An underdamped and delayed tri-stable model-based stochastic resonance

Stochastic resonance(SR) is investigated in an underdamped tri-stable potential system driven by Gaussian colored noise and a periodic excitation, where both displacement and velocity time-delayed states feedback are considered. It is challenging to study SR in a second-order delayed multi-stable system analytically. In this paper, the improved energy envelope stochastic average method is developed to derive the analytical expressions of stationary probability density(SPD)and spectral amplification. The effects of noise intensity, damping coefficient, and time delay on SR are analyzed. The results show that the shapes of joint SPD can be adjusted to the desired structure by choosing the time delay and feedback gains. For fixed time delay, the SR peak is increased for negative displacement or velocity feedback gain. Meanwhile, the SR peak is decreased while the optimal noise intensity increases with increasing correlation time of noise. The Monte Carlo simulations(MCS) confirm the effectiveness of the theoretical results.

The Equilibrium of Fractional Derivative and Second Derivative: The Mechanics of a Power-Law Visco-Elastic Solid

This paper investigates the equilibrium of fractional derivative and 2nd derivative, which occurs if the original function is damped (damping of a power-law viscoelastic solid with viscosities η of 0 ≤ η ≤ 1), where the fractional derivative corresponds to a force applied to the solid (e.g. an impact force), and the second derivative corresponds to acceleration of the solid’s centre of mass, and therefore to the inertial force. Consequently, the equilibrium satisfies the principle of the force equilibrium. Further-more, the paper provides a new definition of under- and overdamping that is not exclusively disjunctive, i.e. not either under- or over-damped as in a linear Voigt model, but rather exhibits damping phases co-existing consecutively as time progresses, separated not by critical damping, but rather by a transition phase. The three damping phases of a power-law viscoelastic solid—underdamping, transition and overdamping—are characterized by: underdamping—centre of mass oscillation about zero line;transition—centre of mass reciprocation without crossing the zero line;overdamping—power decay. The innovation of this new definition is critical for designing non-linear visco-elastic power-law dampers and fine-tuning the ratio of under- and overdamping, considering that three phases—underdamping, transition, and overdamping—co-exist consecutively if 0 < η < 0.401;two phases—transition and overdamping—co-exist consecutively if 0.401 < η < 0.578;and one phase— overdamping—exists exclusively if 0.578 < η < 1.

Effect of inertial mass on a linear system driven by dichotomous noise and a periodic signal

A linear system driven by dichotomous noise and a periodic signal is investigated in the underdamped case. The exact expressions of output signal amplitude and signal-to-noise ratio （SNR） of the system are derived. By means of numerical calculation, the results indicate that （i） at some fixed noise intensities, the output signal amplitude with inertial mass exhibits the structure of a single peak and single valley, or even two peaks if the dichotomous noise is asymmetric; （ii） in the case of asymmetric dichotomous noise, the inertial mass can cause non-monotonic behaviour of the output signal amplitude with respect to noise intensity; （iii） the curve of SNR versus inertial mass displays a maximum in the case of asymmetric dichotomous noise, i.e., a resonance-like phenomenon, while it decreases monotonically in the case of symmetric dichotomous noise; （iv） if the noise is symmetric, the inertial mass can induce stochastic resonance in the system.

Experimental and Analytical Study of Torsional Vibration under Multiaxial Loading in Time Domain

The torsional vibration of power transmission shaft is a phenomenon whose analytical modeling can be represented by a differential equation of motion proposed by technical literature. The solutions of these equations need coefficients and parameters that, usually, must be experimentally estimated. This work uses a resistive electric SG （strain gage） to dynamically determine strains produced in the shaft due to harmonic oscillatory motion under multiaxial loading. This movement is simulated on a prototype specially developed for this purpose. It comprises a pulley attached to the end of a stepped cantilevered shaft, which is clamped at the opposite end. In this configuration, a cam generates a torque to the system, springs regulate the stiffness and the damping coefficient of the assembly, as well as they can be suitably adjusted to produce an underdamped condition. The main advantage, highlighted in this study, refers to a major simplification. Although the system under study shows multiple degrees of freedom （torsion and bending）, the shape and the positioning of linking SGs with the resistor bridge （Wheatstone Bridge）, allow ＂to evaluate the loading effects independently, as if only one degree of freedom of the system exists at a time domain. Strains graphs for two forms of cyclic torsional oscillation, analytical and experimental, were successfully generated.