期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
测量机滚珠丝杠Z轴伺服系统的动力学建模及补偿 被引量:11
1
作者 向红标 裘祖荣 +2 位作者 李醒飞 谭文斌 张晨阳 《天津大学学报》 EI CAS CSCD 北大核心 2011年第4期291-296,共6页
在对θFXZ型测量机Z轴伺服系统的机械结构和控制系统进行分析的基础上,建立了伺服系统的动力学模型.根据受力分析,对系统的干扰力进行建模.利用对PID参数的自适应调节和干扰力的前馈补偿,实现对系统的误差补偿.实验结果表明,补偿后的跟... 在对θFXZ型测量机Z轴伺服系统的机械结构和控制系统进行分析的基础上,建立了伺服系统的动力学模型.根据受力分析,对系统的干扰力进行建模.利用对PID参数的自适应调节和干扰力的前馈补偿,实现对系统的误差补偿.实验结果表明,补偿后的跟踪误差约为补偿前的1/4,系统静差也由原来的2μm减小到0.4μm以内.该伺服系统的动力学建模和干扰力建模能直观、有效地描述Z轴系统的运动特性,补偿方案能很好地改善系统的动态跟踪误差和控制定位精度. 展开更多
关键词 伺服系统模型 干扰力模型 跟踪误差 静差
下载PDF
电液复合调节作动器的建模与AMESim仿真 被引量:15
2
作者 郎燕 李运华 《航空学报》 EI CAS CSCD 北大核心 2007年第B08期152-157,共6页
针对传统功率电传一体化作动器存在的诸如动态响应差、固有频率低等问题,提出一种增加了一个总压力控制阀的改进型电液复合调节一体化作动器。通过保持作动筒高、低压腔的压力之和为一常数,使泵控系统的固有频率和阀控系统相同,有效地... 针对传统功率电传一体化作动器存在的诸如动态响应差、固有频率低等问题,提出一种增加了一个总压力控制阀的改进型电液复合调节一体化作动器。通过保持作动筒高、低压腔的压力之和为一常数,使泵控系统的固有频率和阀控系统相同,有效地改善了动态响应。在综合考虑这种改进的电液一体化作动器中不可忽视的结构刚度、摩擦、泄漏等非线性因素对系统的影响后,在已有简化模型基础上建立了非线性仿真模型。用AMESim软件进行仿真验证和分析,结果表明该模型较好地反映了实际系统的性能,为功率电传一体化舵机的进一步结构优化和控制提供了理论依据。 展开更多
关键词 作动器 功率电传 电液伺服系统模型 AMESIM 仿真
下载PDF
PARAMETER IDENTIFICATION OF LUGRE FRICTION MODEL FOR FLIGHT SIMULATION SERVO SYSTEM BASED ON ANT COLONY ALGORITHM 被引量:4
3
作者 段海滨 王道波 +1 位作者 朱家强 黄向华 《Transactions of Nanjing University of Aeronautics and Astronautics》 EI 2004年第3期179-183,共5页
In light of the high nonlinearity of LuGre friction model, a novel method based on ant colony algorithm(ACA) for identifying the friction parameters of flight simulation servo system is proposed. ACA is a parallelized... In light of the high nonlinearity of LuGre friction model, a novel method based on ant colony algorithm(ACA) for identifying the friction parameters of flight simulation servo system is proposed. ACA is a parallelized bionic optimization algorithm inspired from the behavior of real ants, and a kind of positive feedback mechanism is adopted in ACA. On the basis of brief introduction of LuGre friction model, a method for identifying the static LuGre friction parameters and the dynamic LuGre friction parameters using ACA is derived. Finally, this new friction parameter identification scheme is applied to a electric-driven flight simulation servo system with high precision. Simulation and application results verify the feasibility and the effectiveness of the scheme. It provides a new way to identify the friction parameters of LuGre model. 展开更多
关键词 parameter identification LuGre friction mo-del flight simulation servo system
下载PDF
Effective model based fault detection scheme for rudder servo system
4
作者 徐巧宁 周华 +2 位作者 喻峰 魏兴乔 杨华勇 《Journal of Central South University》 SCIE EI CAS 2014年第11期4172-4183,共12页
The inherent nonlinearities of the rudder servo system(RSS) and the unknown external disturbances bring great challenges to the practical application of fault detection technology. Modeling of whole rudder system is a... The inherent nonlinearities of the rudder servo system(RSS) and the unknown external disturbances bring great challenges to the practical application of fault detection technology. Modeling of whole rudder system is a challenging and difficult task. Quite often, models are too inaccurate, especially in transient stages. In model based fault detection, these inaccuracies might cause wrong actions. An effective approach, which combines nonlinear unknown input observer(NUIO) with an adaptive threshold, is proposed. NUIO can estimate the states of RSS asymptotically without any knowledge of external disturbance. An adaptive threshold is used for decision making which helps to reduce the influence of model uncertainty. Actuator and sensor faults that occur in RSS are considered both by simulation and experimental tests. The observer performance, robustness and fault detection capability are verified. Simulation and experimental results show that the proposed fault detection scheme is efficient and can be used for on-line fault detection. 展开更多
关键词 rudder servo system fault detection nonlinear unknown input observer adaptive threshold
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部