A nonlinear dynamics model and a mathematical expression were set up to investigatethe mechanism and conditions of vibration creep acceleration.The model showsthat hydraulic spring and nonlinear friction are major fac...A nonlinear dynamics model and a mathematical expression were set up to investigatethe mechanism and conditions of vibration creep acceleration.The model showsthat hydraulic spring and nonlinear friction are major factors that can affect low-speed instability.The mathematic model was established to obtain the change rule of speed andinstantaneous acceleration of the hydraulic motor.Then, Matlab was used to simulate theeffect of nonlinear friction force and hydraulic motor parameters such as coefficient of leakand compression ratio, etc., under low speed.Finally, some measures were proposed toimprove the low-speed stability of the hydraulic motor.展开更多
In order to study the effect of time lag and stress loading rates on rock deformation,the conventional stepped stress loading mode was changed into a continuous mode to investigate the effect of effective pressure on ...In order to study the effect of time lag and stress loading rates on rock deformation,the conventional stepped stress loading mode was changed into a continuous mode to investigate the effect of effective pressure on permeability and porosity.The time lag effect of rock deformation illustrating the relationship between changes in permeability and steady time was studied.Permeability reduction ratios were measured under different stress loading rates which were achieved by different pump rate settings.The results show that permeability and porosity gradually decrease with increases in effective pressure.Permeability at high effective pressure attains stability quickly.Steady times at low effective pressure are very long.Reduction in permeability at lower stress loading rates is small,while,in contrast,it is large at high stress loading rates.展开更多
A comparison of the effectiveness of installing reactive power compensators,such as shunt capacitors,static var compensators(SVCs),and static synchronous compensators(STATCOMs),was presented in large-scale power netwo...A comparison of the effectiveness of installing reactive power compensators,such as shunt capacitors,static var compensators(SVCs),and static synchronous compensators(STATCOMs),was presented in large-scale power networks.A suitable bus was first identified using modal analysis method.The single shunt capacitor,single SVC,and single STATCOM were installed separately on the most critical bus.The effects of the installation of different devices on power loss reduction,voltage profile improvement,and voltage stability margin enhancement were examined and compared for 57-and 118-bus transmission systems.The comparative study results show that SVC,and STATCOM are expensive compared to shunt capacitor,yet the effect of installing STATCOM is better than SVC and the effect of installing SVC is better than that of shunt capacitor in achieving power loss reduction,voltage profile improvement and voltage stability margin enhancement.展开更多
A high stabilized low dropout(LDO) voltage regulator fabricated for GPS radio frequency(RF) chip in SMIC 0.18μm CMOS technology is presented.The LDO mainly consists of bandgap reference,error amplifier,resistive feed...A high stabilized low dropout(LDO) voltage regulator fabricated for GPS radio frequency(RF) chip in SMIC 0.18μm CMOS technology is presented.The LDO mainly consists of bandgap reference,error amplifier,resistive feedback network and AC current path.A fast current path is added to improve the performance of LDO's transient response.Equivalent series resistance(ESR)compensation and internal Miller compensation are used to constitute the frequency compensation.The measurement results of the transient response of the output voltage show that it can recover within 2μs with less than 120 mV ripple when the load current is changed from 0 to 100 mA.The total quiescent current of LDO and bandgap reference(without load) is 260 μA.展开更多
LES (Large-Eddy Simulation) computations were preformed to investigate the mechanisms of a kind of spanwisegroove for the passive control of laminar separation bubble on the suction surface of a low-speed highly loade...LES (Large-Eddy Simulation) computations were preformed to investigate the mechanisms of a kind of spanwisegroove for the passive control of laminar separation bubble on the suction surface of a low-speed highly loadedlow-pressure turbine blade at Re = 50,000 (Reynolds number, based on inlet velocity and axial chord length).Compared with the smooth suction surface, the numerical results indicate that: (1) the groove is effective toshorten and thin the separation bubble, which contributes the flow loss reduction on the groove surface, by thinningthe boundary layer behind the groove and promoting earlier transition inception in the separation bubble; (2)upstream movement of the transition inception location on the grooved surface is suggested being the result of thelower frequency at which the highest amplification rate of instability waves occurs, and the larger initial amplitudeof the disturbance at the most unstable frequency before transition; and (3) the viscous instability mode ispromoted on the grooved surface, due to the thinning of the boundary layer behind the groove.展开更多
In this paper, performance of PECVD SiO 2 /Si 3 N 4 double layers electrets with different thicknesses were investigated detailedly in respect of chargeability, storage charge stability in high temperature and reliabi...In this paper, performance of PECVD SiO 2 /Si 3 N 4 double layers electrets with different thicknesses were investigated detailedly in respect of chargeability, storage charge stability in high temperature and reliability in high humidity environment. Samples with different thicknesses of Si 3 N 4 and SiO 2 were prepared on Pyrex 7740 glass substrates and characterized by isothermal and high humidity charge decay. The results of experiment approved that the PECVD SiO 2 /Si 3 N 4 double layers electrets on glass substrate has as good chargeability and charge stability in high temperature and high humidity environment as thermal oxidation or APCVD/LPCVD ones on silicon substrates. The experiment results indicated that a Si 3 N 4 layer no less than 50 nm is necessary for good charge stability in high temperature and a Si 3 N 4 layer thicker than 500 nm decreases the chargeability. Even a 2 nm Si 3 N 4 layer is enough to significantly improve the charge stability in high humidity environment. Thick SiO 2 layer can increase the surface potential of electrets under the same charging condition and its charge stability in high temperature. However, the electrets with high surface potential also exhibit poor uniformity of charge stability in high humidity environment.展开更多
基金Supported by the Natural Science Foundation of Fujian Province of China(2009J01259)Scientific Research Foundation of Department of Education(JB08182)
文摘A nonlinear dynamics model and a mathematical expression were set up to investigatethe mechanism and conditions of vibration creep acceleration.The model showsthat hydraulic spring and nonlinear friction are major factors that can affect low-speed instability.The mathematic model was established to obtain the change rule of speed andinstantaneous acceleration of the hydraulic motor.Then, Matlab was used to simulate theeffect of nonlinear friction force and hydraulic motor parameters such as coefficient of leakand compression ratio, etc., under low speed.Finally, some measures were proposed toimprove the low-speed stability of the hydraulic motor.
基金Projects 2008ZX05009-004 supported by the National Key Sci-Tech Major Special Item2006CB705805 by the National Basic Research Program of Chinasupported by the National Basic Research Program of China and "enhanced oil recovery basic theory for low permeability reservoirs" under grant 2002CCA00700
文摘In order to study the effect of time lag and stress loading rates on rock deformation,the conventional stepped stress loading mode was changed into a continuous mode to investigate the effect of effective pressure on permeability and porosity.The time lag effect of rock deformation illustrating the relationship between changes in permeability and steady time was studied.Permeability reduction ratios were measured under different stress loading rates which were achieved by different pump rate settings.The results show that permeability and porosity gradually decrease with increases in effective pressure.Permeability at high effective pressure attains stability quickly.Steady times at low effective pressure are very long.Reduction in permeability at lower stress loading rates is small,while,in contrast,it is large at high stress loading rates.
文摘A comparison of the effectiveness of installing reactive power compensators,such as shunt capacitors,static var compensators(SVCs),and static synchronous compensators(STATCOMs),was presented in large-scale power networks.A suitable bus was first identified using modal analysis method.The single shunt capacitor,single SVC,and single STATCOM were installed separately on the most critical bus.The effects of the installation of different devices on power loss reduction,voltage profile improvement,and voltage stability margin enhancement were examined and compared for 57-and 118-bus transmission systems.The comparative study results show that SVC,and STATCOM are expensive compared to shunt capacitor,yet the effect of installing STATCOM is better than SVC and the effect of installing SVC is better than that of shunt capacitor in achieving power loss reduction,voltage profile improvement and voltage stability margin enhancement.
基金Supported by the Communication Systems Project of Jiangsu Department(No.JHB04010)
文摘A high stabilized low dropout(LDO) voltage regulator fabricated for GPS radio frequency(RF) chip in SMIC 0.18μm CMOS technology is presented.The LDO mainly consists of bandgap reference,error amplifier,resistive feedback network and AC current path.A fast current path is added to improve the performance of LDO's transient response.Equivalent series resistance(ESR)compensation and internal Miller compensation are used to constitute the frequency compensation.The measurement results of the transient response of the output voltage show that it can recover within 2μs with less than 120 mV ripple when the load current is changed from 0 to 100 mA.The total quiescent current of LDO and bandgap reference(without load) is 260 μA.
文摘LES (Large-Eddy Simulation) computations were preformed to investigate the mechanisms of a kind of spanwisegroove for the passive control of laminar separation bubble on the suction surface of a low-speed highly loadedlow-pressure turbine blade at Re = 50,000 (Reynolds number, based on inlet velocity and axial chord length).Compared with the smooth suction surface, the numerical results indicate that: (1) the groove is effective toshorten and thin the separation bubble, which contributes the flow loss reduction on the groove surface, by thinningthe boundary layer behind the groove and promoting earlier transition inception in the separation bubble; (2)upstream movement of the transition inception location on the grooved surface is suggested being the result of thelower frequency at which the highest amplification rate of instability waves occurs, and the larger initial amplitudeof the disturbance at the most unstable frequency before transition; and (3) the viscous instability mode ispromoted on the grooved surface, due to the thinning of the boundary layer behind the groove.
基金supported by the National Basic Research Program of China ("973" Program) (Grant No. 2009CB320300)
文摘In this paper, performance of PECVD SiO 2 /Si 3 N 4 double layers electrets with different thicknesses were investigated detailedly in respect of chargeability, storage charge stability in high temperature and reliability in high humidity environment. Samples with different thicknesses of Si 3 N 4 and SiO 2 were prepared on Pyrex 7740 glass substrates and characterized by isothermal and high humidity charge decay. The results of experiment approved that the PECVD SiO 2 /Si 3 N 4 double layers electrets on glass substrate has as good chargeability and charge stability in high temperature and high humidity environment as thermal oxidation or APCVD/LPCVD ones on silicon substrates. The experiment results indicated that a Si 3 N 4 layer no less than 50 nm is necessary for good charge stability in high temperature and a Si 3 N 4 layer thicker than 500 nm decreases the chargeability. Even a 2 nm Si 3 N 4 layer is enough to significantly improve the charge stability in high humidity environment. Thick SiO 2 layer can increase the surface potential of electrets under the same charging condition and its charge stability in high temperature. However, the electrets with high surface potential also exhibit poor uniformity of charge stability in high humidity environment.
