Mg-2.7Nd-0.2Zn-0.4Zr （mass fraction, %） alloy was designed for degradable biomedical material. The ingots of the alloy were solution treated and then hot extruded. The extruded rods were heat treated with aging trea...Mg-2.7Nd-0.2Zn-0.4Zr （mass fraction, %） alloy was designed for degradable biomedical material. The ingots of the alloy were solution treated and then hot extruded. The extruded rods were heat treated with aging treatment, solution treatment and solution＋aging treatment, respectively. Microstructures of the alloy were observed by optical microscopy （OM） and scanning electron microscopy （SEM）. Mechanical properties at room temperature were tested. In vitro degradation behavior of the alloy immersed in simulated body fluid was measured by hydrogen evolution and mass loss tests. The degradation morphologies of the alloy with and without degradation products were observed by SEM. The results show that the grains grow apparently after solution treatment. Solution treatment improves the elongation of as-extruded alloy significantly and decreases the strength, while aging treatment improves the strength and reduces the elongation of the alloy. The yield ratio is reduced by heat treatment. The in vitro degradation results of the alloy show that solution treatment on the as-extruded alloy results in a little higher degradation rate and aging treatment on the alloy can reduce degradation rate slightly.展开更多
The microstructures,mechanical properties and in vitro degradation behavior of as-extruded pure Zn and Zn-x Sr(x=0.1,0.4,0.8 wt.%)alloys were investigated systematically.For the microstructure and mechanical propertie...The microstructures,mechanical properties and in vitro degradation behavior of as-extruded pure Zn and Zn-x Sr(x=0.1,0.4,0.8 wt.%)alloys were investigated systematically.For the microstructure and mechanical properties,Sr Zn13 phase was newly formed due to the addition of 0.1 wt.%Sr,improving the yield strength,ultimate tensile strength and elongation from(85.33±2.86)MPa,(106.00±1.41)MPa and(15.37±0.57)%for pure Zn to(107.67±2.05)MPa,(115.67±2.52)MPa and(20.80±2.19)%for Zn-0.1Sr,respectively.However,further increase of Sr content led to the deterioration of the mechanical properties due to the stress concentration and cracks initiation caused by the coarsening Sr Zn13 particles during tensile tests.For in vitro degradation,since micro galvanic corrosion was enhanced owing to the formation of the inhomogeneously distributed Sr Zn13 phase,the corrosion mode became non-uniform.Corrosion rate is gradually increased with the addition of Sr,which is increased from(11.45±2.02)μm/a(a=year)for pure Zn to(32.59±3.40)μm/a for Zn-0.8Sr.To sum up,the as-extruded Zn-0.1Sr alloy exhibited the best combination of mechanical properties and degradation behavior.展开更多
Ti-based scaffolds reinforced with zirconia and hydroxyapatite were produced successfully by a hybrid method with an eco-friendliness and low cost to obtain low elastic modulus(E) with sufficient physical, electrochem...Ti-based scaffolds reinforced with zirconia and hydroxyapatite were produced successfully by a hybrid method with an eco-friendliness and low cost to obtain low elastic modulus(E) with sufficient physical, electrochemical and biological properties. The effect of simultaneous modification of the volume fraction of hydroxyapatite(HA) and zirconia(ZrO_(2)) on scaffolds was investigated in terms of mechanical, corrosive, and antibacterial properties. Scanning electron microscopy with attached electron dispersive spectroscopy and X-ray diffraction were used for the characterization of scaffolds. Compression and electrochemical tests were performed to determine mechanical properties with detailed fracture mechanism and in-vitro corrosion susceptibility to simulated body fluid at 37 ℃,respectively. Antibacterial tests were carried out by comparing the inhibition areas of E.coli and S.aureus bacteria. It was observed that the mechanical strength of the scaffolds decreased with increasing HA:ZrO_(2)volume fraction ratio.The lowest E was achieved(6.61 GPa) in 6:4 HA:ZrO_(2)composite scaffolds. Corrosion current density(J_(corr)) values were calculated to be 21, 337, and 504 μ A/cm^(2) for unreinforced Ti, 3:2 and 6:4 HA:ZrO_(2)reinforced scaffolds,respectively. The inhibition capacity of the 6:4 reinforced composite scaffold was found to be more effective against S.aureus bacteria than other scaffolds.展开更多
To make clear the precise hemodynamic mechanism underlying the anti-atherogenesis benefit of enhanced external couterpulsation(EECP) treatment, and to investigate the proper role of some important hemodynamic factors ...To make clear the precise hemodynamic mechanism underlying the anti-atherogenesis benefit of enhanced external couterpulsation(EECP) treatment, and to investigate the proper role of some important hemodynamic factors during the atherosclerotic progress, a comprehensive study combining long-term animal experiment and numerical solving was conducted in this paper. An experimentally induced hypercholesterolemic porcine model was developed and the chronic EECP intervention was subjected. Basic hemodynamic measurement was performed in vivo, as well as the arterial endothelial samples were extracted for physiological examination. Meanwhile, a numerical model was introduced to solve the complex hemodynamic factors such as WSS and OSI. The results show that EECP treatment resulted in significant increase of the instant levels of arterial WSS, blood pressure, and OSI. During EECP treatment, the instant OSI level of the common carotid arteries over cardiac cycles raised to a mean value of 8.58 ×10-2±2.13 ×10-2. Meanwhile, the chronic intervention of EECP treatment significantly reduced the atherosclerotic lesions in abdominal aortas and the endothelial cellular adherence. The present study suggests that the unique blood flow pattern induced by EECP treatment and the augmentation of WSS level in cardiac cycles may be the most important hemodynamic mechanism that contribute to its anti-atherogenesis effect. And as one of the indices that cause great concern in current hemodynamic study, OSI may not play a key role during the initiation of atherosclerosis.展开更多
基金supported by the Introducing Talents Funds of Nanjing Institute of Technology,ChinaProject(20100470030) supported by the China Postdoctoral Science Foundation
文摘Mg-2.7Nd-0.2Zn-0.4Zr （mass fraction, %） alloy was designed for degradable biomedical material. The ingots of the alloy were solution treated and then hot extruded. The extruded rods were heat treated with aging treatment, solution treatment and solution＋aging treatment, respectively. Microstructures of the alloy were observed by optical microscopy （OM） and scanning electron microscopy （SEM）. Mechanical properties at room temperature were tested. In vitro degradation behavior of the alloy immersed in simulated body fluid was measured by hydrogen evolution and mass loss tests. The degradation morphologies of the alloy with and without degradation products were observed by SEM. The results show that the grains grow apparently after solution treatment. Solution treatment improves the elongation of as-extruded alloy significantly and decreases the strength, while aging treatment improves the strength and reduces the elongation of the alloy. The yield ratio is reduced by heat treatment. The in vitro degradation results of the alloy show that solution treatment on the as-extruded alloy results in a little higher degradation rate and aging treatment on the alloy can reduce degradation rate slightly.
基金Project(17XD1402100)supported by the Science and Technology Commission of Shanghai Municipality,ChinaProject(SZSM201612092)supported by Shenzhen Three Renowned Project,China+1 种基金Project(2018RC001A-18)supported by the Innovation Talent Program of Karamay City,ChinaProject(2018D01A07)supported by the Natural Science Foundation of Xinjiang Uygur Autonomous Region,China。
文摘The microstructures,mechanical properties and in vitro degradation behavior of as-extruded pure Zn and Zn-x Sr(x=0.1,0.4,0.8 wt.%)alloys were investigated systematically.For the microstructure and mechanical properties,Sr Zn13 phase was newly formed due to the addition of 0.1 wt.%Sr,improving the yield strength,ultimate tensile strength and elongation from(85.33±2.86)MPa,(106.00±1.41)MPa and(15.37±0.57)%for pure Zn to(107.67±2.05)MPa,(115.67±2.52)MPa and(20.80±2.19)%for Zn-0.1Sr,respectively.However,further increase of Sr content led to the deterioration of the mechanical properties due to the stress concentration and cracks initiation caused by the coarsening Sr Zn13 particles during tensile tests.For in vitro degradation,since micro galvanic corrosion was enhanced owing to the formation of the inhomogeneously distributed Sr Zn13 phase,the corrosion mode became non-uniform.Corrosion rate is gradually increased with the addition of Sr,which is increased from(11.45±2.02)μm/a(a=year)for pure Zn to(32.59±3.40)μm/a for Zn-0.8Sr.To sum up,the as-extruded Zn-0.1Sr alloy exhibited the best combination of mechanical properties and degradation behavior.
基金the financial supports from the Research Fund of Atatürk University, Turkey (No. FDK-2019-7281)。
文摘Ti-based scaffolds reinforced with zirconia and hydroxyapatite were produced successfully by a hybrid method with an eco-friendliness and low cost to obtain low elastic modulus(E) with sufficient physical, electrochemical and biological properties. The effect of simultaneous modification of the volume fraction of hydroxyapatite(HA) and zirconia(ZrO_(2)) on scaffolds was investigated in terms of mechanical, corrosive, and antibacterial properties. Scanning electron microscopy with attached electron dispersive spectroscopy and X-ray diffraction were used for the characterization of scaffolds. Compression and electrochemical tests were performed to determine mechanical properties with detailed fracture mechanism and in-vitro corrosion susceptibility to simulated body fluid at 37 ℃,respectively. Antibacterial tests were carried out by comparing the inhibition areas of E.coli and S.aureus bacteria. It was observed that the mechanical strength of the scaffolds decreased with increasing HA:ZrO_(2)volume fraction ratio.The lowest E was achieved(6.61 GPa) in 6:4 HA:ZrO_(2)composite scaffolds. Corrosion current density(J_(corr)) values were calculated to be 21, 337, and 504 μ A/cm^(2) for unreinforced Ti, 3:2 and 6:4 HA:ZrO_(2)reinforced scaffolds,respectively. The inhibition capacity of the 6:4 reinforced composite scaffold was found to be more effective against S.aureus bacteria than other scaffolds.
基金Key Clinical Project from the Ministry of Healthgrant number:25400+1 种基金National Natural Science Foundation of Chinagrant number:81170272
文摘To make clear the precise hemodynamic mechanism underlying the anti-atherogenesis benefit of enhanced external couterpulsation(EECP) treatment, and to investigate the proper role of some important hemodynamic factors during the atherosclerotic progress, a comprehensive study combining long-term animal experiment and numerical solving was conducted in this paper. An experimentally induced hypercholesterolemic porcine model was developed and the chronic EECP intervention was subjected. Basic hemodynamic measurement was performed in vivo, as well as the arterial endothelial samples were extracted for physiological examination. Meanwhile, a numerical model was introduced to solve the complex hemodynamic factors such as WSS and OSI. The results show that EECP treatment resulted in significant increase of the instant levels of arterial WSS, blood pressure, and OSI. During EECP treatment, the instant OSI level of the common carotid arteries over cardiac cycles raised to a mean value of 8.58 ×10-2±2.13 ×10-2. Meanwhile, the chronic intervention of EECP treatment significantly reduced the atherosclerotic lesions in abdominal aortas and the endothelial cellular adherence. The present study suggests that the unique blood flow pattern induced by EECP treatment and the augmentation of WSS level in cardiac cycles may be the most important hemodynamic mechanism that contribute to its anti-atherogenesis effect. And as one of the indices that cause great concern in current hemodynamic study, OSI may not play a key role during the initiation of atherosclerosis.
