The flotation separation of smithsonite from calcite and quartz using a alkyl diamine ether(GE-609)as the collector was investigated through micro-flotation experiments and the real ore flotation experiments.The resul...The flotation separation of smithsonite from calcite and quartz using a alkyl diamine ether(GE-609)as the collector was investigated through micro-flotation experiments and the real ore flotation experiments.The results show that GE-609exhibits good collecting capability to three minerals without selectivity.The presence of sodium sulfide enhances the flotation of smithsonite and calcite while inhibits quartz.Moreover,both sodium silicate and sodium hexametaphosphate exhibit good selective inhibition to calcite.The real ore test results show that a zinc concentrate containing23.51%Zn with the recovery of71.02%is obtained in the closed-circuit test.To understand the adsorption of GE-609on smithsonite surface,zeta potential measurement and FTIR analysis were carried out,and the results indicate that the collector GE-609can adsorb on smithsonite surface through both electrostatic adsorption and chemical adsorption,and the presence of sodium sulfide enhances the adsorption of GE-609.展开更多
A novel technique of flue gas desulphufization （FGD） using industrial sodium sulfide as absorbent is described to remove SO2 in flue gas. The FGD byproduct in this novel technique is sodium thiosuffate （Na2S2O3 ...A novel technique of flue gas desulphufization （FGD） using industrial sodium sulfide as absorbent is described to remove SO2 in flue gas. The FGD byproduct in this novel technique is sodium thiosuffate （Na2S2O3 · 5H2O, Hypo） which can be used as chemical raw material. Optimal operating parameters about this technique have been determined. In order to enhance productive efficiency of sodium thiosulfate, EDTA disodium additive is added into absorption solution to prevent oxidation of sodium thiosulfate. Its optimal concentration is 0. 02 wt. %. The pH value of absorption solution is set in the range of 5 ~ 6.5. Experimental results show that SO2removal efficiency averagely reach 98.72 %. The highest productive efficiency of sodium thiosulfate reaches 83.24 %. The sodium thiosulfate formed during FGD can be separated from saturated absorbent by filtration, concentration and crystallization. The filtrate after separating sodium thiosulfate will be reused as SO2 absorbent by replenishing some fresh sodium sulfide.展开更多
The extraction of cadmium and zinc with di-(2-ethylhexyl)-dithiophosphoric acid(D2EHDTPA)-toluene and D2EHDTPA-trioctyl amine(TOA)-toluene has been investigated. Infrared spectrum analysis, the nuclear magnetic resona...The extraction of cadmium and zinc with di-(2-ethylhexyl)-dithiophosphoric acid(D2EHDTPA)-toluene and D2EHDTPA-trioctyl amine(TOA)-toluene has been investigated. Infrared spectrum analysis, the nuclear magnetic resonance spectrum(NMR) analysis and conductivity measurements confirm that the probable structures of the extracted complexes are CdA2 and ZnA2. Cadmium can be extracted by D2EHDTPA very easily. Almost all the cadmium can be extracted, but stripping of cadmium from the organic phase is very difficult. When a mixture of D2EHDTPA and TOA is used, selective extraction of cadmium from zinc sulfate solution can be achieved. Cadmium can be easily stripped from the organic phase.展开更多
基金Project(2016RS2016) supported by Innovation Team of Interface Chemistry of Efficient and Clean Utilization of Complex Mineral Resources,China
文摘The flotation separation of smithsonite from calcite and quartz using a alkyl diamine ether(GE-609)as the collector was investigated through micro-flotation experiments and the real ore flotation experiments.The results show that GE-609exhibits good collecting capability to three minerals without selectivity.The presence of sodium sulfide enhances the flotation of smithsonite and calcite while inhibits quartz.Moreover,both sodium silicate and sodium hexametaphosphate exhibit good selective inhibition to calcite.The real ore test results show that a zinc concentrate containing23.51%Zn with the recovery of71.02%is obtained in the closed-circuit test.To understand the adsorption of GE-609on smithsonite surface,zeta potential measurement and FTIR analysis were carried out,and the results indicate that the collector GE-609can adsorb on smithsonite surface through both electrostatic adsorption and chemical adsorption,and the presence of sodium sulfide enhances the adsorption of GE-609.
基金This research project was sponsored by National Natural Science Foundation (20877026)
文摘A novel technique of flue gas desulphufization （FGD） using industrial sodium sulfide as absorbent is described to remove SO2 in flue gas. The FGD byproduct in this novel technique is sodium thiosuffate （Na2S2O3 · 5H2O, Hypo） which can be used as chemical raw material. Optimal operating parameters about this technique have been determined. In order to enhance productive efficiency of sodium thiosulfate, EDTA disodium additive is added into absorption solution to prevent oxidation of sodium thiosulfate. Its optimal concentration is 0. 02 wt. %. The pH value of absorption solution is set in the range of 5 ~ 6.5. Experimental results show that SO2removal efficiency averagely reach 98.72 %. The highest productive efficiency of sodium thiosulfate reaches 83.24 %. The sodium thiosulfate formed during FGD can be separated from saturated absorbent by filtration, concentration and crystallization. The filtrate after separating sodium thiosulfate will be reused as SO2 absorbent by replenishing some fresh sodium sulfide.
基金Supported by the National Natural Science Foundation of China(No.59474009).
文摘The extraction of cadmium and zinc with di-(2-ethylhexyl)-dithiophosphoric acid(D2EHDTPA)-toluene and D2EHDTPA-trioctyl amine(TOA)-toluene has been investigated. Infrared spectrum analysis, the nuclear magnetic resonance spectrum(NMR) analysis and conductivity measurements confirm that the probable structures of the extracted complexes are CdA2 and ZnA2. Cadmium can be extracted by D2EHDTPA very easily. Almost all the cadmium can be extracted, but stripping of cadmium from the organic phase is very difficult. When a mixture of D2EHDTPA and TOA is used, selective extraction of cadmium from zinc sulfate solution can be achieved. Cadmium can be easily stripped from the organic phase.
