Porous electrodes with three-phase reaction in low temperature fuel cells have attracted much attention by their flooding phenomena. In order to have a better understanding of the flooding phenomena inside electrode, ...Porous electrodes with three-phase reaction in low temperature fuel cells have attracted much attention by their flooding phenomena. In order to have a better understanding of the flooding phenomena inside electrode, it is important to evaluate various discharge conditions of the flooded electrodes. A model of flooded porous electrode under the influence of potential sweep was developed to evaluate the flooding conditions in-situ. The hysteresis of current density vs. time was observed at high sweep rates （1 O0 mV.sl）. It was not observed at low sweep rate （0.1 mV-s~）. In this study, these characteristics of flooding and hysteresis conditions were found to be markedly dependent on the potential scan rate. These dynamic behaviors are interpreted in terms of water saturation response, velocity of water movement, and evaporation rate of water.展开更多
A selective subband enhancement method based on biorthogonal wavelet base is proposed. This novel image enhancement method is just for those images in which the energy of target information area is relatively lower. I...A selective subband enhancement method based on biorthogonal wavelet base is proposed. This novel image enhancement method is just for those images in which the energy of target information area is relatively lower. It includes two parts: one is enhancing the low frequency subband by wavelet decomposition and the other is building a new criterion based on entropy window to image evaluation. Experimental results show that this new scheme may result in a perfect image processing.展开更多
In this paper a lumped parameter model of a two-pass gas-to-gas crossflow heat exchanger with high speed air flow has been presented for the investigation of its transieat behaviours. The effects of both the changes o...In this paper a lumped parameter model of a two-pass gas-to-gas crossflow heat exchanger with high speed air flow has been presented for the investigation of its transieat behaviours. The effects of both the changes of inlet temperature and flow rate on outlet temperature can be predicted with this model.The calculation results under typical conditions are compared with experimental results and good agreements are obtained.展开更多
文摘Porous electrodes with three-phase reaction in low temperature fuel cells have attracted much attention by their flooding phenomena. In order to have a better understanding of the flooding phenomena inside electrode, it is important to evaluate various discharge conditions of the flooded electrodes. A model of flooded porous electrode under the influence of potential sweep was developed to evaluate the flooding conditions in-situ. The hysteresis of current density vs. time was observed at high sweep rates （1 O0 mV.sl）. It was not observed at low sweep rate （0.1 mV-s~）. In this study, these characteristics of flooding and hysteresis conditions were found to be markedly dependent on the potential scan rate. These dynamic behaviors are interpreted in terms of water saturation response, velocity of water movement, and evaporation rate of water.
基金Project (2003AA1Z2610) supported by National High Technology Research and Development Programof China
文摘A selective subband enhancement method based on biorthogonal wavelet base is proposed. This novel image enhancement method is just for those images in which the energy of target information area is relatively lower. It includes two parts: one is enhancing the low frequency subband by wavelet decomposition and the other is building a new criterion based on entropy window to image evaluation. Experimental results show that this new scheme may result in a perfect image processing.
文摘In this paper a lumped parameter model of a two-pass gas-to-gas crossflow heat exchanger with high speed air flow has been presented for the investigation of its transieat behaviours. The effects of both the changes of inlet temperature and flow rate on outlet temperature can be predicted with this model.The calculation results under typical conditions are compared with experimental results and good agreements are obtained.
