The performance of inclined pile group embedded in consolidating soil under surcharge load was investigated by experiment in comparison with vertical pile group and single pile under the same conditions; dragload, dow...The performance of inclined pile group embedded in consolidating soil under surcharge load was investigated by experiment in comparison with vertical pile group and single pile under the same conditions; dragload, downdrag, and layered soil settlement were measured. A three-dimensional numerical model was built via FLAC3D software, and verified by the experimental results. Influence factors, such as consolidation time, pile spacing, and pile tilt angle were analyzed. The results show that dragload of inclined pile group increases with the increase of consolidation time and pile spacing or the decrease of pile tilt angle. Downdrag of inclined pile group increases with the increase of consolidation time, pile spacing and pile tilt angle.展开更多
The CuO/γ-Al2O3/cordierite catalyst, after being sulfated by sulfur dioxide (SO2) at 673 K, exhibits high activities for selective catalytic reduction (SCR) of nitrogen oxide (NO) with ammonia (NH3) at 573-723 K. The...The CuO/γ-Al2O3/cordierite catalyst, after being sulfated by sulfur dioxide (SO2) at 673 K, exhibits high activities for selective catalytic reduction (SCR) of nitrogen oxide (NO) with ammonia (NH3) at 573-723 K. The intrinsic kinetics of SCR of NO with NH3 over CuO/γ-Al2O3/cordierite catalyst has been measured in a fixed-bed reactor in the absence of internal and external diffusions. The experimental results show that the reaction rate can be quantified by a first-order expression with activation energy Eá of 94.01 kJ·mol-1 and the corresponding p re-exponential factor A′ of 3.39×108 cm3·g-1·s-1 when NH3 is excessive. However, when NH3 is not enough, an E ley-Rideal kinetic model based on experimental data is derived with Ea of 105.79 kJ·mol-1, the corresponding A of 2 .94×109 cm3·g-1·s-1, heat of adsorption-Hads of 87.90 kJ·mol-1 and the corresponding Aads of 9.24 cm3·mol-1. The intrinsic kinetic model obtained was incorporated in a 3D mathematical model of monolithic reactor, and the agreement of the prediction with experimental data indicates that the present kinetic model is adequate for the reac-tor design and engineering scale-up.展开更多
Recently one-dimensional topological phases are gaining increasing attentions. Like two- and three-dimensional ones, Onedimensional systems are important in a complete understanding of the topological properties. One-...Recently one-dimensional topological phases are gaining increasing attentions. Like two- and three-dimensional ones, Onedimensional systems are important in a complete understanding of the topological properties. One-dimensional topological phases have been realized using current experimental setups. Specially the signatures of Majorana fermions have been observed in onedimensional topological superconductors engineered with Rashiba nanowires. From the many studies, the paper reviews typical theoretical models of one-dimensional topological insulators and superconductors. For one-dimensional topological insulators, we introduce the Su-Schrieffer-Heeger, superlattices and Creutz models, while for topological superconductors the Kitaev model and Rashiba nanowire are introduced. These models not only provide an overview of one-dimensional topological phases, but also are the starting points for further studies.展开更多
The stowing and deploying experiment was conducted for three 700 mm long thin-walled tubes,and the structural behavior characteristics parameters were measured clearly,including strain,deformation and wrapping moment....The stowing and deploying experiment was conducted for three 700 mm long thin-walled tubes,and the structural behavior characteristics parameters were measured clearly,including strain,deformation and wrapping moment.3D finite element models(FEM)were built subsequently and explicit dynamic method was used to simulate the stowing and deploying of the lenticular carbon fiber reinforced polymer(CFRP)thin-walled tubular space boom,which was designed as four-ply(45°/-45°/45°/-45°)lay-up.The stress and energy during the wrapping process were got and compared with different wrapping angular velocity,the reasonable wrapping angular velocity and effective method were conformed,and structural behavior characteristics were obtained.The results were compared and discussed as well,and the results show that the numerical results by 0.628 rad/s velocity agree well with the measured values.In this paper,the numerical procedure and experimental results are valuable to the optimization design of CFRP thin-walled tubular space boom and future research.展开更多
基金Supported by National Natural Science Foundation of China (No. 51008116)State Key Laboratory of Coastal and Offshore Engineering (No. LP1014)+1 种基金Fundamental Research Funds for the Central Universities (No. 2009B14514)China Postdoctoral Science Foundation (No. 20090461062)
文摘The performance of inclined pile group embedded in consolidating soil under surcharge load was investigated by experiment in comparison with vertical pile group and single pile under the same conditions; dragload, downdrag, and layered soil settlement were measured. A three-dimensional numerical model was built via FLAC3D software, and verified by the experimental results. Influence factors, such as consolidation time, pile spacing, and pile tilt angle were analyzed. The results show that dragload of inclined pile group increases with the increase of consolidation time and pile spacing or the decrease of pile tilt angle. Downdrag of inclined pile group increases with the increase of consolidation time, pile spacing and pile tilt angle.
基金Supported by the National Natural Science Foundation of China （20821004 20736001 21076008） the Research Fund for the Doctoral Program of Higher Education of China （2090010110002）
文摘The CuO/γ-Al2O3/cordierite catalyst, after being sulfated by sulfur dioxide (SO2) at 673 K, exhibits high activities for selective catalytic reduction (SCR) of nitrogen oxide (NO) with ammonia (NH3) at 573-723 K. The intrinsic kinetics of SCR of NO with NH3 over CuO/γ-Al2O3/cordierite catalyst has been measured in a fixed-bed reactor in the absence of internal and external diffusions. The experimental results show that the reaction rate can be quantified by a first-order expression with activation energy Eá of 94.01 kJ·mol-1 and the corresponding p re-exponential factor A′ of 3.39×108 cm3·g-1·s-1 when NH3 is excessive. However, when NH3 is not enough, an E ley-Rideal kinetic model based on experimental data is derived with Ea of 105.79 kJ·mol-1, the corresponding A of 2 .94×109 cm3·g-1·s-1, heat of adsorption-Hads of 87.90 kJ·mol-1 and the corresponding Aads of 9.24 cm3·mol-1. The intrinsic kinetic model obtained was incorporated in a 3D mathematical model of monolithic reactor, and the agreement of the prediction with experimental data indicates that the present kinetic model is adequate for the reac-tor design and engineering scale-up.
基金the National Natural Science Foundation of China(Grant Nos.11274032 and 11104189)
文摘Recently one-dimensional topological phases are gaining increasing attentions. Like two- and three-dimensional ones, Onedimensional systems are important in a complete understanding of the topological properties. One-dimensional topological phases have been realized using current experimental setups. Specially the signatures of Majorana fermions have been observed in onedimensional topological superconductors engineered with Rashiba nanowires. From the many studies, the paper reviews typical theoretical models of one-dimensional topological insulators and superconductors. For one-dimensional topological insulators, we introduce the Su-Schrieffer-Heeger, superlattices and Creutz models, while for topological superconductors the Kitaev model and Rashiba nanowire are introduced. These models not only provide an overview of one-dimensional topological phases, but also are the starting points for further studies.
基金the National Natural Science Foundation of China(No.50878128)the Shanghai Aerospace Foundation(No.HTJ10-15)
文摘The stowing and deploying experiment was conducted for three 700 mm long thin-walled tubes,and the structural behavior characteristics parameters were measured clearly,including strain,deformation and wrapping moment.3D finite element models(FEM)were built subsequently and explicit dynamic method was used to simulate the stowing and deploying of the lenticular carbon fiber reinforced polymer(CFRP)thin-walled tubular space boom,which was designed as four-ply(45°/-45°/45°/-45°)lay-up.The stress and energy during the wrapping process were got and compared with different wrapping angular velocity,the reasonable wrapping angular velocity and effective method were conformed,and structural behavior characteristics were obtained.The results were compared and discussed as well,and the results show that the numerical results by 0.628 rad/s velocity agree well with the measured values.In this paper,the numerical procedure and experimental results are valuable to the optimization design of CFRP thin-walled tubular space boom and future research.
