The hydrogen reduction of tungsten oxides WO_(2.90),W_(20)O_(58) and WO_3 were directly studied using high temperature X-ray diffraction analysis.The differences between tetragonal WO_(2.90) and monoclinic W_(20)O_(58...The hydrogen reduction of tungsten oxides WO_(2.90),W_(20)O_(58) and WO_3 were directly studied using high temperature X-ray diffraction analysis.The differences between tetragonal WO_(2.90) and monoclinic W_(20)O_(58) were discussed.Pure β-W was obtained from oxide WO_(2.90),while there appears small amount of WO_2 during the reduction of W_(20)O_(58) to β-W.展开更多
The hydrogen reduction of tungsten oxides WO_(272)and WO_2 were studied directly using high-temperature X-ray diffraction analysis,The pure β-W was obtained from the reduction of WO_(272)The transformation of β-W to...The hydrogen reduction of tungsten oxides WO_(272)and WO_2 were studied directly using high-temperature X-ray diffraction analysis,The pure β-W was obtained from the reduction of WO_(272)The transformation of β-W to x-W was also studied in both hydrogen and nitrogen.The forming condition of β-W from WO_2 was discussed.Finally.a complete schematic diagram of reduction of tungsten oxides was given in this paper.展开更多
The WO_3/C composite was successfully prepared by calcination of a mixture of WO_3 and g-C_3N_4 at 520 ℃. The as-synthesized samples were analyzed by X-ray diffraction(XRD), electronic differential system(EDS), scann...The WO_3/C composite was successfully prepared by calcination of a mixture of WO_3 and g-C_3N_4 at 520 ℃. The as-synthesized samples were analyzed by X-ray diffraction(XRD), electronic differential system(EDS), scanning electron microscopy(SEM), infrared spectrometry(IR) and the Brunner-Emmet-Teller(BET) techniques. The WO_3/C composite, in comparison with the WO_3 and C_3N_4, features smaller particle size, bigger surface area and higher desulphurization performance. The influence of the reaction temperature, the catalyst dosage, the reaction time, the oxidant dosage, the sulfide type and the extractant dose on desulfurization reaction was studied. The results showed that the WO_3/C composite revealed a higher desulfurization activity than the WO_3. The desulfurization rate could reach up to 95.8% under optimal conditions covering a catalyst dosage of 0.02 g, a H_2O_2 amount of 0.2 mL, a 1-ethyl-3-methylimidazolium ethyl sulfate(EMIES) amount of 1.0 mL, a reaction temperature of 70 ℃ and a reaction time of 180 min. After five recycles, the desulfurization activity of catalyst did not significantly decline.展开更多
The polycrystalline phase WO_3/g-C_3N_4 was synthesized under stirring using tungstenic acid(H_2WO_4) and graphitic carbon nitride(g-C_3N_4) as raw materials. The catalyst was characterized by X-ray diffraction(XRD), ...The polycrystalline phase WO_3/g-C_3N_4 was synthesized under stirring using tungstenic acid(H_2WO_4) and graphitic carbon nitride(g-C_3N_4) as raw materials. The catalyst was characterized by X-ray diffraction(XRD), scanning electron microscopy(SEM),energy dispersive spectroscopy(EDS),the Fourier transform infrared spectroscopy(FT-IR),and the Brunauer-Emmett-Teller analysis(BET). The polycrystalline phase WO_3/g-C_3N_4 was determined by XRD technique. The oxidative desulfurization process was investigated using WO_3/g-C_3N_4 as the catalyst, 30% hydrogen peroxide(H202) as the oxidant, and 1-butyl-3-methylimidazolium tetrafluoroborate([bmim]BF4) ionic liquids(ILs) as the extractant. The operating conditions, including H_2WO_4 amount, IL dose, H_2 O_2 volume, temperature, catalyst dosage, and types of sulfur compounds,were systematically researched. The desulfurization rate could reach 98.46% for removing dibenzothiophene(DBT) from the model oil under optimal reaction conditions. In addition, the catalytic activity was slightly decreased after five recycles of catalysts. The reaction kinetics analysis shows that the oxidative desulfurization system was in accord with the first-order reaction kinetics equation. The mechanism of oxidative desulfurization was proposed.展开更多
Ni_xWO_(2.72) nanorods(NRs) are synthesized by a one-pot reaction of Ni(acac)_2 and WCl_4. In the rod structure, Ni(Ⅱ) intercalates in the defective perovskite-type WO_(2.72) and is stabilized. The Ni_xWO_(2.72) NRs ...Ni_xWO_(2.72) nanorods(NRs) are synthesized by a one-pot reaction of Ni(acac)_2 and WCl_4. In the rod structure, Ni(Ⅱ) intercalates in the defective perovskite-type WO_(2.72) and is stabilized. The Ni_xWO_(2.72) NRs show the x-dependent electrocatalysis for the oxygen evolution reaction(OER) in 0.1 M KOH with Ni_(0.78)WO_(2.72) being the most efficient, even outperforming the commercial Ir-catalyst. The synthesis is not limited to Ni_xWO_(2.72) but can be extended to M_xWO_(2.72)(M = Co, Fe) as well,providing a new class of oxide-based catalysts for efficient OER and other energy conversion reactions.展开更多
文摘The hydrogen reduction of tungsten oxides WO_(2.90),W_(20)O_(58) and WO_3 were directly studied using high temperature X-ray diffraction analysis.The differences between tetragonal WO_(2.90) and monoclinic W_(20)O_(58) were discussed.Pure β-W was obtained from oxide WO_(2.90),while there appears small amount of WO_2 during the reduction of W_(20)O_(58) to β-W.
文摘The hydrogen reduction of tungsten oxides WO_(272)and WO_2 were studied directly using high-temperature X-ray diffraction analysis,The pure β-W was obtained from the reduction of WO_(272)The transformation of β-W to x-W was also studied in both hydrogen and nitrogen.The forming condition of β-W from WO_2 was discussed.Finally.a complete schematic diagram of reduction of tungsten oxides was given in this paper.
基金the financial support of the Natural Science Foundation of China (Project No. 21003069)the Liaoning Province Doctoral Fund (Project No.201501105)
文摘The WO_3/C composite was successfully prepared by calcination of a mixture of WO_3 and g-C_3N_4 at 520 ℃. The as-synthesized samples were analyzed by X-ray diffraction(XRD), electronic differential system(EDS), scanning electron microscopy(SEM), infrared spectrometry(IR) and the Brunner-Emmet-Teller(BET) techniques. The WO_3/C composite, in comparison with the WO_3 and C_3N_4, features smaller particle size, bigger surface area and higher desulphurization performance. The influence of the reaction temperature, the catalyst dosage, the reaction time, the oxidant dosage, the sulfide type and the extractant dose on desulfurization reaction was studied. The results showed that the WO_3/C composite revealed a higher desulfurization activity than the WO_3. The desulfurization rate could reach up to 95.8% under optimal conditions covering a catalyst dosage of 0.02 g, a H_2O_2 amount of 0.2 mL, a 1-ethyl-3-methylimidazolium ethyl sulfate(EMIES) amount of 1.0 mL, a reaction temperature of 70 ℃ and a reaction time of 180 min. After five recycles, the desulfurization activity of catalyst did not significantly decline.
基金the financial support of the Doctoral Fund of Liaoning Province (201501105)
文摘The polycrystalline phase WO_3/g-C_3N_4 was synthesized under stirring using tungstenic acid(H_2WO_4) and graphitic carbon nitride(g-C_3N_4) as raw materials. The catalyst was characterized by X-ray diffraction(XRD), scanning electron microscopy(SEM),energy dispersive spectroscopy(EDS),the Fourier transform infrared spectroscopy(FT-IR),and the Brunauer-Emmett-Teller analysis(BET). The polycrystalline phase WO_3/g-C_3N_4 was determined by XRD technique. The oxidative desulfurization process was investigated using WO_3/g-C_3N_4 as the catalyst, 30% hydrogen peroxide(H202) as the oxidant, and 1-butyl-3-methylimidazolium tetrafluoroborate([bmim]BF4) ionic liquids(ILs) as the extractant. The operating conditions, including H_2WO_4 amount, IL dose, H_2 O_2 volume, temperature, catalyst dosage, and types of sulfur compounds,were systematically researched. The desulfurization rate could reach 98.46% for removing dibenzothiophene(DBT) from the model oil under optimal reaction conditions. In addition, the catalytic activity was slightly decreased after five recycles of catalysts. The reaction kinetics analysis shows that the oxidative desulfurization system was in accord with the first-order reaction kinetics equation. The mechanism of oxidative desulfurization was proposed.
基金supported by the U.S.Army Research Laboratory and the U.S. Army Research Office under grant W911NF-15-1-0147 on "New Composite Catalysts Based on Nitrogen-Doped Graphene and Nanoparticles for Advanced Electrocatalysis"Part of electron microscopy work used resources of the Center for Functional Nanomaterials, which is a U.S. DOE Office of Science Facility, at Brookhaven National Laboratory under Contract No. DE-SC0012704
文摘Ni_xWO_(2.72) nanorods(NRs) are synthesized by a one-pot reaction of Ni(acac)_2 and WCl_4. In the rod structure, Ni(Ⅱ) intercalates in the defective perovskite-type WO_(2.72) and is stabilized. The Ni_xWO_(2.72) NRs show the x-dependent electrocatalysis for the oxygen evolution reaction(OER) in 0.1 M KOH with Ni_(0.78)WO_(2.72) being the most efficient, even outperforming the commercial Ir-catalyst. The synthesis is not limited to Ni_xWO_(2.72) but can be extended to M_xWO_(2.72)(M = Co, Fe) as well,providing a new class of oxide-based catalysts for efficient OER and other energy conversion reactions.
