Seafloor Sediment Classification Based on Multibeam Sonar Data

The multibeam sonars can provide hydrographic quality depth data as well as hold the potential to provide calibrated measurements of the seafloor acoustic backscattering strength. There has been much interest in utilizing backscatters and images from multibeam sonar for seabed type identification and most results are obtained. This paper has presented a focused review of several main methods and recent developments of seafloor classification utilizing multibeam sonar data or/and images. These are including the power spectral analysis methods, the texture analysis, traditional Bayesian classification theory and the most active neural network approaches.

Demodulated method of optical fiber Stokes temperature sensors

Based on the Stokes signals of the spontaneous Raman backscattering,a demodulated method for the simultaneous distributed temperature measurement in an optical fiber is presented to improve the sensitivity of the sensor.The experimental system of Stokes temperature sensor is set up and 2 km of operating length,1 m of distance resolution ,accuracy of ±0.1℃ are obtained.

Dynamic fracture behavior of rock under impact load using the caustics method

We studied the dynamic fracture mechanical behavior of rock under different impact rates. The fracture experiment was a three-point bending beam subjected to different impact loads monitored using the reflected caustics method. The mechanical parameters for fracture of the three-poim bending beam specimen under impact load are analyzed. The mechanism of crack propagation is discussed. Experimental results show that the dynamic stress intensity factor increases before crack initiation. When the dynamic stress intensity factor reaches its maximum value the crack starts to develop. After crack initiation the dynamic stress intensity factor decreases rapidly and oscillates. As the impact rate increases the cracks initiate earlier, the maximum value of crack growth velocity becomes smaller and the values of dynamic stress intensity factor also vary less during crack propagation. The results provide a theoretical basis for the study of rock dynamic fracture.

Effect of non-Gaussian properties of the sea surface on the low-incidence radar backscatter and its inversion in terms of wave spectra by an ocean wave spectrometer

The principle of ocean wave spectrometers was first presented several decades ago to detect the directional wave spectrum with real-aperture radar(Jackson,1981). To invert wave spectra using an ocean wave spectrometer,for simplicity,the hydrodynamic forcing and wave-wave interaction effect are neglected and a Gaussian slope probability density function(pdf) is used to calculate the normalized backscattering cross-section( σ 0) of the ocean surface. However,the real sea surface is non-Gaussian. It is not known whether the non-Gaussian property of the sea surface will affect the performance of the inversion of the wave spectrum if following existing inversion steps and methods. In this paper,the pdf of the sea surface slope is expressed as a Gram-Charlier fourth-order expansion,which is quasi-Gaussian. The modulation transfer function(MTF) is derived for a non-Gaussian slope pdf. The effects of non-Gaussian properties of the sea surface slope on the inversion process and result are then studied in a simulation of the SWIM(Surface Waves Investigation and Monitoring) instrument configuration to be used on the CFOSAT(China-France Oceanography Satellite) mission. The simulation results show that the mean trend of σ 0 depends on the sea slope pdf,and the peakedness and skewness coefficients of the slope pdf affect the shape of the mean trend of σ 0 versus incidence and azimuth; owing to high resolution of σ 0 in the range direction,MTF obtained using the mean trend of σ 0 is almost as accurate as that set in the direct simulation; in the inversion,if ignoring the non-Gaussian assumption,the inversion performances for the wave spectrum decrease,as seen for an increase in the energy error of the inverted wave slope spectrum. However,the peak wavelength and wave direction are the same for inversions that consider and ignore the non-Gaussian property.

Chemical Composition of Summertime PM_(2.5) and Its Relationship to Aerosol Optical Properties in Guangzhou,China

Urban aerosols have a large effect on the deterioration of air quality and the degradation of atmospheric visibility.Characterization of the chemical composition of PM 2.5 and in situ measurements of the optical properties of aerosols were conducted in July 2008 at an urban site in Guangzhou,Southern China.The mean PM 2.5 concentration for the entire period was 53.7±23.2 μg m 3.The mean PM 2.5 concentration (82.7±25.4 μg m 3) on hazy days was roughly two times higher than that on clear days (38.8±8.7 μg m 3).The total water-soluble ion species and the total average carbon accounted for 47.9%±4.3% and 35.2%±4.5%,respectively,of the major components of PM 2.5.The increase of secondary and carbonaceous aerosols,in particular ammonium sulfate,played an important role in the formation of haze pollution.The mean absorption and scattering coefficients and the single scattering albedo over the whole period were 53±20 M m 1,226±111 M m 1,and 0.80±0.04,respectively.PM 2.5 had a high linear correlation with the aerosol extinction coefficient,elemental carbon (EC) was correlated with aerosol absorption,and organic carbon (OC) and SO 4 2 were tightly linked to aerosol scattering.

Impact of Different Aerosols on the Evolution of the Atmospheric Boundary Layer

The present work analyzes the effect of aerosols on the evolution of the atmospheric boundary layer (ABL) over Shangdianzi in Beijing.A one-dimensional ABL model and a radiative transfer scheme are incorporated to develop the structure of the ABL.The diurnal variation of the atmospheric radiative budget,atmospheric heating rate,sensible and latent heat fluxes,surface and the 2 m air temperatures as well as the ABL height,and its perturbations due to the aerosols with different single-scattering albedo (SSA) are studied by comparing the aerosol-laden atmosphere to the clean atmosphere.The results show that the absorbing aerosols cause less reduction in surface evaporation relative to that by scatting aerosols,and both surface temperature and 2 m temperature decrease from the clean atmosphere to the aerosol-laden atmosphere.The greater the aerosol absorption,the more stable the surface layer.After 12:00 am,the 2 m temperature increases for strong absorption aerosols.In the meantime,there is a slight decrease in the 2 m temperature for purely scattering aerosols due to radiative cooling.The purely scattering aerosols decrease the ABL temperature and enhance the capping inversion,further reducing the ABL height.

Performance evaluation of operational atmospheric correction algorithms over the East China Seas

To acquire high-quality operational data products for Chinese in-orbit and scheduled ocean color sensors, the performances of two operational atmospheric correction(AC) algorithms(ESA MEGS 7.4.1 and NASA Sea DAS 6.1) were evaluated over the East China Seas(ECS) using MERIS data. The spectral remote sensing reflectance R_(rs)(λ), aerosol optical thickness(AOT), and ?ngstr?m exponent(α) retrieved using the two algorithms were validated using in situ measurements obtained between May 2002 and October 2009. Match-ups of R_(rs), AOT, and α between the in situ and MERIS data were obtained through strict exclusion criteria. Statistical analysis of R_(rs)(λ) showed a mean percentage difference(MPD) of 9%–13% in the 490–560 nm spectral range, and significant overestimation was observed at 413 nm(MPD>72%). The AOTs were overestimated(MPD>32%), and although the ESA algorithm outperformed the NASA algorithm in the blue-green bands, the situation was reversed in the red-near-infrared bands. The value of α was obviously underestimated by the ESA algorithm(MPD=41%) but not by the NASA algorithm(MPD=35%). To clarify why the NASA algorithm performed better in the retrieval of α, scatter plots of the α single scattering albedo(SSA) density were prepared. These α-SSA density scatter plots showed that the applicability of the aerosol models used by the NASA algorithm over the ECS is better than that used by the ESA algorithm, although neither aerosol model is suitable for the ECS region. The results of this study provide a reference to both data users and data agencies regarding the use of operational data products and the investigation into the improvement of current AC schemes over the ECS.

Reanalysis of Elastic Scattering of ~6Li + ^(209)Bi Reaction Using a New DensityDistribution of ~6Li Nucleus

In the present paper, the elastic scattering of6 Li + 209 Bi system is reanalyzed by using the double folding model (DFM) at energies near the Coulomb barrier (ELab=29.9 and 32.8 MeV). With this goal, a new density distribution of6 Li nucleus, the no-core full configuration (NCFC) density distribution (DD), is used to obtain the real potentials in DFM calculations. The NCFC DD results are compared with the results of both gaussian shape (GS) DD and an earlier study as well as the experimental data. This comparison provides information about the similarities and differences of the models used in calculations.

On Local Nonreflecting Boundary Conditions for Time Dependent Wave Propagation

The simulation of wave phenomena in unbounded domains generally requires an artificial boundary to truncate the unbounded exterior and limit the computation to a finite region.At the artificial boundary a boundary condition is then needed,which allows the propagating waves to exit the computational domain without spurious reflection.In 1977,Engquist and Majda proposed the first hierarchy of absorbing boundary conditions,which allows a systematic reduction of spurious reflection without moving the artificial boundary farther away from the scatterer.Their pioneering work,which initiated an entire research area,is reviewed here from a modern perspective.Recent developments such as high-order local conditions and their extension to multiple scattering are also presented.Finally,the accuracy of high-order local conditions is demonstrated through numerical experiments.