在感应式无线电能传输系统的实际应用中,通常需要系统输出电压保持恒定。采用一种基于串并/串(SP/S)谐振补偿的感应式无线电能传输系统拓扑结构,当系统发射端和接收端的相对位置确定并采用定频控制时,该结构在全负载范围内具备接收端输...在感应式无线电能传输系统的实际应用中,通常需要系统输出电压保持恒定。采用一种基于串并/串(SP/S)谐振补偿的感应式无线电能传输系统拓扑结构,当系统发射端和接收端的相对位置确定并采用定频控制时,该结构在全负载范围内具备接收端输出恒压特性。同时分析了随着横向偏移的变化,系统输出恒压增益的变化特性。最后,设计了一个6.6 k W、20 k Hz定频控制的感应式无线电能传输实验系统,验证了所采用的SP/S谐振补偿拓扑结构的可行性和有效性。展开更多
A new configuration for delay cells used in voltage controlled oscillators is presented. A jitter comparison between the source-coupled differential delay cell and the proposed CMOS inverter based delay cell is given....A new configuration for delay cells used in voltage controlled oscillators is presented. A jitter comparison between the source-coupled differential delay cell and the proposed CMOS inverter based delay cell is given. A new method to optimize loop parameters based on low-jitter in PLL is also introduced. A low-jitter 1.25GHz Serdes is implemented in a 0.35μm standard 2P3M CMOS process. The result shows that the RJ （random jitter） RMS of 1.25GHz data rate series output is 2. 3ps （0. 0015UI） and RJ （1 sigma） is 0. 0035UI. A phase noise measurement shows - 120dBc/Hz@100kHz at 1111100000 clock-pattern data out.展开更多
In order to study the work-ability and establish the optimum hot formation processing parameters for industrial 1060 pure aluminum, the compressive deformation behavior of pure aluminum was investigated at temperature...In order to study the work-ability and establish the optimum hot formation processing parameters for industrial 1060 pure aluminum, the compressive deformation behavior of pure aluminum was investigated at temperatures of 523?823 K and strain rates of 0.005?10 s?1 on a Gleeble?1500 thermo-simulation machine. The influence rule of processing parameters (strain, strain rate and temperature) on flow stress of pure aluminum was investigated. Nine analysis factors consisting of material parameters and according weights were optimized. Then, the constitutive equations of multilevel series rules, multilevel parallel rules and multilevel series ¶llel rules were established. The correlation coefficients (R) are 0.992, 0.988 and 0.990, respectively, and the average absolute relative errors (AAREs) are 6.77%, 8.70% and 7.63%, respectively, which proves that the constitutive equations of multilevel series rules can predict the flow stress of pure aluminum with good correlation and precision.展开更多
文摘在感应式无线电能传输系统的实际应用中,通常需要系统输出电压保持恒定。采用一种基于串并/串(SP/S)谐振补偿的感应式无线电能传输系统拓扑结构,当系统发射端和接收端的相对位置确定并采用定频控制时,该结构在全负载范围内具备接收端输出恒压特性。同时分析了随着横向偏移的变化,系统输出恒压增益的变化特性。最后,设计了一个6.6 k W、20 k Hz定频控制的感应式无线电能传输实验系统,验证了所采用的SP/S谐振补偿拓扑结构的可行性和有效性。
文摘A new configuration for delay cells used in voltage controlled oscillators is presented. A jitter comparison between the source-coupled differential delay cell and the proposed CMOS inverter based delay cell is given. A new method to optimize loop parameters based on low-jitter in PLL is also introduced. A low-jitter 1.25GHz Serdes is implemented in a 0.35μm standard 2P3M CMOS process. The result shows that the RJ （random jitter） RMS of 1.25GHz data rate series output is 2. 3ps （0. 0015UI） and RJ （1 sigma） is 0. 0035UI. A phase noise measurement shows - 120dBc/Hz@100kHz at 1111100000 clock-pattern data out.
基金Project(51275414)supported by the National Natural Science Foundation of ChinaProject(2015JM5204)supported by the Natural Science Foundation of Shaanxi Province,China+1 种基金Project(Z2015064)supported by the Graduate Starting Seed Fund of the Northwestern Polytechnical University,ChinaProject(130-QP-2015)supported by the Research Fund of the State Key Laboratory of Solidification Processing(NWPU),China
文摘In order to study the work-ability and establish the optimum hot formation processing parameters for industrial 1060 pure aluminum, the compressive deformation behavior of pure aluminum was investigated at temperatures of 523?823 K and strain rates of 0.005?10 s?1 on a Gleeble?1500 thermo-simulation machine. The influence rule of processing parameters (strain, strain rate and temperature) on flow stress of pure aluminum was investigated. Nine analysis factors consisting of material parameters and according weights were optimized. Then, the constitutive equations of multilevel series rules, multilevel parallel rules and multilevel series ¶llel rules were established. The correlation coefficients (R) are 0.992, 0.988 and 0.990, respectively, and the average absolute relative errors (AAREs) are 6.77%, 8.70% and 7.63%, respectively, which proves that the constitutive equations of multilevel series rules can predict the flow stress of pure aluminum with good correlation and precision.
