The jet co-flow packing tray(JCPT) with three different types of perforation in equal opening fraction was tested in two rectangular columns with 0.12m in width and 0.27m in length operated with air-water system. The ...The jet co-flow packing tray(JCPT) with three different types of perforation in equal opening fraction was tested in two rectangular columns with 0.12m in width and 0.27m in length operated with air-water system. The influences of gas phase orifice F-factor and clear liquid height Hc on the amount of liquid lifted, Q, were examined. The corresponding correlation between Q with F-factor and equivalent diameter of perforated holes as well as Hc was obtained. Furthermore, the non-steady state mass transfer performance of JCPT was tested by the humidification of air with water. Finally, by the analysis of data and comparison, it was found that the JCPT tray with single cap and two holes exhibited the highest mass transfer efficiency and best performance.展开更多
A cross-flow wind turbine near a structure was tested for the performance. The results showed that the performance of a cross-flow wind turbine near a structure was up to 30% higher than the one without a structure. I...A cross-flow wind turbine near a structure was tested for the performance. The results showed that the performance of a cross-flow wind turbine near a structure was up to 30% higher than the one without a structure. In addition, we tried to get higher performance of a cross-flow wind turbine by using an Inlet Guide Structure and a Flow Deflector. An Inlet Guide Structure was placed on the edge of a structure and a Flow Deflector was set near a cross-flow wind turbine and can improve ambient wind environments of the wind turbine, the maximum power coefficients were about 15 to 40% higher and the tip speed ratio range showing the high power coefficient was wide and the positive gradients were steep apparently.展开更多
文摘The jet co-flow packing tray(JCPT) with three different types of perforation in equal opening fraction was tested in two rectangular columns with 0.12m in width and 0.27m in length operated with air-water system. The influences of gas phase orifice F-factor and clear liquid height Hc on the amount of liquid lifted, Q, were examined. The corresponding correlation between Q with F-factor and equivalent diameter of perforated holes as well as Hc was obtained. Furthermore, the non-steady state mass transfer performance of JCPT was tested by the humidification of air with water. Finally, by the analysis of data and comparison, it was found that the JCPT tray with single cap and two holes exhibited the highest mass transfer efficiency and best performance.
文摘A cross-flow wind turbine near a structure was tested for the performance. The results showed that the performance of a cross-flow wind turbine near a structure was up to 30% higher than the one without a structure. In addition, we tried to get higher performance of a cross-flow wind turbine by using an Inlet Guide Structure and a Flow Deflector. An Inlet Guide Structure was placed on the edge of a structure and a Flow Deflector was set near a cross-flow wind turbine and can improve ambient wind environments of the wind turbine, the maximum power coefficients were about 15 to 40% higher and the tip speed ratio range showing the high power coefficient was wide and the positive gradients were steep apparently.
