This paper, with NOAA/AHHRR data for 2 years, discusses the expanding path and extent of suspended sediment from the Changjiang River, and the relationship between the suspended sediment expanding and coastal current ...This paper, with NOAA/AHHRR data for 2 years, discusses the expanding path and extent of suspended sediment from the Changjiang River, and the relationship between the suspended sediment expanding and coastal current systems by analyzing the thermal infrared imagery with the sediment imagery, which is acquired by correlating the atmosphere corrected AVHRR imagery with in-situ suspended sediment data. The coastal current systems affecting the sediment dispersal mainly include： the Taiwan Warm Current （TWC）, the Huanghai Sea Mixed Water （HSMW）, North Jiangsu near-shore current, and Zhejiang near-shore current etc. In winter, the current systems are stable. Their distribution affects the sediment from north Jiangsu expanding toward the Changjiang estuary in some degree .The front between Zhejiang coastal current and TWC blocks the expanding of sediment toward the sea. In the flood season, apart from the limitation by coastal current systems, the spatial and temporal distribution of suspended sediment is also affected by the runoff, which shows as the jet stream and fresh water. Spring and autumn are the transitional periods of the forming of expanding patterns of flood season and winter respectively. In addition, the re-suspended sediment caused by the wind wave may make the expanding range of near-shore sediment larger.展开更多
With concentrated juice of mulberry as raw material, the influence of type and dosage of dry aid, the inlet air tempera- ture, inlet flow rate, and rotating speed on spray drying was studied. The spray drying processi...With concentrated juice of mulberry as raw material, the influence of type and dosage of dry aid, the inlet air tempera- ture, inlet flow rate, and rotating speed on spray drying was studied. The spray drying processing conditions of mulberry pow- der were optimized by the L9 （3^4） orthogonal test on the basis of single factor experiment. The results showed that optimum technical parameters to produce mulberry powder were： lS-cyclodextrin as dry aids with dosage of 30%, inlet air temperature of 180 ℃, rotating speed of 18 000 r/min and inlet flow rate of 30 mL/min. The mulberry powder under this optimum process conditions had a loose structure and bright color, fruity flavor was rich, the anthocyanin content for 54.67 mg/g, moisture content for 5.6% and sensory scores for 83.展开更多
The flow maldistribution and the effect of different inlet configuration on the flow distribution in platefin heat exchangers were studied experimentally. It is found that the flow maldistribution is serious because o...The flow maldistribution and the effect of different inlet configuration on the flow distribution in platefin heat exchangers were studied experimentally. It is found that the flow maldistribution is serious because of the defects of inlet configurations, while the inlet configuration and Reynolds number are the main factors affecting the flow distribution. The improved inlet configurations, which are the header with a two-stage distributing configuration and the guide vane with a fluid complementary cavity were proposed and tested in this paper. The experimental results show that the improved inlet configurations can effectively improve the performance of flow distribution in heat exchangers.展开更多
An improved 3-D ECOM-si model was used to study the impact of seasonal tide variation on saltwater intrusion into the Changjiang River estuary, especially at the bifurcation of the North Branch （NB） and the South Br...An improved 3-D ECOM-si model was used to study the impact of seasonal tide variation on saltwater intrusion into the Changjiang River estuary, especially at the bifurcation of the North Branch （NB） and the South Branch （SB）. The study assumes that the fiver discharge and wind are constant. The model successfully reproduced the saltwater intrusion. During spring tide, there is water and salt spillover （WSO and SSO） from the NB into the SB, and tidally averaged （net） water and salt fluxes are 985 m3/s and 24.8 ton/s, respectively. During neap tide, the WSO disappears and its net water flux is 122 m3/s. Meanwhile, the SSO continues, with net salt flux of 1.01 ton/s, much smaller than during spring tide. Because the tidal range during spring tide is smaller in June than in March, overall saltwater intrusion is weaker in June than in March during that tidal period. However, the WSO and SSO still exist in June. Net water and salt fluxes in that month are 622 m3/s and 15.35 ton/s, respectively, decreasing by 363 m3/s and 9.45 ton/s over those in March. Because tidal range during neap tide is greater in June than in March, saltwater intrusion in June is stronger than in March during that tidal period. The WSO and SSO appear in June, with net water and salt fluxes of 280 m3/s and 8.55 ton/s, respectively, increasing by 402 m3/s and 7.54 ton/s over those in March. Saltwater intrusion in the estuary is controlled by the fiver discharge, semi-diurnal flood-ebb tide, semi-monthly spring or neap tide, and seasonal tide variation.展开更多
Based on the engineering application, the angle range of rectifying airflow unit attaching diffusion tank is from 2.5° to 7.5°. In the range of average inlet velocity of 25.0 m/s to 55.0 m/s of diffusion tan...Based on the engineering application, the angle range of rectifying airflow unit attaching diffusion tank is from 2.5° to 7.5°. In the range of average inlet velocity of 25.0 m/s to 55.0 m/s of diffusion tank, numerical simulations of diffusion tank were done. The results of numerical simulations of diffusion tank are shown as follows： ③ In cases of the inlet velocity range from 25.0 m/s to 55.0 m/s, and the angle range of rectifying airflow unit from 2.5° to 7.5°, the average value of pressure losses decreases to the minimum when the angle is 4.5°.② In cases of the inlet velocity of 35.0 m/s, the pressure loss of diffusion tank decreases to the minimum when the angle of rectifying airflow unit is 5.5°. ③ As far as there are different angles of rectifying airflow unit, pressure loss increases gradually along with the addition of inlet velocity.展开更多
Flow characteristics in the entrance of plate-fin heat exchanger have been investigated by means of particle image velocimetry (PIV). The flow field was measured using the two-frame cross-correlation technique. Stream...Flow characteristics in the entrance of plate-fin heat exchanger have been investigated by means of particle image velocimetry (PIV). The flow field was measured using the two-frame cross-correlation technique. Streamline and velocity contour graphs at different cross-sections were obtained in the experiment. The experimental results indicate that flow maldistribution in the conventional header is very serious, while the improved header configuration with punched baffle can effectively improve the uniformity. The flow maldistribution parameter in plate-fin heat exchanger has been reduced from 1.21 to 0.21, and the ratio of the maximum velocity to the minimum is reduced from 23.2 to 1.8 by install-ing the punched baffle. The results suggest room for the optimum design of plate-fin heat exchanger.展开更多
文摘This paper, with NOAA/AHHRR data for 2 years, discusses the expanding path and extent of suspended sediment from the Changjiang River, and the relationship between the suspended sediment expanding and coastal current systems by analyzing the thermal infrared imagery with the sediment imagery, which is acquired by correlating the atmosphere corrected AVHRR imagery with in-situ suspended sediment data. The coastal current systems affecting the sediment dispersal mainly include： the Taiwan Warm Current （TWC）, the Huanghai Sea Mixed Water （HSMW）, North Jiangsu near-shore current, and Zhejiang near-shore current etc. In winter, the current systems are stable. Their distribution affects the sediment from north Jiangsu expanding toward the Changjiang estuary in some degree .The front between Zhejiang coastal current and TWC blocks the expanding of sediment toward the sea. In the flood season, apart from the limitation by coastal current systems, the spatial and temporal distribution of suspended sediment is also affected by the runoff, which shows as the jet stream and fresh water. Spring and autumn are the transitional periods of the forming of expanding patterns of flood season and winter respectively. In addition, the re-suspended sediment caused by the wind wave may make the expanding range of near-shore sediment larger.
文摘With concentrated juice of mulberry as raw material, the influence of type and dosage of dry aid, the inlet air tempera- ture, inlet flow rate, and rotating speed on spray drying was studied. The spray drying processing conditions of mulberry pow- der were optimized by the L9 （3^4） orthogonal test on the basis of single factor experiment. The results showed that optimum technical parameters to produce mulberry powder were： lS-cyclodextrin as dry aids with dosage of 30%, inlet air temperature of 180 ℃, rotating speed of 18 000 r/min and inlet flow rate of 30 mL/min. The mulberry powder under this optimum process conditions had a loose structure and bright color, fruity flavor was rich, the anthocyanin content for 54.67 mg/g, moisture content for 5.6% and sensory scores for 83.
基金Supported by the Doctoral Foundation of Xi'an Jiaotong University (No. DFXJTU2002-12) the Foundation for Excellent Doctoral Dissertation Author by Minister of Education, China (No. 199933).
文摘The flow maldistribution and the effect of different inlet configuration on the flow distribution in platefin heat exchangers were studied experimentally. It is found that the flow maldistribution is serious because of the defects of inlet configurations, while the inlet configuration and Reynolds number are the main factors affecting the flow distribution. The improved inlet configurations, which are the header with a two-stage distributing configuration and the guide vane with a fluid complementary cavity were proposed and tested in this paper. The experimental results show that the improved inlet configurations can effectively improve the performance of flow distribution in heat exchangers.
基金Supported by the National Basic Science Research Program of Global Change Research(No.2010CB951201)the Funds for Creative Research Groups of China(No.41021064)the Marine Special Program for Scientific Research on Public Causes(No.201005019)
文摘An improved 3-D ECOM-si model was used to study the impact of seasonal tide variation on saltwater intrusion into the Changjiang River estuary, especially at the bifurcation of the North Branch （NB） and the South Branch （SB）. The study assumes that the fiver discharge and wind are constant. The model successfully reproduced the saltwater intrusion. During spring tide, there is water and salt spillover （WSO and SSO） from the NB into the SB, and tidally averaged （net） water and salt fluxes are 985 m3/s and 24.8 ton/s, respectively. During neap tide, the WSO disappears and its net water flux is 122 m3/s. Meanwhile, the SSO continues, with net salt flux of 1.01 ton/s, much smaller than during spring tide. Because the tidal range during spring tide is smaller in June than in March, overall saltwater intrusion is weaker in June than in March during that tidal period. However, the WSO and SSO still exist in June. Net water and salt fluxes in that month are 622 m3/s and 15.35 ton/s, respectively, decreasing by 363 m3/s and 9.45 ton/s over those in March. Because tidal range during neap tide is greater in June than in March, saltwater intrusion in June is stronger than in March during that tidal period. The WSO and SSO appear in June, with net water and salt fluxes of 280 m3/s and 8.55 ton/s, respectively, increasing by 402 m3/s and 7.54 ton/s over those in March. Saltwater intrusion in the estuary is controlled by the fiver discharge, semi-diurnal flood-ebb tide, semi-monthly spring or neap tide, and seasonal tide variation.
基金Supported by the National Natural Science Foundation of China （51074073） the Project of Hunan Provincial Science ＆ Technology Department （2010XK6066） the Project of Scientific Research Fund of Hunan Provincial Education Department （10C0675）
文摘Based on the engineering application, the angle range of rectifying airflow unit attaching diffusion tank is from 2.5° to 7.5°. In the range of average inlet velocity of 25.0 m/s to 55.0 m/s of diffusion tank, numerical simulations of diffusion tank were done. The results of numerical simulations of diffusion tank are shown as follows： ③ In cases of the inlet velocity range from 25.0 m/s to 55.0 m/s, and the angle range of rectifying airflow unit from 2.5° to 7.5°, the average value of pressure losses decreases to the minimum when the angle is 4.5°.② In cases of the inlet velocity of 35.0 m/s, the pressure loss of diffusion tank decreases to the minimum when the angle of rectifying airflow unit is 5.5°. ③ As far as there are different angles of rectifying airflow unit, pressure loss increases gradually along with the addition of inlet velocity.
基金Supported by the Foundation for Excellent Doctoral Dissertation Author by Ministry of Education of China (No.199933).
文摘Flow characteristics in the entrance of plate-fin heat exchanger have been investigated by means of particle image velocimetry (PIV). The flow field was measured using the two-frame cross-correlation technique. Streamline and velocity contour graphs at different cross-sections were obtained in the experiment. The experimental results indicate that flow maldistribution in the conventional header is very serious, while the improved header configuration with punched baffle can effectively improve the uniformity. The flow maldistribution parameter in plate-fin heat exchanger has been reduced from 1.21 to 0.21, and the ratio of the maximum velocity to the minimum is reduced from 23.2 to 1.8 by install-ing the punched baffle. The results suggest room for the optimum design of plate-fin heat exchanger.
