Based on the local configuration angle division to select the corresponding method for electromagnetic scattering calculation from rough sea surface, this paper presents an angular cutoff composite model： when the lo...Based on the local configuration angle division to select the corresponding method for electromagnetic scattering calculation from rough sea surface, this paper presents an angular cutoff composite model： when the local scattered angle is in the specular region that is given by an approximately 20 degrees cone around the specular direction, the Kirchhoff approximation is applied to evaluate the specular reflection, which dominates the total scattering in this region; the small perturbation method is employed to handle the diffuse reflection which is predominant as the local scattered angle is situated out of the specular region. Numerical results are compared with those of experimental and theoretical models in several configurations as a function of incident angle, wind speed, wind direction. The comparison of numerical results of other experimental and theoretical models in several configurations shows that the new composite model is robust to give accurate numerical evaluations for the sea surface scattering.展开更多
Electromagnetic （EM） scattering from a stack of two rough interfaces separating a homogeneous medium with a perfectly electric conducting （PEC） object has been calculated through the method of moments for vertical...Electromagnetic （EM） scattering from a stack of two rough interfaces separating a homogeneous medium with a perfectly electric conducting （PEC） object has been calculated through the method of moments for vertical polarization. Theoretical formulations of EM scattering from multi-layered rough interfaces with a PEC object have been derived in detail and the total fields and their normal derivatives on the rough interfaces are solved. The two-layered model is a special case. In this work, a Gaussian rough surface was applied to simulate the rough interface. A cylinder was located above, between or below the two-layered rough interfaces. Through numerical simulations, the validity of this work is demonstrated by comparing it with existing scattering models, which are special cases that include a PEC object located above/below a single-layered rough interface and two-layered rough interfaces without an object. Subsequently, the influences of characteristic parameters, such as the relative permittivity of the medium, as well as the average height between the two rough surfaces, on the bistatic scattering coefficient are discussed.展开更多
We describe the synthesis of three-dimensional(3D) multilayer ZnO@Ag/SiO2@Ag nanorod arrays by the physico–chemical method. The surface-enhanced Raman scattering(SERS) performance of the 3D multilayer Zn O@Ag/SiO2@Ag...We describe the synthesis of three-dimensional(3D) multilayer ZnO@Ag/SiO2@Ag nanorod arrays by the physico–chemical method. The surface-enhanced Raman scattering(SERS) performance of the 3D multilayer Zn O@Ag/SiO2@Ag nanorod arrays is studied by varying the thickness of dielectric layer SiO2 and outer-layer noble Ag. The 3D Zn O@Ag/SiO2@Ag nanorod arrays create a huge number of SERS "hot spots" that mainly contribute to the high SERS sensitivity. The great enhancement of SERS results from the electron transfer between ZnO and Ag and different electromagnetic enhancements of Ag nanoparticles(NPs) with different thicknesses. Through the finite-difference time-domain(FDTD) theoretical simulation, the enhancement of SERS signal can be ascribed to a strong electric field enhancement produced in the 3D framework. The simplicity and generality of our method offer great advantages for further understanding the SERS mechanism induced by the surface plasmon resonance(SPR) effect.展开更多
基金supported by the National Natural Science Foundation of China (Grant No. 60871070)the National Pre-research Foundation and the Foundation of the National Electromagnetic Scattering Laboratory
文摘Based on the local configuration angle division to select the corresponding method for electromagnetic scattering calculation from rough sea surface, this paper presents an angular cutoff composite model： when the local scattered angle is in the specular region that is given by an approximately 20 degrees cone around the specular direction, the Kirchhoff approximation is applied to evaluate the specular reflection, which dominates the total scattering in this region; the small perturbation method is employed to handle the diffuse reflection which is predominant as the local scattered angle is situated out of the specular region. Numerical results are compared with those of experimental and theoretical models in several configurations as a function of incident angle, wind speed, wind direction. The comparison of numerical results of other experimental and theoretical models in several configurations shows that the new composite model is robust to give accurate numerical evaluations for the sea surface scattering.
基金Project supported by the National Natural Science Foundation of China (Grant No. 60971067)the Specialized Research Fund for the Doctoral Program of Higher Education,China (Grant No. 20100203110016)the Fundamental Research Funds for the Central Universities,China (Grant No. K50510070001)
文摘Electromagnetic （EM） scattering from a stack of two rough interfaces separating a homogeneous medium with a perfectly electric conducting （PEC） object has been calculated through the method of moments for vertical polarization. Theoretical formulations of EM scattering from multi-layered rough interfaces with a PEC object have been derived in detail and the total fields and their normal derivatives on the rough interfaces are solved. The two-layered model is a special case. In this work, a Gaussian rough surface was applied to simulate the rough interface. A cylinder was located above, between or below the two-layered rough interfaces. Through numerical simulations, the validity of this work is demonstrated by comparing it with existing scattering models, which are special cases that include a PEC object located above/below a single-layered rough interface and two-layered rough interfaces without an object. Subsequently, the influences of characteristic parameters, such as the relative permittivity of the medium, as well as the average height between the two rough surfaces, on the bistatic scattering coefficient are discussed.
基金Project supported by the Fund from the Science and Technology Department of Jilin Province,China(Grant No.20170520108JH)the Beihua University Youth Nurtural Fund,China(Grant No.2017QNJJL15)+1 种基金the Beihua University PhD Research Start-up Fund,China(Grant No.202116140)the Undergraduate Innovation Project,China(Grant No.220718100)
文摘We describe the synthesis of three-dimensional(3D) multilayer ZnO@Ag/SiO2@Ag nanorod arrays by the physico–chemical method. The surface-enhanced Raman scattering(SERS) performance of the 3D multilayer Zn O@Ag/SiO2@Ag nanorod arrays is studied by varying the thickness of dielectric layer SiO2 and outer-layer noble Ag. The 3D Zn O@Ag/SiO2@Ag nanorod arrays create a huge number of SERS "hot spots" that mainly contribute to the high SERS sensitivity. The great enhancement of SERS results from the electron transfer between ZnO and Ag and different electromagnetic enhancements of Ag nanoparticles(NPs) with different thicknesses. Through the finite-difference time-domain(FDTD) theoretical simulation, the enhancement of SERS signal can be ascribed to a strong electric field enhancement produced in the 3D framework. The simplicity and generality of our method offer great advantages for further understanding the SERS mechanism induced by the surface plasmon resonance(SPR) effect.
