期刊文献+
共找到5篇文章
< 1 >
每页显示 20 50 100
车轴压装部相控阵超声波探伤的各向异性扩散去噪改进算法 被引量:5
1
作者 彭朝勇 高晓蓉 王艾 《中国铁道科学》 EI CAS CSCD 北大核心 2017年第3期77-82,共6页
为了在铁路车轴相控阵超声波自动探伤中有效去除车轴压装部轮轴接触界面回波的干扰,结合车轴压装部裂纹的周向连续性远高于轴向连续性这一固有特征,选取超声波声束沿周向扫查(B扫)方式对车轴压装部进行超声波检测,然后对原始超声波检测... 为了在铁路车轴相控阵超声波自动探伤中有效去除车轴压装部轮轴接触界面回波的干扰,结合车轴压装部裂纹的周向连续性远高于轴向连续性这一固有特征,选取超声波声束沿周向扫查(B扫)方式对车轴压装部进行超声波检测,然后对原始超声波检测信号进行数字信号处理,得到车轴压装部的B扫图;基于B扫图中界面回波与缺陷回波不同的连续性及不同的聚集特征,提出使用局部区域对比度作为聚集特征的表征参数,并将该参数作为各向异性扩散函数的一个参量,对传统的各向异性扩散去噪算法进行改进,建立基于区域对比度的自适应各向异性扩散改进算法。试验和实车的验证结果表明:与传统算法相比,采用改进算法得到的峰值信噪比和对比噪声比分别提高5.2和7.8dB,在不漏判的情况下误判率下降了18%。 展开更多
关键词 铁路车轴 压装部 超声波探伤 相控阵 各向异性扩散 区域对比度 去噪算法
下载PDF
轮轴压装部超声波探伤的比较
2
作者 戴志勇 《铁道机车车辆工人》 1994年第10期16-18,22,共4页
车辆轮轴是在载荷作用下的运转部件,在车辆运行中承受拉压、剪切、弯曲、扭转等交变应力的作用,在车轴压装部的应力集中部位(轮座外侧10~35mm,内侧5~30mm处)逐渐产生疲劳裂纹,而且在耦合面上易产生透油透锈等缺陷。 由于轮座区域肉眼... 车辆轮轴是在载荷作用下的运转部件,在车辆运行中承受拉压、剪切、弯曲、扭转等交变应力的作用,在车轴压装部的应力集中部位(轮座外侧10~35mm,内侧5~30mm处)逐渐产生疲劳裂纹,而且在耦合面上易产生透油透锈等缺陷。 由于轮座区域肉眼不可见,通常所采用的是超声波探伤方法。根据采用的波形不同,可分为小角度探伤方法和大角度探伤方法。1 展开更多
关键词 车辆 轮轴 压装部 超声波探伤 探伤
下载PDF
Comparison Voltage across Insulator Strings of 69 kV and 24 kV Lines due to Lightning Strokes to Top Pole and Mid Span
3
作者 Nattachote Rugthaicharoenchep Wetarin Thansiphrasertt~ +1 位作者 Nattapong Suwannachot Att Phayomhom 《Journal of Energy and Power Engineering》 2013年第7期1382-1387,共6页
This paper analyzes the effects of the voltage across insulator of 69 kV and 24 kV lines installed on the same pole. The case studies illustrated the lightning strike to direct top pole and mid span of ground wire usi... This paper analyzes the effects of the voltage across insulator of 69 kV and 24 kV lines installed on the same pole. The case studies illustrated the lightning strike to direct top pole and mid span of ground wire using the ATP-EMTP (Alternative Transient Program-Electromagnetic Transient Program). The results found that when lightning strike the voltage across the 69 kV line insulator at mid span is 1.55 times and 1.34 times higher than at top pole when the front time is 0.25/100μs and 10/350 μs, respectively. When lightning strike the voltage across the 24 kV line at mid span is 1.04 times and 0.64 times higher than at top pole when the front time is 0.25/100μs and 10/350μs, respectively. So the effect of lightning strike is more severe at mid span than at the direct top pole, especially for the 69 kV insulator. 展开更多
关键词 Overhead ground wire ground rod INSULATOR subtransmission ATP-EMTP lightning concrete pole impulse impedance.
下载PDF
Advances of the Vertical Directional Solidification Technique for the Growth of High Quality GaSb Bulk Crystals 被引量:2
4
作者 Dattatray Bhairu Gadkari 《Journal of Chemistry and Chemical Engineering》 2012年第1期65-73,共9页
Advantages of the detached phenomena have influenced researchers to modify the conventional methods to promote it on the earth. Since 1994, the vertical directional solidification (VDS) technique has been employed f... Advantages of the detached phenomena have influenced researchers to modify the conventional methods to promote it on the earth. Since 1994, the vertical directional solidification (VDS) technique has been employed for the growth of bulk crystals, without the seed, without contact to the ampoule wall, without coating and without external pressure. An automated furnace was designed and fabricated for the controlled temperature gradients, growth conditions and parameters. The typical ingots growths of GaSb have shown the gap of 20 μm-145 μm and mobility μn = 1125 cm^2/V.sec at 300 K. Mobility is highest and five times larger than the attached growths. Dislocation density is the order of 104/cm2 in the conical region, decreases in the direction of growth, and in many crystals reached less than 103/cm2. The spontaneous gap formation due to the meniscus depends on the pressure differences and thermal state. GaSb grown ingots have shown progress in the properties of crystal grown ever, and attributed to reduce thermal stress without contact to the ampoule wall. 展开更多
关键词 SOLIDIFICATION growth from melt ANTIMONIDES semiconduction Ⅲ-Ⅴ crystal structure detached growth.
下载PDF
Fluctuant characteristics of two-phase flow behind a bottom aerator
5
作者 聂孟喜 《Science China(Technological Sciences)》 SCIE EI CAS 2001年第3期291-297,共7页
Experimental observations show that the random process of two-phase flow behind an aerator is an ergodic process and its amplitude distribution is similar to a normal distribution. The maximum pressure fluctuation is ... Experimental observations show that the random process of two-phase flow behind an aerator is an ergodic process and its amplitude distribution is similar to a normal distribution. The maximum pressure fluctuation is at the re-attachment point where the jet-trajectory flow over the aerator re-attaches to the bottom of the channel, and its amplitude is 2—3 times larger than when there is no aerator. There is a dominant frequency of 1.24 Hz in the model, but the coherence in the frequency domain is not obvious for other frequencies beside the dominant frequency. There is a large vortex at the re-attachment point behind the aerator but correlation among the measurement points is not obvious in the time domain. 展开更多
关键词 pressure fluctuation bottom aerator ergodic process coherence function AUTOCORRELATION crosscorrelation function
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部