“Quartus scale” of hot-rolled strip steels and its formation mechanism

The types and growth of various oxide scales formed during the different phases of the production of hotrolled strip steel products are reviewed. Similarities and differences between the ＂tertiary scale＂ on the surface of carbon steels at high temperatures and the oxide scale on pure iron are compared. The micro-structural features of the ＂final oxide scale＂ on the surface of strip steels at room temperature as well as the relationship between these features and the position of the steel coil （plate） and the subsequent processes of recoiling, temper rolling and trimming, etc. are summarized. The actual oxide scales retained on the commercial hot-rolled strip steels at room temperature have been proposed to define as ＂ quartus scale＂ for the first time. The micro-structural development and phase transformation of the initial ＂tertiary scale＂ during and after cooling and coiling are described. The reasons for the ＂tertiary scale＂ on carbon steels differing from the oxide scale formed on pure iron, and the major influencing factors in the formation of various types of ＂quartus scales＂ are analyzed from both thermodynamic and dynamic viewpoints. The development mechanism of ＂ quartus scales＂ is discussed and the potential effects of the ＂ quartus scale＂ state （thickness, constitution, structure and defects）, on the rusting and pickling properties of commercial hot-rolled strip steel, as well as on the mechanical properties of oxide scales are analyzed.

Mill scale structure and damp heat corrosion performance of four 510L hot-rolled strips

In this study, the matrix structure, state and composition of the mill scales of four typical domestically made 510L hot-rolled strips were observed and analyzed by means of optical microscopy （OM） ,scanning electron microscopy （SEM） and X-ray diffraction （XRD）. The corrosion behavior of the steels with and without mill scales were investigated by means of hot-humid corrosion tests under the condition of relative humidity （ RH ） of 95% at 50℃ and 70℃, respectively. The results show that the matrix structures, state, composition and thickness of mill scales vary in the strips. The rusting starting time of the specimens with scales is generally a bit longer than that of the specimens without scales, but their corrosion mass-gain is higher. For these two kinds of specimens ,their corrosion rate increases significantly with the increase of temperature. The rusting behavior of the 510L strips produced by various plants is different due to the variations of hot-rolling processes and designed chemical compositions. Various relevant aspects should be taken into account in the evaluation of the corrosion behavior of hot-rolled strips.

Effects of Al contents on microstructure and properties of hot-dip Zn-Al alloy coatings on hydrogen reduced hot-rolled steel without acid pickling

A new hot-dip galvanizing method was employed on hot-rolled low carbon steel.The effects of Al contents on microstructure,micro-hardness and corrosion resistance of Zn-Al alloy coatings were systematically investigated.Phase composition,microstructure and element distribution in Zn-Al alloy coatings were analyzed using X-ray diffraction（XRD）and electron probe micro analysis（EPMA）,respectively.It is found that Al content（0.6-6.0 wt.%）in galvanizing zinc affects surface quality and adhesion between coatings and matrix in the newly developed method.In addition,with increasing Al content,micro-hardness significantly increased due to the increase in Zn-Al eutectoid phases.Potentiodynamic polarization and electrochemical impedance spectroscopy（EIS）also revealed that increase in Al plays a noticeable role in improving the corrosion resistance of Zn-Al alloy coatings.