When an extremely thick rock bed exists above a protected coal seam in the bending zone given the condition of a mining protective seam, this extremely thick rock bed controls the movement of the entire overlying stra...When an extremely thick rock bed exists above a protected coal seam in the bending zone given the condition of a mining protective seam, this extremely thick rock bed controls the movement of the entire overlying stratum. This extremely thick rock bed, called a ＂main key stratum＂, will not subside nor break for a long time, causing lower fractures and bed separations not to close and gas can migrate to the bed separation areas along the fractures. These bed separations become gas enrichment areas. By analyzing the rule of fracture evolution and gas migration under the main key stratum after the deep protective coal seam has been mined, we propose a new gas drainage method which uses bore holes, drilled through rock and coal seams at great depths for draining pressure relief gas. In this method, the bores are located at a high level suction roadway （we can also drill them in the drilling field located high in an air gateway）. Given the practice in the Haizi mine, the gas drainage rate can reach 73% in the middie coal group, with a gas drainage radius over 100 m.展开更多
When, in a coal mine distribution network whose neutral point is grounded by an arc suppression coil (ASC), a fault occurs in the ASC, compensation cannot be properly realized. Furthermore, it can damage the safe and ...When, in a coal mine distribution network whose neutral point is grounded by an arc suppression coil (ASC), a fault occurs in the ASC, compensation cannot be properly realized. Furthermore, it can damage the safe and reliable run of the network. We first introduce a three-phase five-column arc suppression coil (TPFCASC) and discuss its autotracking compensation theory. Then we compare the single phase to ground fault of the coal mine distribution network with an open phase fault at the TPFCASC using the Thévenin theory, the symmetrical-component method and the complex sequence network respectively. The results show that, in both types of faults, zero-sequence voltage of the network will appear and the maximum magnitude of this zero-sequence voltage is different in both faults. Based on this situation, a protection for the open phase fault at the TPFCASC should be estab-lished.展开更多
The developing processes of stress and deformation fields of a protected layer after mining an upper-protective layer with a bow pseudo-incline technique were simulated to locate the protection region. The pressure re...The developing processes of stress and deformation fields of a protected layer after mining an upper-protective layer with a bow pseudo-incline technique were simulated to locate the protection region. The pressure relief of the protected layer was analyzed after mining the upper-protective layer. The pressure relief angle along the strike and incline were located according to the roles of protection of the deformation and stress pressure-relief of the protective layer after mining. This results show that the upper-protective layer with the bow pseudo-incline technique have an upper and downside pressure relief angle of 85 and 68 degrees respectively; the distribution of strike pressure relief angles along the pseudo-incline working face is uneven and their values range from 38.3 to 51 degrees. The pressure relief angle of the inclined middle location was the largest. The distribution of the protection region of the upper-protective layer with the bow pseudo-incline teelmique located by practical tests and numerical simulation is essentially consistent, compared with the results obtained by these methods.展开更多
Hard coal mining in the German Ruhr district has a tradition of more than 200 years. Starting in the south near the river Ruhr with mining of seams near to the surface, mining wandered to the north with coal seams dee...Hard coal mining in the German Ruhr district has a tradition of more than 200 years. Starting in the south near the river Ruhr with mining of seams near to the surface, mining wandered to the north with coal seams deeper and deeper. In the same way all environmental effects of mining wandered from south to north, as there are abandoned mining sites, contaminated areas, burning mining dumps, subsided areas and gas accesses at day ground. This all happened in a very high populated area with more than four million inhabitants. Therefore Germany has a long tradition in solving environmental problems of mining activities. The very good interaction of mine authority, mining companies and the mine workers’ union is the main reason why the problems of decreasing mining activities in Germany were solved without economic, environmental or social hazards.展开更多
During mining of lower protective coal seam, a surface borehole can efficiently extract not only the pressure-relieved gas from the protected layer, but also the gas from the mining layer gob. If the distance between ...During mining of lower protective coal seam, a surface borehole can efficiently extract not only the pressure-relieved gas from the protected layer, but also the gas from the mining layer gob. If the distance between the borehole and gob is too large, the quantity of gas drained from the protected layer decreases substantially. To solve this problem, a mathematical model for extracting pressure-relieved gas from a protected coal seam using a surface borehole was established, based on the radial gas flow theory and law of conservation of energy. The key factors influencing the quantity of gas and the drainage flow network using a surface borehole were presented. The results show that the quantity of pressure-relieved gas drained from the protected layer can be significantly increased by increasing the flow resistance of the borehole bottom. Application of this method in the Wulan Coal Mine of the Shenhua Group significantly increased the flow of pure gas and the gas concentration （by factors of 1.8 and 2.0, respectively）, thus demonstrating the remarkable effects of this method.展开更多
基金Projects 2005CB221503 supported by the National Basic Research Program of China70533050 and 50674089 by the National Natural Science Foundation of China2005BA813B-3-06 by the National Tenth 5-Year Key Scientific and Technological Project
文摘When an extremely thick rock bed exists above a protected coal seam in the bending zone given the condition of a mining protective seam, this extremely thick rock bed controls the movement of the entire overlying stratum. This extremely thick rock bed, called a ＂main key stratum＂, will not subside nor break for a long time, causing lower fractures and bed separations not to close and gas can migrate to the bed separation areas along the fractures. These bed separations become gas enrichment areas. By analyzing the rule of fracture evolution and gas migration under the main key stratum after the deep protective coal seam has been mined, we propose a new gas drainage method which uses bore holes, drilled through rock and coal seams at great depths for draining pressure relief gas. In this method, the bores are located at a high level suction roadway （we can also drill them in the drilling field located high in an air gateway）. Given the practice in the Haizi mine, the gas drainage rate can reach 73% in the middie coal group, with a gas drainage radius over 100 m.
文摘When, in a coal mine distribution network whose neutral point is grounded by an arc suppression coil (ASC), a fault occurs in the ASC, compensation cannot be properly realized. Furthermore, it can damage the safe and reliable run of the network. We first introduce a three-phase five-column arc suppression coil (TPFCASC) and discuss its autotracking compensation theory. Then we compare the single phase to ground fault of the coal mine distribution network with an open phase fault at the TPFCASC using the Thévenin theory, the symmetrical-component method and the complex sequence network respectively. The results show that, in both types of faults, zero-sequence voltage of the network will appear and the maximum magnitude of this zero-sequence voltage is different in both faults. Based on this situation, a protection for the open phase fault at the TPFCASC should be estab-lished.
基金Projects PLN0610 supported by the Open Fund of State Key Lab of Oil and Gas Reservoir Geology and Exploitation (Southwest Petroleum University)HKLGF200706 by the Opening Project of Henan Key Laboratory of Coal Mine Methane and Fire Prevention+3 种基金50334060, 50474025 and 50774106 by the National Natural Science Foundation of China2005CB221502 by the National Basic Research Program of China50621403 by the Natural Science Innova-tion Group Foundation of ChinaCSTC, 2006BB7147, 2006AA7002 by the Natural Science Foundation of Chongqing
文摘The developing processes of stress and deformation fields of a protected layer after mining an upper-protective layer with a bow pseudo-incline technique were simulated to locate the protection region. The pressure relief of the protected layer was analyzed after mining the upper-protective layer. The pressure relief angle along the strike and incline were located according to the roles of protection of the deformation and stress pressure-relief of the protective layer after mining. This results show that the upper-protective layer with the bow pseudo-incline technique have an upper and downside pressure relief angle of 85 and 68 degrees respectively; the distribution of strike pressure relief angles along the pseudo-incline working face is uneven and their values range from 38.3 to 51 degrees. The pressure relief angle of the inclined middle location was the largest. The distribution of the protection region of the upper-protective layer with the bow pseudo-incline teelmique located by practical tests and numerical simulation is essentially consistent, compared with the results obtained by these methods.
文摘Hard coal mining in the German Ruhr district has a tradition of more than 200 years. Starting in the south near the river Ruhr with mining of seams near to the surface, mining wandered to the north with coal seams deeper and deeper. In the same way all environmental effects of mining wandered from south to north, as there are abandoned mining sites, contaminated areas, burning mining dumps, subsided areas and gas accesses at day ground. This all happened in a very high populated area with more than four million inhabitants. Therefore Germany has a long tradition in solving environmental problems of mining activities. The very good interaction of mine authority, mining companies and the mine workers’ union is the main reason why the problems of decreasing mining activities in Germany were solved without economic, environmental or social hazards.
文摘During mining of lower protective coal seam, a surface borehole can efficiently extract not only the pressure-relieved gas from the protected layer, but also the gas from the mining layer gob. If the distance between the borehole and gob is too large, the quantity of gas drained from the protected layer decreases substantially. To solve this problem, a mathematical model for extracting pressure-relieved gas from a protected coal seam using a surface borehole was established, based on the radial gas flow theory and law of conservation of energy. The key factors influencing the quantity of gas and the drainage flow network using a surface borehole were presented. The results show that the quantity of pressure-relieved gas drained from the protected layer can be significantly increased by increasing the flow resistance of the borehole bottom. Application of this method in the Wulan Coal Mine of the Shenhua Group significantly increased the flow of pure gas and the gas concentration （by factors of 1.8 and 2.0, respectively）, thus demonstrating the remarkable effects of this method.
