In order to reveal the law of raw coal seepage at different gas pressures, the gravity constant load seepage experimental system was developed and used. The law of raw coal seepage at different gas pressures with He, ...In order to reveal the law of raw coal seepage at different gas pressures, the gravity constant load seepage experimental system was developed and used. The law of raw coal seepage at different gas pressures with He, N2 and CO2 was investigated. The results show that, in a given state of stress during the experiment, with the increase of gas pressure, the permeability of raw coal sample prone to outburst exhibits a significantly decrease, and then exhibits an increasing trend when reaching the extreme point. The law of Klingberg coefficient related to the stress state and the gas adsorption properties was also obtained. Under the same experimental conditions, the Klingberg coefficient of He is greater than that of N2; and the Klingberg coefficient of CO2 has minimum value; so the stronger the gas adsorption is, the smaller the Klingberg coefficient of gas goes. Klinkenberg coefficient decreases with the increase of effective stress. Under the same conditions, the permeability of He is greater than that of N2; the permeability of CO2 has minimum value; so the stronger the gas adsorption is, the lower the permeability of the coal sample goes. The results have important significance in revealing the mechanism of gas seenage. Dredicting coal mine gas disaster, and gas drainage and safety nroduction.展开更多
Since 1992 the author has led research group in Xi'an Jiaotong University to investigate and develop micro-electro mechanical systems(MEMS) sensors,including pressure sensor,acceleration sensor,gas sensor,viscosit...Since 1992 the author has led research group in Xi'an Jiaotong University to investigate and develop micro-electro mechanical systems(MEMS) sensors,including pressure sensor,acceleration sensor,gas sensor,viscosity & density sensor,polymerase chain reaction(PCR) chip and integrated sensor etc.This paper introduces the technologies and research results related to MEMS sensors we achieved in the last 20 years.展开更多
The work presents the results of tests on the shear parameters of walls made of AAC （autoclaved aerated concrete, fb = 4.0 N/mm2） on the system mortar for thin M5 and M10 joints （fm = 6.1 N/mm2 and fro = 11.9 N/mm2...The work presents the results of tests on the shear parameters of walls made of AAC （autoclaved aerated concrete, fb = 4.0 N/mm2） on the system mortar for thin M5 and M10 joints （fm = 6.1 N/mm2 and fro = 11.9 N/mm2） and on polyurethane glue and also walls without mortar （dry masonry）. The wall compression strength （on mortar M5 class） （per EN 1052-1：2000） amounted tofc,mv= 2.97 N/mm2 （fk = 2.48 N/mm2）, elastic modulus was Ecru = 2,040 N/mm2. Various structure of bed joints and head joints were applied and the following were used as reinforcement： steel trusses of EFZ 140/Z 140 type （Z1 type） and meshes made of plastics （Z2 type）. Based on the tests carried out with regard to unreinforced elements, it was shown that the filling in of head joints with mortar had an advantageous effect on the values of cracking and destruction stresses. While, with the use of reinforcement, advantageous increase of stress was obtained only when the mortar was laid twice on both bed surfaces of masonry units. The application of reinforcement in the bed joints when the mortar was laid only on one bed joints surface of the masonry units reduced the values of cracking and destruction stresses in relation to the values obtained in the unreinforced walls.展开更多
基金supported by the Fundamental Research Funds for the Central Universities (No. 2011QZ02)the National Natural Science Foundation of China (No. 51204189)the National Basic Research Program of China (No. 2011CB201202)
文摘In order to reveal the law of raw coal seepage at different gas pressures, the gravity constant load seepage experimental system was developed and used. The law of raw coal seepage at different gas pressures with He, N2 and CO2 was investigated. The results show that, in a given state of stress during the experiment, with the increase of gas pressure, the permeability of raw coal sample prone to outburst exhibits a significantly decrease, and then exhibits an increasing trend when reaching the extreme point. The law of Klingberg coefficient related to the stress state and the gas adsorption properties was also obtained. Under the same experimental conditions, the Klingberg coefficient of He is greater than that of N2; and the Klingberg coefficient of CO2 has minimum value; so the stronger the gas adsorption is, the smaller the Klingberg coefficient of gas goes. Klinkenberg coefficient decreases with the increase of effective stress. Under the same conditions, the permeability of He is greater than that of N2; the permeability of CO2 has minimum value; so the stronger the gas adsorption is, the lower the permeability of the coal sample goes. The results have important significance in revealing the mechanism of gas seenage. Dredicting coal mine gas disaster, and gas drainage and safety nroduction.
文摘Since 1992 the author has led research group in Xi'an Jiaotong University to investigate and develop micro-electro mechanical systems(MEMS) sensors,including pressure sensor,acceleration sensor,gas sensor,viscosity & density sensor,polymerase chain reaction(PCR) chip and integrated sensor etc.This paper introduces the technologies and research results related to MEMS sensors we achieved in the last 20 years.
文摘The work presents the results of tests on the shear parameters of walls made of AAC （autoclaved aerated concrete, fb = 4.0 N/mm2） on the system mortar for thin M5 and M10 joints （fm = 6.1 N/mm2 and fro = 11.9 N/mm2） and on polyurethane glue and also walls without mortar （dry masonry）. The wall compression strength （on mortar M5 class） （per EN 1052-1：2000） amounted tofc,mv= 2.97 N/mm2 （fk = 2.48 N/mm2）, elastic modulus was Ecru = 2,040 N/mm2. Various structure of bed joints and head joints were applied and the following were used as reinforcement： steel trusses of EFZ 140/Z 140 type （Z1 type） and meshes made of plastics （Z2 type）. Based on the tests carried out with regard to unreinforced elements, it was shown that the filling in of head joints with mortar had an advantageous effect on the values of cracking and destruction stresses. While, with the use of reinforcement, advantageous increase of stress was obtained only when the mortar was laid twice on both bed surfaces of masonry units. The application of reinforcement in the bed joints when the mortar was laid only on one bed joints surface of the masonry units reduced the values of cracking and destruction stresses in relation to the values obtained in the unreinforced walls.
