果可有效提升量子电压阶梯波信号的测算准确性。
基金Project supported by the National Natural Science Foundation of China(Grant No.11653001)the National Basic Research Program of China(Grant No.2011CBA00304)Tsinghua University Initiative Scientific Research Program,China(Grant No.20131089314)
文摘The superconducting quantum interference device（SQUID） amplifier is widely used in the field of weak signal detection for its low input impedance, low noise, and low power consumption. In this paper, the SQUIDs with identical junctions and the series SQUIDs with different junctions were successfully fabricated. The Nb/Al-AlOx/Nb trilayer and input Nb coils were prepared by asputtering equipment. The SQUID devices were prepared by a sputtering and the lift-off method.Investigations by AFM, OM and SEM revealed the morphology and roughness of the Nb films and Nb/Al-AlOx/Nb trilayer.In addition, the current–voltage characteristics of the SQUID devices with identical junction and different junction areas were measured at 2.5 K in the He^3 refrigerator. The results show that the SQUID modulation depth is obviously affected by the junction area. The modulation depth obviously increases with the increase of the junction area in a certain range. It is found that the series SQUID with identical junction area has a transimpedance gain of 58 Ω approximately.
基金Project supported by the National Natural Science Foundation of China(Grant No.61006044)the Natural Science Foundation of Beijing,China(Grant Nos.4122014 and 4142007)the Fund from the Beijing Municipal Education Committee,China(Grant No.KM200910005001)
文摘In this paper, the positive influence of a uni-traveling-carrier （UTC） structure to ease the contract between the respon- sivity and working speed of the InP-based double hetero-junction phototransistor （DHPT） is illustrated in detail. Different results under electrical bias, optical bias or combined electrical and optical bias are analyzed for an excellent UTC-DHPT performance. The results show that when the UTC-DHPT operates at three-terminal （3T） working mode with combined electrical bias and optical bias in base, it keeps a high optical responsivity of 34.72 A/W and the highest optical transition frequency of 120 GHz. The current gain of the 3T UTC-DHPT under 1.55-μm light illuminations reaches 62 dB. This indicates that the combined base electrical bias and optical bias of 3T UTC-DHPT can make sure that the UTC-DHPT provides high optical current gain and high optical transition frequency simultaneously.
文摘In this paper we study the traffic states and jams in vehicular traffic merging and bifurcating at a junction on a two-lane highway. The two-lane traffic model for the vehicular motion at the junction is presented where a jam occurs frequently due to merging, lane changing, and bifurcating. The traffic flow is called the weaving. At the weaving section, vehicles slow down and then move aside on the other lane for changing their direction. We derive the fundamental diagrams (flow-density diagrams) for the weaving traffic flow. The traffic states vary with the density, slowdown speed, and the fraction of vehicles changing the lane. The dynamical phase transitions occur. It is shown that the fundamental diagrams depend highly on the traffic states.
