In order to design the scale model in a wide frequency range,a method based on the reflective loss is proposed according to the high-frequency approximation algorithm,and an example of designing the scale model of a p...In order to design the scale model in a wide frequency range,a method based on the reflective loss is proposed according to the high-frequency approximation algorithm,and an example of designing the scale model of a plate-shaped absorber is given in this paper.In the example,the frequency of the full-size measurement ranges from 2.0 GHz to 2.4 GHz,the thickness of the full-size absorber is 1 mm and the scale ratio is 1/5.A two-layer scale absorber is obtained by the proposed method.The thickness values of the bottom and top layer are 0.4 mm and 0.5 mm,respectively.Furthermore,the scattering properties of a plate model and an SLICY model are studied by FEKO to verify the effectiveness of the designed scale absorber.Compared with the corresponding values from the theoretical scale model,the average values of the absolute deviations in 10 GHz～12 GHz are 0.53 d Bm^2,0.65 d Bm^2,0.76 d Bm^2 for the plate model and 0.20 d Bm^2,0.95 d Bm^2,0.77 d Bm^2 for the SLICY model while the incident angles are 0°,30°,and 60°,respectively.These deviations fall within the Radar cross section（RCS） measurement tolerance.Thus,the work in this paper has important theoretical and practical significance.展开更多
A wide range fractional-N frequency synthesizer in 0.18μm RF CMOS technology is implemented. A switched-capacitors bank LC-tank VCO and an adaptive frequency calibration technique are used to expand the frequency ran...A wide range fractional-N frequency synthesizer in 0.18μm RF CMOS technology is implemented. A switched-capacitors bank LC-tank VCO and an adaptive frequency calibration technique are used to expand the frequency range.A 16-bit third-order sigma-delta modulator with dither is used to randomize the fractional spur. The active area is 0.6 mm;.The experimental results show the proposed frequency synthesizer consumes 4.3 raA from a single 1.8 V supply voltage except for buffers.The frequency range is 1.44-2.11 GHz and the frequency resolution is less than 0.4 kHz.The phase noise is -94 dBc/Hz @ 100 kHz and -121 dBc/Hz @ 1 MHz at the output of the prescaler with a loop bandwidth of approximately 120 kHz.The performance meets the requirements for the multi-band and multi-mode transceiver applications.展开更多
基金Project supported by the National Natural Science Foundation of China(Grant Nos.61601299 and 11404213)the Shanghai Municipal Science and Technology Commission,China(Grant Nos.17210730900 and 15ZR1439600)the Defense Industrial Technology,China(Grant No.B2120132001)
文摘In order to design the scale model in a wide frequency range,a method based on the reflective loss is proposed according to the high-frequency approximation algorithm,and an example of designing the scale model of a plate-shaped absorber is given in this paper.In the example,the frequency of the full-size measurement ranges from 2.0 GHz to 2.4 GHz,the thickness of the full-size absorber is 1 mm and the scale ratio is 1/5.A two-layer scale absorber is obtained by the proposed method.The thickness values of the bottom and top layer are 0.4 mm and 0.5 mm,respectively.Furthermore,the scattering properties of a plate model and an SLICY model are studied by FEKO to verify the effectiveness of the designed scale absorber.Compared with the corresponding values from the theoretical scale model,the average values of the absolute deviations in 10 GHz～12 GHz are 0.53 d Bm^2,0.65 d Bm^2,0.76 d Bm^2 for the plate model and 0.20 d Bm^2,0.95 d Bm^2,0.77 d Bm^2 for the SLICY model while the incident angles are 0°,30°,and 60°,respectively.These deviations fall within the Radar cross section（RCS） measurement tolerance.Thus,the work in this paper has important theoretical and practical significance.
文摘A wide range fractional-N frequency synthesizer in 0.18μm RF CMOS technology is implemented. A switched-capacitors bank LC-tank VCO and an adaptive frequency calibration technique are used to expand the frequency range.A 16-bit third-order sigma-delta modulator with dither is used to randomize the fractional spur. The active area is 0.6 mm;.The experimental results show the proposed frequency synthesizer consumes 4.3 raA from a single 1.8 V supply voltage except for buffers.The frequency range is 1.44-2.11 GHz and the frequency resolution is less than 0.4 kHz.The phase noise is -94 dBc/Hz @ 100 kHz and -121 dBc/Hz @ 1 MHz at the output of the prescaler with a loop bandwidth of approximately 120 kHz.The performance meets the requirements for the multi-band and multi-mode transceiver applications.
