期刊文献+
共找到3篇文章
< 1 >
每页显示 20 50 100
分层水环境曝气诱导形成内波的过程与特性 被引量:3
1
作者 孙昕 杨潘 解岳 《中国环境科学》 EI CAS CSCD 北大核心 2016年第9期2658-2664,共7页
采用分层水库模型,在平均温度梯度为0.37℃/cm条件下,开展了系统的曝气诱导内波的中试研究.分析了曝气诱导形成内波的过程,探究了曝气诱导形成内波的类型,重点揭示了曝气扰动源形式和跃温层厚度对内波形成过程和特性的影响.实验结果表明... 采用分层水库模型,在平均温度梯度为0.37℃/cm条件下,开展了系统的曝气诱导内波的中试研究.分析了曝气诱导形成内波的过程,探究了曝气诱导形成内波的类型,重点揭示了曝气扰动源形式和跃温层厚度对内波形成过程和特性的影响.实验结果表明:扬水曝气产生的气水两相流是一种非定常的周期性扰动源,气水两相流的尾迹带动整个模型水体上下振动,这种振动在分层水体跃温层处诱导形成内波.从激发源角度上说,它是一种尾迹效应波.气弹释放周期在44.06~58.69s之间时,内波波高达到最大,当气弹释放周期达到180s时不能形成连续的内波;曝气器出流口增大,内波波高、周期呈增大趋势.分层水体的跃温层厚度也影响内波的形成,相同温度梯度条件下,随着跃温层厚度的增加,内波的波高、周期随之增大. 展开更多
关键词 内波 曝气 分层水环境 出流口直径 跃温层厚度
下载PDF
Study of Choked Flows through a Convergent Nozzle 被引量:2
2
作者 Kazunori KUBO Yoshiaki MIYAZATO Kazuyasu MATSUO 《Journal of Thermal Science》 SCIE EI CAS CSCD 2010年第3期193-197,共5页
When sonic nozzles of significantly smaller diameter are used as standard flow meters,the critical back pressure ratio is affected by the boundary layer at the nozzle throat.However,the effect of the boundary layer on... When sonic nozzles of significantly smaller diameter are used as standard flow meters,the critical back pressure ratio is affected by the boundary layer at the nozzle throat.However,the effect of the boundary layer on choking criteria is still controversial.Then,the choking phenomenon of a convergent nozzle flow has been experimentally investigated using four convergent nozzles with the same diameter followed by a straight pipe of a variable length.As a result,it is shown that the critical back pressure ratio is smaller than that for the steady one-dimensional is-entropic flow and decreases as the boundary layer thickness increases.Moreover,the main flow Mach number at the nozzle exit is supersonic when the back pressure ratio is equivalent to the choking condition,and the Mach number increases as the boundary layer thickness increases. 展开更多
关键词 Boundary Layer Convergent Nozzle Choked Flow Choking Pressure Ratio
原文传递
A miniature pump with a fluid dynamic bearing 被引量:4
3
作者 LUO XianWu JI Bin +3 位作者 ZHUANG BaoTang ZHU Lei LU Li XU HongYuan 《Science China(Technological Sciences)》 SCIE EI CAS 2012年第3期795-801,共7页
This paper describes the development of a miniature pump having an impeller with an exit diameter of 24 mm supported with the motor rotor by a fluid dynamic beating. Tests verify that the miniature pump is stable and ... This paper describes the development of a miniature pump having an impeller with an exit diameter of 24 mm supported with the motor rotor by a fluid dynamic beating. Tests verify that the miniature pump is stable and quiet for rotational speeds larger than 4000 rain-1. The three-dimensional turbulent flow in the entire pump flow passage and the laminar flow in the fluid dynamic bearing were then simulated numerically. The average pump performance was well predicted by the simulations. Both the tests and the simulations show that there is no obvious Reynolds effect for the miniature pump within the tested range of rotational speeds. The numerical results also show that the beating capacity of the fluid dynamic bearing increases with the pump rotor rotational speed and the eccentricity ratio of the journal to the bushing. This pump is very compact, so it is a prom- ising device for surgical use. 展开更多
关键词 miniature pump fluid dynamic bearing hydraulic performance EXPERIMENT numerical simulation
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部