疏水性二氧化铅电极的镀制及强化寿命研究

研究了钛和陶瓷基体上电镀疏水性 Pb O2 电极的工艺 ,测试了电镀工艺中电解液组分 HF、聚四氟乙烯乳液、Cu( NO3 ) 2 、Fe( NO3 ) 3 、Mn( NO3 ) 2 、HNO3 ,以及温度、电流密度、电流波形对电镀所得的 Pb O2 电极寿命的影响。研究发现 ,陶瓷基体 Pb O2 电极具有较好的性能 ,在 9mol/L H2 SO4溶液中 ,1 0 0 A/dm2 的电流密度下连续电解 ,寿命可达 1 30 0 h以上。

Electrosynthesis and physicochemical properties ofα-PbO_2-CeO_2-TiO_2 composite electrodes

In order to investigate the effect of solid particles dopants on physicochemical properties of α-PbO2 electrodes, a-PbO2 composite electrodes doped with nano-TiO2 and nano-CeO2 particles were respectively prepared on A1/conductive coating electrodes in 4 mol/L NaOH solution with addition of PbO until saturation by anodic codeposition. The electrodeposition mechanism, morphology, composition and structure of the composite electrodes were characterized by cyclic voltarnmogram （CV）, SEM, EDAX and XRD. Results show that the doping solid particles can not change reaction mechanism of α-PbO2 electrode in alkaline or acid plating bath, but can improve deposition rate and reduce oxygen evolution potential. The doping solid particles can inhibit the growth of a-PbO2 unit cell and improve specific surface area. The diffraction peak intensity of a-PbO2-CeO2-TiO2 composite electrode is lower than that of pure a-PbO2 electrode. The electrocatalytic activity of a-PbO2-2.12%CEO2-3.71%TIO2 composite electrode is the best. The Guglielmi model for CeO2 and TiO2 codeposition with a-PbO2 is also pronosed.

SnO_2-based gas(hydrogen) anodes for aluminum electrolysis

A novel SnO2-based gas anode was developed for aluminum electrolysis in molten cryolite at 850 ＆#176;C to reduce energy consumption and decrease CO2 emissions. Hydrogen was introduced into the anode, participating in the anode reaction. Carbon and aluminum were used as the cathode and reference electrodes, respectively. Cyclic voltammetry was applied in the cell to investigate the electrochemical behavior of oxygen ion on platinum and SnO2-based materials. The potential for oxygen evolution on these electrode materials was determined. Then, galvanostatic electrolysis was performed on the gas anode, showing a significant depolarization effect （a decrease of ~0.8 V of the anode potential） after the introduction of hydrogen, compared with no gas introduction or the introduction of argon. The results indicate the involvement of hydrogen in the anode reaction （three-phase-boundary reaction including gas, electrolyte and electrode） and give the possibility for the utilization of reducing gas anodes for aluminum electrolysis.

Decorating non-noble metal plasmonic Al on a TiO2/Cu2O photoanode to boost performance in photoelectrochemical water splitting

Designing low-cost and high-performance photoelectrodes with improved light harvesting and charge separation rates is significant in photoelectrochemical water splitting.Here,a novel TiO2/Cu2O/Al/Al2O3 photoelectrode is manufactured by depositing plasmonic nanoparticles of the non-noble metal Al on the surface of a TiO2/Cu2O core/shell heterojunction for the first time.The Al nanoparticles,which exhibit a surface plasmon resonance(SPR)effect and are substantially less expensive than noble metals such as Au and Ag,generate hot electron-hole pairs and amplify the electromagnetic field at the interface under illumination.The as-prepared TiO2/Cu2O/Al/Al2O3 photoelectrodes have an extended absorption range and enhanced carrier separation and transfer.Their photocurrent density of 4.52 mA·cm^-2 at 1.23 V vs.RHE represents an 1.84-fold improvement over that of TiO2/Cu2O.Specifically,the ultrathin Al2O3 passivation layer spontaneously generated on the surface of Al in air could act as a protective layer to significantly increase its stability.In this work,the synergistic effect of the heterojunctions and the SPR effect of the non-noble metal Al significantly improve the photoelectrode performance,providing a novel concept for the design of electrodes with good properties and high practicability.