Climate in China's Mainland can be divided into the monsoon region in the southeast and the westerly region in the northwest as well as the intercross zone, i.e., the monsoon northernmost marginal active zone that...Climate in China's Mainland can be divided into the monsoon region in the southeast and the westerly region in the northwest as well as the intercross zone, i.e., the monsoon northernmost marginal active zone that is oriented from Southwest China to the upper Yellow River, North China, and Northeast China. In the three regions, dry-wet climate changes are directly linked to the interaction of the southerly monsoon flow on the east side of the Tibetan Plateau and the westerly flow on the north side of the Plateau from the inter-annual to inter-decadal timescales. Some basic features of climate variability in the three regions for the last half century and the historical hundreds of years are reviewed in this paper. In the last half century, an increasing trend of summer precipitation associated with the enhancing westerly flow is found in the westerly region from Xinjiang to northern parts of North China and Northeast China. On the other hand, an increasing trend of summer precipitation along the Yangtze River and a decreasing trend of summer precipitation along the monsoon northernmost marginal active zone are associated with the weakening monsoon flow in East Asia. Historical documents are widely distributed in the monsoon region for hundreds of years and natural climate proxies are constructed in the non-monsoon region, while two types of climate proxies can be commonly found over the monsoon northernmost marginal active zone. In the monsoon region, dry-wet variation centers are altered among North China, the lower Yangtze River, and South China from one century to another. Dry or wet anomalies are firstly observed along the monsoon northernmost marginal active zone and shifted southward or southeastward to the Yangtze River valley and South China in about a 70-year timescale. Severe drought events are experienced along the monsoon northernmost marginal active zone during the last 5 centuries. Inter-decadal dry-wet variations are depicted by natural proxies for the last 4-5 centuries in several areas over the non-monsoon region. Some questions, such as the impact of global warming on dry-wet regime changes in China, complex interactions between the monsoon and westerly flows in Northeast China, and the integrated multi-proxy analysis throughout all of China, are proposed.展开更多
Wet coffee processing leads to the generation of large volumes of wastewater, whose discharge to the environment leads to pollution of freshwater bodies. Kayanza is a major coffee growing area in Burundi with more tha...Wet coffee processing leads to the generation of large volumes of wastewater, whose discharge to the environment leads to pollution of freshwater bodies. Kayanza is a major coffee growing area in Burundi with more than 40 wet coffee processing factories (WCPF) that discharge effluents directly to receiving water bodies without treatment. This study was carried out to assess the effect of coffee wastewater on the physicochemical properties of receiving waterbodies in Kayanza coffee growing ecological zone. Currently, no study has been done to analyze the effluent from the WCPF and assess the level of pollution. This study will therefore provide valuable data on the water pollution from coffee processing plants. Ten (10) rivers in the Kayanza coffee growing zone were studied during the months of April and June, 2020. Water samples were collected upstream (U) and downstream (D) of the effluent discharge points in triplicate. Samples were analyzed for pH, Chemical Oxygen Demand (COD), Biochemical Oxygen Demand (BOD<sub>5</sub>), Temperature, Salinity, Electrical Conductivity (EC), Total Dissolved Solids (TDS), Dissolved Oxygen (DO), Total Suspended Solids (TSS), Nitrates, Nitrites, Lead (Pb), Copper (Cu), Chlorides and Ammonium ions using standard methods. <span style="letter-spacing:0.1pt;">Ph</span>ysical parameters were analyzed in situ whereas chemical param<span style="letter-spacing:0.1pt;">eters w</span><span style="letter-spacing:-0.05pt;">ere analy</span>zed in the laboratories in Burundi Institute of Agricultural Science<span style="letter-spacing:0.1pt;">s</span> (ISA<span style="letter-spacing:-0.2pt;">BU) and University of Burundi. Data were analyzed u</span>sing R-studio-1.0.153, GenStat 64-bit Release 14.1 and SSPS. Results on the physicochemical parameters indicated that coffee factory effluent has a polluting potential during coffee processing peak. The concentrations of the physicochemical parameters were significantly (p < 0.05) higher downstream (D) compared to upstream (U) of the river water sampling points. All downstream sites had COD, BOD<sub>5</sub>, TSS and pH values above allowable limits set by WHO and Burundi. The polluting impact of public wet coffee processing factories was significantly higher than that of private and cooperatives owned factories (p < 0.05). Measures should be taken in order to protect water bodies.展开更多
The water absorption and desorption processes of different types of lightweight aggregates were studied.Subsequently,the influences of pre-wetting lightweight aggregates on compressive strength,microhardness,phase com...The water absorption and desorption processes of different types of lightweight aggregates were studied.Subsequently,the influences of pre-wetting lightweight aggregates on compressive strength,microhardness,phase composition,hydration parameters and micromorphology of the cement pastes were investigated.The results showed that the water absorption and desorption capacities of the lightweight aggregates increased with the decrease of the densification degree.With the addition of pre-wetting lightweight aggregates,the compressive strength of the cement pastes would increase.Moreover,the enhancement effect was more obviously with the desorption capacity of pre-wetting lightweight aggregates increasing.Especially,sample S1 with pre-wetting red-mud ceramisites had the highest compressive strength,of which increased to 49.4 MPa after 28 d curing age.The reason is that mainly because the addition of pre-wetting lightweight aggregates can promote the generation of C–S–H gels in the interfacial zone,and the hydration degree of the interfacial zone increases with the water desorption of pre-wetting lightweight aggregates increasing.It is contributed to optimize the microstructure to enhance microhardness of the interfacial zone,resulting in the compressive strength of the cement-based materials improving.Therefore,the pre-wetting lightweight aggregates with high porosity and strength are the potential internal curing agents for high-strength lightweight concretes.展开更多
The presence of stress is shown to have a significant impact on chloride ions in concrete. Reinforced concrete is usually durable and cost-effective which has resulted in its widespread use for construction, however, ...The presence of stress is shown to have a significant impact on chloride ions in concrete. Reinforced concrete is usually durable and cost-effective which has resulted in its widespread use for construction, however, the concrete subjected to environment and load has become increasingly apparently that attacked by aggressive agents such as chloride ion. In this study, the coupling influences are stress effects and environmental problems on the coastline concrete durability have been investigated. A series of cyclic of a wet-dry cycle and submersion tests were performed onto the stressed concrete to obtain an understanding of the physical mechanisms causing the accumulation of chlorides in the interior pores of concrete under different stress types and exposure environments, based on the same duration. Specimens were prepared and subjected to NaCl solution in a wet-dry cycle and submersion, the chloride in the tension zone is gradual with increasing the stress level, as well as the chloride ion in the wet-dry cycle, is increasing the number of cycles. The apparent diffusion coefficient of each specimen was calculated respectively, the profile of concentration at a different section of tension and compression zones were presented in influence factors of the number of cycles, the length of drying phase, and periodic wetting cycles with sodium solution was discussed. After employed Fick’s second law, the results suggested D<sub>a</sub> in a wet-dry cycle is much higher than the D<sub>a</sub> in submersion zones.展开更多
基金supported by the National Natural Science Foundation of China(Nos40890053,90502001,and 90711003)
文摘Climate in China's Mainland can be divided into the monsoon region in the southeast and the westerly region in the northwest as well as the intercross zone, i.e., the monsoon northernmost marginal active zone that is oriented from Southwest China to the upper Yellow River, North China, and Northeast China. In the three regions, dry-wet climate changes are directly linked to the interaction of the southerly monsoon flow on the east side of the Tibetan Plateau and the westerly flow on the north side of the Plateau from the inter-annual to inter-decadal timescales. Some basic features of climate variability in the three regions for the last half century and the historical hundreds of years are reviewed in this paper. In the last half century, an increasing trend of summer precipitation associated with the enhancing westerly flow is found in the westerly region from Xinjiang to northern parts of North China and Northeast China. On the other hand, an increasing trend of summer precipitation along the Yangtze River and a decreasing trend of summer precipitation along the monsoon northernmost marginal active zone are associated with the weakening monsoon flow in East Asia. Historical documents are widely distributed in the monsoon region for hundreds of years and natural climate proxies are constructed in the non-monsoon region, while two types of climate proxies can be commonly found over the monsoon northernmost marginal active zone. In the monsoon region, dry-wet variation centers are altered among North China, the lower Yangtze River, and South China from one century to another. Dry or wet anomalies are firstly observed along the monsoon northernmost marginal active zone and shifted southward or southeastward to the Yangtze River valley and South China in about a 70-year timescale. Severe drought events are experienced along the monsoon northernmost marginal active zone during the last 5 centuries. Inter-decadal dry-wet variations are depicted by natural proxies for the last 4-5 centuries in several areas over the non-monsoon region. Some questions, such as the impact of global warming on dry-wet regime changes in China, complex interactions between the monsoon and westerly flows in Northeast China, and the integrated multi-proxy analysis throughout all of China, are proposed.
文摘Wet coffee processing leads to the generation of large volumes of wastewater, whose discharge to the environment leads to pollution of freshwater bodies. Kayanza is a major coffee growing area in Burundi with more than 40 wet coffee processing factories (WCPF) that discharge effluents directly to receiving water bodies without treatment. This study was carried out to assess the effect of coffee wastewater on the physicochemical properties of receiving waterbodies in Kayanza coffee growing ecological zone. Currently, no study has been done to analyze the effluent from the WCPF and assess the level of pollution. This study will therefore provide valuable data on the water pollution from coffee processing plants. Ten (10) rivers in the Kayanza coffee growing zone were studied during the months of April and June, 2020. Water samples were collected upstream (U) and downstream (D) of the effluent discharge points in triplicate. Samples were analyzed for pH, Chemical Oxygen Demand (COD), Biochemical Oxygen Demand (BOD<sub>5</sub>), Temperature, Salinity, Electrical Conductivity (EC), Total Dissolved Solids (TDS), Dissolved Oxygen (DO), Total Suspended Solids (TSS), Nitrates, Nitrites, Lead (Pb), Copper (Cu), Chlorides and Ammonium ions using standard methods. <span style="letter-spacing:0.1pt;">Ph</span>ysical parameters were analyzed in situ whereas chemical param<span style="letter-spacing:0.1pt;">eters w</span><span style="letter-spacing:-0.05pt;">ere analy</span>zed in the laboratories in Burundi Institute of Agricultural Science<span style="letter-spacing:0.1pt;">s</span> (ISA<span style="letter-spacing:-0.2pt;">BU) and University of Burundi. Data were analyzed u</span>sing R-studio-1.0.153, GenStat 64-bit Release 14.1 and SSPS. Results on the physicochemical parameters indicated that coffee factory effluent has a polluting potential during coffee processing peak. The concentrations of the physicochemical parameters were significantly (p < 0.05) higher downstream (D) compared to upstream (U) of the river water sampling points. All downstream sites had COD, BOD<sub>5</sub>, TSS and pH values above allowable limits set by WHO and Burundi. The polluting impact of public wet coffee processing factories was significantly higher than that of private and cooperatives owned factories (p < 0.05). Measures should be taken in order to protect water bodies.
基金Funded by National Natural Science Foundation of China(Nos.51878003 and 51778513)Major Special Science and Technology Project of Hubei Province(No.2018AAA001)the National Basic Research Program of China(973 Program)(No.2015CB655101).
文摘The water absorption and desorption processes of different types of lightweight aggregates were studied.Subsequently,the influences of pre-wetting lightweight aggregates on compressive strength,microhardness,phase composition,hydration parameters and micromorphology of the cement pastes were investigated.The results showed that the water absorption and desorption capacities of the lightweight aggregates increased with the decrease of the densification degree.With the addition of pre-wetting lightweight aggregates,the compressive strength of the cement pastes would increase.Moreover,the enhancement effect was more obviously with the desorption capacity of pre-wetting lightweight aggregates increasing.Especially,sample S1 with pre-wetting red-mud ceramisites had the highest compressive strength,of which increased to 49.4 MPa after 28 d curing age.The reason is that mainly because the addition of pre-wetting lightweight aggregates can promote the generation of C–S–H gels in the interfacial zone,and the hydration degree of the interfacial zone increases with the water desorption of pre-wetting lightweight aggregates increasing.It is contributed to optimize the microstructure to enhance microhardness of the interfacial zone,resulting in the compressive strength of the cement-based materials improving.Therefore,the pre-wetting lightweight aggregates with high porosity and strength are the potential internal curing agents for high-strength lightweight concretes.
文摘The presence of stress is shown to have a significant impact on chloride ions in concrete. Reinforced concrete is usually durable and cost-effective which has resulted in its widespread use for construction, however, the concrete subjected to environment and load has become increasingly apparently that attacked by aggressive agents such as chloride ion. In this study, the coupling influences are stress effects and environmental problems on the coastline concrete durability have been investigated. A series of cyclic of a wet-dry cycle and submersion tests were performed onto the stressed concrete to obtain an understanding of the physical mechanisms causing the accumulation of chlorides in the interior pores of concrete under different stress types and exposure environments, based on the same duration. Specimens were prepared and subjected to NaCl solution in a wet-dry cycle and submersion, the chloride in the tension zone is gradual with increasing the stress level, as well as the chloride ion in the wet-dry cycle, is increasing the number of cycles. The apparent diffusion coefficient of each specimen was calculated respectively, the profile of concentration at a different section of tension and compression zones were presented in influence factors of the number of cycles, the length of drying phase, and periodic wetting cycles with sodium solution was discussed. After employed Fick’s second law, the results suggested D<sub>a</sub> in a wet-dry cycle is much higher than the D<sub>a</sub> in submersion zones.
