期刊文献+
共找到6篇文章
< 1 >
每页显示 20 50 100
骨架式车身力流试验分析研究
1
作者 田林雳 高云凯 安秀哲 《机械工程学报》 EI CAS CSCD 北大核心 2016年第10期103-112,共10页
以特定工况下某骨架式车身为例,进行结构力流试验分析研究。测量车身骨架关键位置的应力应变,分析车身骨架的力学性能;提出以具有相同量纲的应力成分描述力流分布、以内力矩描述力流传递的力流评价方法;引入并改进承载因子和承载均匀性... 以特定工况下某骨架式车身为例,进行结构力流试验分析研究。测量车身骨架关键位置的应力应变,分析车身骨架的力学性能;提出以具有相同量纲的应力成分描述力流分布、以内力矩描述力流传递的力流评价方法;引入并改进承载因子和承载均匀性系数作为车身结构承载能力的评价指标;基于力流分析给出车身骨架结构的优化方案。研究结果表明,弯矩应力成分可以作为力流分布的主要评价依据,翘曲应力成分可以作为观测力流走向的辅助手段;扭转工况下车身骨架纵梁主要起传递力流的作用,横梁和立柱组成抗扭环,主要起分担力流的作用,车身的前部、中部和后部都应存在抗扭环,若缺失必将影响车身结构的承载能力;力流优化使骨架式车身结构的承载能力提升18.71%,载荷分布均匀性提高14.89%。力流分析对车身结构设计及优化有重要参考价值。 展开更多
关键词 骨架式车身结构 流分布 力流传递 承载能
下载PDF
Transfer Characteristics in Mechanically Stirred Airlift Loop Reactors with or without Static Mixers 被引量:5
2
作者 吕效平 王延儒 时钧 《Chinese Journal of Chemical Engineering》 SCIE EI CAS CSCD 2000年第3期208-211,共4页
The mechanically stirred internal loop airlift reactors equipped with or without static mixers are devised for intensification of gas-liquid mass transfer rate. The influences of superficial gas velocity, agitation o... The mechanically stirred internal loop airlift reactors equipped with or without static mixers are devised for intensification of gas-liquid mass transfer rate. The influences of superficial gas velocity, agitation or static mixers on gas hold-up, mixing time, liquid circulating velocity and volumetric mass transfer coefficient have been investigated with tap water and carboxymethyl cellulose (CMC) aqueous solution. The experimental results indicate that mechanical agitation is more efficacious than static mixer in highly viscous media for improving mass transfer in airlift reactors. The empirical correlation of volumetric mass transfer coefficient with apparent viscosity, and energy consumption for mechanical agitation and aeration is developed. 展开更多
关键词 airlft loop reactor static mixer STIRRER HYDRODYNAMICS mass transfer
下载PDF
Hydrodynamics and Mass Transfer of Jet Co-flow Packing Tray
3
作者 刘国标 兰仁水 +1 位作者 王树楹 余国琮 《Chinese Journal of Chemical Engineering》 SCIE EI CAS CSCD 2005年第1期131-134,共4页
The jet co-flow packing tray(JCPT) with three different types of perforation in equal opening fraction was tested in two rectangular columns with 0.12m in width and 0.27m in length operated with air-water system. The ... The jet co-flow packing tray(JCPT) with three different types of perforation in equal opening fraction was tested in two rectangular columns with 0.12m in width and 0.27m in length operated with air-water system. The influences of gas phase orifice F-factor and clear liquid height Hc on the amount of liquid lifted, Q, were examined. The corresponding correlation between Q with F-factor and equivalent diameter of perforated holes as well as Hc was obtained. Furthermore, the non-steady state mass transfer performance of JCPT was tested by the humidification of air with water. Finally, by the analysis of data and comparison, it was found that the JCPT tray with single cap and two holes exhibited the highest mass transfer efficiency and best performance. 展开更多
关键词 PACKING TRAY mass transfer tray efficiency jet co-flow packing tray
下载PDF
大型锻压机典型组合结构接触问题的研究 被引量:3
4
作者 王芳芳 湛利华 黄明辉 《锻压技术》 CAS CSCD 北大核心 2011年第1期69-72,共4页
为保证大型锻压机组合结构的整体工作性能,针对锻压机典型的局部组合结构——C型板与十字键联接,运用大型商用有限元软件Marc,分析了锻造过程中巨大工作载荷传递引起的两者之间的接触状态变化规律。研究结果表明:工作载荷作用下,十字键... 为保证大型锻压机组合结构的整体工作性能,针对锻压机典型的局部组合结构——C型板与十字键联接,运用大型商用有限元软件Marc,分析了锻造过程中巨大工作载荷传递引起的两者之间的接触状态变化规律。研究结果表明:工作载荷作用下,十字键和C型板之间接触面积减小,出现"开缝"和界面接触应力分布极度不均匀的现象,直接影响压机结构承载过程中的力流传递特征。通过设置合理的过盈量,使"开缝"值在满足强度设计条件下的最大降幅达到77.87%,改善了接触应力分布极度不均匀现象,最大应力差值由156.42 MPa降为131.59MPa,增大了两者之间的接触面积,使得力流传递均匀。 展开更多
关键词 锻压机 组合结构 有限元分析 接触应 力流传递
原文传递
JOY与DBT液压支架底座前后过桥结构研究 被引量:1
5
作者 孙远方 张兴辉 +1 位作者 孟丽娜 韩振仙 《矿山机械》 2018年第8期10-14,共5页
根据JOY及DBT液压支架底座前后过桥不同的结构特点,进行三维建模,以及在3种恶劣试验工况下的有限元受力分析,结合力流的传递特点和规律,进行对比分析研究,为国内液压支架的设计研发以及进一步提高产品可靠性提供参考。
关键词 JOY DBT 液压支架 底座过桥 有限元分析 力流传递
原文传递
HEAT AND MASS TRANSFER EFFECTS ON CARREAU FLUID MODEL FOR BLOOD FLOW THROUGH A TAPERED ARTERY WITH A STENOSIS 被引量:9
6
作者 NOREEN SHER AKBAR DBSEH CEME 《International Journal of Biomathematics》 2014年第1期69-89,共21页
In the current critique, we deliberate the blood flow through narrowing vein with a steno- sis in the manifestation of heat and mass transmission. The non-Newtonian flora of blood in small veins are examined mathemati... In the current critique, we deliberate the blood flow through narrowing vein with a steno- sis in the manifestation of heat and mass transmission. The non-Newtonian flora of blood in small veins are examined mathematically by demonstrating the blood as Carreau fluid. The illustration for the blood flow is debated through an axially irregular but outward regular stenosis. Regularity in the dissemination of the fortification clipping stress and resistive impedance and their evolution with the emerging stenosis is a new significant feature of our investigation. Analytical solutions have been appraised for "velocity, tem- perature, concentration, resistance impedance, wall shear stress and shearing stress at the stenosis throat". The graphical consequences of different types of tapering arteries (i.e. "converging tapering, diverging tapering, non-tapered artery") have been studied for dissimilar constraints of attention. Rivulet shapes have been strategized for different parameters at the culmination of the article. 展开更多
关键词 Carreau fluid blood flow tapered artery STENOSIS analytical solution heat and mass transfer.
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部