选取福建漳州地区经粮面压盖的高大平房仓为实验仓房,通过使用功率较小的储藏物冷却机与负压通风相结合的方式对仓房进行降温,中途应用改变粮面压盖的手段实现降温均匀和彻底。实验累计运行112.7 h,降温3.3℃,水分变化为0.1%,运行期间...选取福建漳州地区经粮面压盖的高大平房仓为实验仓房,通过使用功率较小的储藏物冷却机与负压通风相结合的方式对仓房进行降温,中途应用改变粮面压盖的手段实现降温均匀和彻底。实验累计运行112.7 h,降温3.3℃,水分变化为0.1%,运行期间的降温单位能耗为0.47 k W·h/(℃·t),符合《谷物冷却机低温储粮技术规程》的规定,并且达到了保水降温的效果。展开更多
Gametophytes of Laminaria japonica were cryopreserved in liquid nitrogen using encapsulation-dehydration with two-step cooling method. Gametophytes cultured at 10℃ and under continuous irradiance of 30 μmol m^-2 s^-...Gametophytes of Laminaria japonica were cryopreserved in liquid nitrogen using encapsulation-dehydration with two-step cooling method. Gametophytes cultured at 10℃ and under continuous irradiance of 30 μmol m^-2 s^-1 for 3 weeks were encapsulated in calcium alginate beads. The beads were dehydrated in 0.4 molLl sucrose prepared with seawater for 6 h, desiccated in an incubator set at 10℃ and 70% relative humidity for 4 h, pre-frozen at either -40℃ or -60℃ for 30 min, and stored in liquid nitrogen for 〉24 h. As high as 43% of survival rate was observed when gametophytes were thawed by placing the beads in 40℃ seawater and re-hydrated in 0.05 molL^-1 citrate sodium prepared using 30‰ NaCl 7 d later. More cells of male gametophytes survived the whole procedure in comparison with female gametophytes. The cells of gametophytes surviving the preservation were able to grow asexually and produce morphologically normal sporophytes.展开更多
A single stage Stifling pulse tube cryocooler was designed based on REGEN 3.2 and fabricated for testing. The experimental results show that the cooler can provide a cooling capacity of 5.0 W at 79.1 K, and produce a ...A single stage Stifling pulse tube cryocooler was designed based on REGEN 3.2 and fabricated for testing. The experimental results show that the cooler can provide a cooling capacity of 5.0 W at 79.1 K, and produce a no-load temperature of 57.0 K, operating with an average pressure of 2.50 MPa and a frequency of 60 Hz, performance results that are very close to the calculated values. The cryocooler can be cooled from room temperature to 80 K in 8.5 min. The fast cooldown time is a result of the small regenerator.展开更多
Mg?1Zn?0.5Ca alloys were prepared by traditional steel mould casting and water-cooled copper mould injection casting at higher cooling rate. Microstructure, mechanical properties and bio-corrosion resistance of two al...Mg?1Zn?0.5Ca alloys were prepared by traditional steel mould casting and water-cooled copper mould injection casting at higher cooling rate. Microstructure, mechanical properties and bio-corrosion resistance of two alloys were contrastively investigated. Grain size reduces remarkably and microstructure becomes homogenous when raising cooling rate. The bio-corrosion behaviour in 3.5% sodium chloride solution (3.5% NaCl) and Hank’s solution at 37°C was investigated using electrochemical polarization measurement and the results indicate that the alloy prepared at higher cooling rates has better corrosion resistance in both types of solution. Further mass loss immersion test in Hank’s solution reveals the same result. The reason of corrosion resistance improvement is that raising cooling rate brings about homogeneous microstructure, which leads to micro-galvanic corrosion alleviation. The tensile test results show that yield strength, ultimate tensile strength and elongation are improved by raising cooling rate and the improvement is mainly due to grain refinement.展开更多
文摘选取福建漳州地区经粮面压盖的高大平房仓为实验仓房,通过使用功率较小的储藏物冷却机与负压通风相结合的方式对仓房进行降温,中途应用改变粮面压盖的手段实现降温均匀和彻底。实验累计运行112.7 h,降温3.3℃,水分变化为0.1%,运行期间的降温单位能耗为0.47 k W·h/(℃·t),符合《谷物冷却机低温储粮技术规程》的规定,并且达到了保水降温的效果。
文摘Gametophytes of Laminaria japonica were cryopreserved in liquid nitrogen using encapsulation-dehydration with two-step cooling method. Gametophytes cultured at 10℃ and under continuous irradiance of 30 μmol m^-2 s^-1 for 3 weeks were encapsulated in calcium alginate beads. The beads were dehydrated in 0.4 molLl sucrose prepared with seawater for 6 h, desiccated in an incubator set at 10℃ and 70% relative humidity for 4 h, pre-frozen at either -40℃ or -60℃ for 30 min, and stored in liquid nitrogen for 〉24 h. As high as 43% of survival rate was observed when gametophytes were thawed by placing the beads in 40℃ seawater and re-hydrated in 0.05 molL^-1 citrate sodium prepared using 30‰ NaCl 7 d later. More cells of male gametophytes survived the whole procedure in comparison with female gametophytes. The cells of gametophytes surviving the preservation were able to grow asexually and produce morphologically normal sporophytes.
基金the National Natural Science Foundation of China (No. 50676081)the Science and Technology Department of Zhejiang Province (No. 2007C30063), China
文摘A single stage Stifling pulse tube cryocooler was designed based on REGEN 3.2 and fabricated for testing. The experimental results show that the cooler can provide a cooling capacity of 5.0 W at 79.1 K, and produce a no-load temperature of 57.0 K, operating with an average pressure of 2.50 MPa and a frequency of 60 Hz, performance results that are very close to the calculated values. The cryocooler can be cooled from room temperature to 80 K in 8.5 min. The fast cooldown time is a result of the small regenerator.
基金Project(20921002)supported by the Innovative Research Groups of the National Natural Science Foundation of ChinaProject(21221061)supported by the National Natural Science Foundation of China+1 种基金Project(201105007)supported by the Science and Technology Program of Jilin Province,ChinaProject(20140325003GX)supported by the Science and Technology Support Project of Jilin Province,China
文摘Mg?1Zn?0.5Ca alloys were prepared by traditional steel mould casting and water-cooled copper mould injection casting at higher cooling rate. Microstructure, mechanical properties and bio-corrosion resistance of two alloys were contrastively investigated. Grain size reduces remarkably and microstructure becomes homogenous when raising cooling rate. The bio-corrosion behaviour in 3.5% sodium chloride solution (3.5% NaCl) and Hank’s solution at 37°C was investigated using electrochemical polarization measurement and the results indicate that the alloy prepared at higher cooling rates has better corrosion resistance in both types of solution. Further mass loss immersion test in Hank’s solution reveals the same result. The reason of corrosion resistance improvement is that raising cooling rate brings about homogeneous microstructure, which leads to micro-galvanic corrosion alleviation. The tensile test results show that yield strength, ultimate tensile strength and elongation are improved by raising cooling rate and the improvement is mainly due to grain refinement.
