We continuously monitor the long-term seismic velocity variation of one of the major ruptured faults of the devastating 2008 Mw7.9 Wenchuan earthquake in China from July 2009 to January 2012,jointly using accurately c...We continuously monitor the long-term seismic velocity variation of one of the major ruptured faults of the devastating 2008 Mw7.9 Wenchuan earthquake in China from July 2009 to January 2012,jointly using accurately controlled routinely operated signal system active source and seismic noise-based monitoring technique.Our measurements show that the temporal velocity change is not homogeneous and highly localized in the damaged fault zone and the adjacent areas.Velocity variations from the active and passive methods are quite consistent,which both are characterized by ±0.2 % seasonal variation,with peak and trough at winter and summer,respectively.The periodic velocity variation within fault zone exhibits remarkably positive correlation with barometric pressure with stress sensitivity in the order of 10-6Pa-1,suggesting that the plausible mechanism might be the crack density variation of the shallow subsurface medium of the damaged fault zone in response to the cyclic barometric pressure loading.展开更多
Variation of shear-wave propagation velocity (SWV) with depth was studied by analyzing more than one hundred actual SWV profiles. Linear, power, and hyperbolic variation schemes were investigated to find the most re...Variation of shear-wave propagation velocity (SWV) with depth was studied by analyzing more than one hundred actual SWV profiles. Linear, power, and hyperbolic variation schemes were investigated to find the most representative form for naturally occurred alluvial deposits. It was found that hyperbolic (asymptotic) variation dominates the majority of cases and it can be reliably implemented in analytical or analytical-numerical procedures. Site response analyses for a one-layer heterogeneous stratum were conducted to find an equivalent homogeneous alternative which simplifies the analysis procedure but does not compromise the accuracy of the resonance and amplification responses. Harmonic average, arithmetic average and mid-value equivalents are chosen from the literature for investigation. Furthermore, full and partial depth averaging schemes were evaluated and compared in order to verify the validity of current practices which rely upon averaging shallow depths, viz., the first 30 m of the strata. Engineering bedrock concept was discussed and the results were compared.展开更多
The correction for antenna phase center is considered in processing Global Positioning System (GPS) data collected from a network of GPS ultra-short baselines. Compared with the leveling measurements, the GPS result...The correction for antenna phase center is considered in processing Global Positioning System (GPS) data collected from a network of GPS ultra-short baselines. Compared with the leveling measurements, the GPS results show that the relative vertical offsets for the pairs of GPS receiver antenna phase centers still exist, although absolute calibration of the antenna phase center variations (PCVs) has been considered. With respect to the TPS CR.G3 antenna, the relative vertical offset for the LEI AT504 antenna is 8.4 mm, the offset for the ASH701945C_M antenna is 5.5 mm, and those for the ASHY00936E_C and ASH701945B_M antennas are approximately between 2 mm and -3 mm. The relative offsets for the same type of antennas are approximately 1 mm. By correcting the absolute PCVs, the existing relative offset becomes negligible for horizontal positioning.展开更多
The shortcomings of an exit stress variation formula which has been well accepted are analyzed~ it is found that the exit stress variation formula violates the premise of the law of volume constancy. The shortcomings ...The shortcomings of an exit stress variation formula which has been well accepted are analyzed~ it is found that the exit stress variation formula violates the premise of the law of volume constancy. The shortcomings of an en- try stress variation formula are analyzed too, and the basic assumption of the formula is uniform exit velocity. How- ever, for a rigid-plastic material uniform exit velocity implies that the lateral distributioi1 of elongation is uniform, so the exit stress must be uniform and any type of flatness defect is impossible, which is contrary to the practice. In fact, entry and exit velocity variation influence entry and exit stress variation, and entry and exit stress variation in- fluence entry and exit velocity variation too, so a precise explicit stress variation formula cannot be got easily. Con- sidering the relationship between stress variation and velocity variation, an iteration method is presented to calculate entry and exit stress variation of cold rolling strip. To avoid divergent phenomenon of the iteration course, a relaxa- tion factor method is adopted. The calculation results are compared with the entry and exit stress variation formula commonly used by many researchers. The difference is remarkable, while the result calculated agree more well with measured result if the exit elastic recovery zone is considered. Specially, the incoming flatnessI propagate efficiency calculated ~ives a more realistic result.展开更多
In this study,the flow structure and effect of different pump rotational speeds on a centrifugal pump’s performance are experimentally and numerically investigated.The internal flow field pattern within the pump has ...In this study,the flow structure and effect of different pump rotational speeds on a centrifugal pump’s performance are experimentally and numerically investigated.The internal flow field pattern within the pump has been analyzed and discussed using the CFD technique.The numerical results are compared with experimental data under a wide range of operating conditions.The comparison results between them have indicated a considerable agreement.The pressure variations are gradually increasing from inlet to outlet impeller of the pump.The results note that when the impeller rotates near the tongue region,the pressure in this region was higher than in other parts.Also,the interaction between the impeller and volute tongue region is actually according to the impeller blades’relative position concerning the tongue region.Furthermore,the pressure and velocity variations within a centrifugal pump increase with rotational impeller speed.展开更多
基金supported by the National Natural Science Foundation of China with Grant No.41174040the Wenchuan earthquake Fault Scientific Drilling project
文摘We continuously monitor the long-term seismic velocity variation of one of the major ruptured faults of the devastating 2008 Mw7.9 Wenchuan earthquake in China from July 2009 to January 2012,jointly using accurately controlled routinely operated signal system active source and seismic noise-based monitoring technique.Our measurements show that the temporal velocity change is not homogeneous and highly localized in the damaged fault zone and the adjacent areas.Velocity variations from the active and passive methods are quite consistent,which both are characterized by ±0.2 % seasonal variation,with peak and trough at winter and summer,respectively.The periodic velocity variation within fault zone exhibits remarkably positive correlation with barometric pressure with stress sensitivity in the order of 10-6Pa-1,suggesting that the plausible mechanism might be the crack density variation of the shallow subsurface medium of the damaged fault zone in response to the cyclic barometric pressure loading.
文摘Variation of shear-wave propagation velocity (SWV) with depth was studied by analyzing more than one hundred actual SWV profiles. Linear, power, and hyperbolic variation schemes were investigated to find the most representative form for naturally occurred alluvial deposits. It was found that hyperbolic (asymptotic) variation dominates the majority of cases and it can be reliably implemented in analytical or analytical-numerical procedures. Site response analyses for a one-layer heterogeneous stratum were conducted to find an equivalent homogeneous alternative which simplifies the analysis procedure but does not compromise the accuracy of the resonance and amplification responses. Harmonic average, arithmetic average and mid-value equivalents are chosen from the literature for investigation. Furthermore, full and partial depth averaging schemes were evaluated and compared in order to verify the validity of current practices which rely upon averaging shallow depths, viz., the first 30 m of the strata. Engineering bedrock concept was discussed and the results were compared.
基金supported by the Science for Earthquake Resilience(XH14070Y,XH15064Y)the China NationalSpecial Fund for Earthquake Scientific Research in Public Interest(201208009)
文摘The correction for antenna phase center is considered in processing Global Positioning System (GPS) data collected from a network of GPS ultra-short baselines. Compared with the leveling measurements, the GPS results show that the relative vertical offsets for the pairs of GPS receiver antenna phase centers still exist, although absolute calibration of the antenna phase center variations (PCVs) has been considered. With respect to the TPS CR.G3 antenna, the relative vertical offset for the LEI AT504 antenna is 8.4 mm, the offset for the ASH701945C_M antenna is 5.5 mm, and those for the ASHY00936E_C and ASH701945B_M antennas are approximately between 2 mm and -3 mm. The relative offsets for the same type of antennas are approximately 1 mm. By correcting the absolute PCVs, the existing relative offset becomes negligible for horizontal positioning.
基金Sponsored by National Science and Technology Support Plan of China (2009AA04Z143)Science and Technology Support Plan of Hebei Province (10212101D)Science and Technology Project of Qinhuangdao City (200902B012)
文摘The shortcomings of an exit stress variation formula which has been well accepted are analyzed~ it is found that the exit stress variation formula violates the premise of the law of volume constancy. The shortcomings of an en- try stress variation formula are analyzed too, and the basic assumption of the formula is uniform exit velocity. How- ever, for a rigid-plastic material uniform exit velocity implies that the lateral distributioi1 of elongation is uniform, so the exit stress must be uniform and any type of flatness defect is impossible, which is contrary to the practice. In fact, entry and exit velocity variation influence entry and exit stress variation, and entry and exit stress variation in- fluence entry and exit velocity variation too, so a precise explicit stress variation formula cannot be got easily. Con- sidering the relationship between stress variation and velocity variation, an iteration method is presented to calculate entry and exit stress variation of cold rolling strip. To avoid divergent phenomenon of the iteration course, a relaxa- tion factor method is adopted. The calculation results are compared with the entry and exit stress variation formula commonly used by many researchers. The difference is remarkable, while the result calculated agree more well with measured result if the exit elastic recovery zone is considered. Specially, the incoming flatnessI propagate efficiency calculated ~ives a more realistic result.
文摘In this study,the flow structure and effect of different pump rotational speeds on a centrifugal pump’s performance are experimentally and numerically investigated.The internal flow field pattern within the pump has been analyzed and discussed using the CFD technique.The numerical results are compared with experimental data under a wide range of operating conditions.The comparison results between them have indicated a considerable agreement.The pressure variations are gradually increasing from inlet to outlet impeller of the pump.The results note that when the impeller rotates near the tongue region,the pressure in this region was higher than in other parts.Also,the interaction between the impeller and volute tongue region is actually according to the impeller blades’relative position concerning the tongue region.Furthermore,the pressure and velocity variations within a centrifugal pump increase with rotational impeller speed.