As an important role in the development of ITS, traffic assignment forecast is always the research focus. Based on the analysis of classic traffic assignment forecast models, an improved traffic assignment forecast mo...As an important role in the development of ITS, traffic assignment forecast is always the research focus. Based on the analysis of classic traffic assignment forecast models, an improved traffic assignment forecast model, multi-ways probability and capacity constraint (MPCC) is presented. Using the new traffic as- signment forecast model to forecast the traffic volume will improve the rationality and veracity of traffic as- signment forecast.展开更多
It has been demonstrated that either Channel Allocation （CA） or Relay Selection （RS） can improve the performance in relaying networks separately. However, there is little work concerning their combination in multi...It has been demonstrated that either Channel Allocation （CA） or Relay Selection （RS） can improve the performance in relaying networks separately. However, there is little work concerning their combination in multi-cell uplink scenarios. In this paper, we investigate the issue which considers the CA and RS to optimize the system transmission rate in an uplink scenario, while maintaining the resource distribution fairness among users. This is first formulated as an optimization problem for a linear cellular system, where the same frequency channels can be reused in different cells. Based on the link and co-channel interference conditions, two low-complexity CA and RS schemes are then proposed with different decomposition se quences. Finally, numerical results are con ducted to verify the effectiveness of the pro posed CA and RS methods. Simulations re suits show that the proposed methods can yield significant improvements in system per formance in terms of average sum rate.展开更多
A distribution grid is generally characterized by a high R/X （resistance/reactance） ratio and it is radial in nature. By design, a distribution grid system is not an active network, and it is normally designed in su...A distribution grid is generally characterized by a high R/X （resistance/reactance） ratio and it is radial in nature. By design, a distribution grid system is not an active network, and it is normally designed in such a way that power flows from transmission system via distribution system to consumers. But in a situation when wind turbines are connected to the distribution grid, the power source will change from one source to two sources, in this case, network is said to be active. This may probably have an impact on the distribution grid to whenever the wind turbine is connected. The best way to know the impact of wind turbine on the distribution grid in question is by carrying out load flow analysis on that system with and without the connection of wind turbines. Two major fundamental calculations： the steady-state voltage variation at the PCC （point of common coupling） and the calculation of short-circuit power of the grid system at the POC （point of connection） are necessary before carrying out the load flow study on the distribution grid. This paper, therefore, considers these pre-load flow calculations that are necessary before carrying out load flow study on the test distribution grid. These calculations are carded out on a test distribution system.展开更多
文摘As an important role in the development of ITS, traffic assignment forecast is always the research focus. Based on the analysis of classic traffic assignment forecast models, an improved traffic assignment forecast model, multi-ways probability and capacity constraint (MPCC) is presented. Using the new traffic as- signment forecast model to forecast the traffic volume will improve the rationality and veracity of traffic as- signment forecast.
基金supported by the Key Project of State Key Laboratory of Rail Traffic and Control under Grant No.RCS2012ZZ004the Fundamental Research Funds for the Central Universities under Grant No. 2013YJS025
文摘It has been demonstrated that either Channel Allocation （CA） or Relay Selection （RS） can improve the performance in relaying networks separately. However, there is little work concerning their combination in multi-cell uplink scenarios. In this paper, we investigate the issue which considers the CA and RS to optimize the system transmission rate in an uplink scenario, while maintaining the resource distribution fairness among users. This is first formulated as an optimization problem for a linear cellular system, where the same frequency channels can be reused in different cells. Based on the link and co-channel interference conditions, two low-complexity CA and RS schemes are then proposed with different decomposition se quences. Finally, numerical results are con ducted to verify the effectiveness of the pro posed CA and RS methods. Simulations re suits show that the proposed methods can yield significant improvements in system per formance in terms of average sum rate.
文摘A distribution grid is generally characterized by a high R/X （resistance/reactance） ratio and it is radial in nature. By design, a distribution grid system is not an active network, and it is normally designed in such a way that power flows from transmission system via distribution system to consumers. But in a situation when wind turbines are connected to the distribution grid, the power source will change from one source to two sources, in this case, network is said to be active. This may probably have an impact on the distribution grid to whenever the wind turbine is connected. The best way to know the impact of wind turbine on the distribution grid in question is by carrying out load flow analysis on that system with and without the connection of wind turbines. Two major fundamental calculations： the steady-state voltage variation at the PCC （point of common coupling） and the calculation of short-circuit power of the grid system at the POC （point of connection） are necessary before carrying out the load flow study on the distribution grid. This paper, therefore, considers these pre-load flow calculations that are necessary before carrying out load flow study on the test distribution grid. These calculations are carded out on a test distribution system.
