双馈风力发电机通过串联补偿线路外送风电时,会出现由感应发电机效应(induction generator effect,IGE)和次同步控制相互作用(sub-synchronous control interaction,SSCI)引起的次同步振荡问题。为分析该问题,以给其抑制措施提供依据,...双馈风力发电机通过串联补偿线路外送风电时,会出现由感应发电机效应(induction generator effect,IGE)和次同步控制相互作用(sub-synchronous control interaction,SSCI)引起的次同步振荡问题。为分析该问题,以给其抑制措施提供依据,建立了用于次同步振荡分析的双馈风力发电机模型,采用频率扫描法分析了IGE的机理和影响因素,从转子侧电流环的闭环控制角度推导分析了SSCI的机理和影响因素,并采用时域仿真法分别分析和验证了风速、串补度对IGE的影响及转子侧电流环控制参数对SSCI特性的影响。研究结果表明:串补度的增加和风速的减小会引起IGE;电流环控制器比例系数和积分系数的增大会引起SSCI。展开更多
Wind turbine size has increased continuously and correspondingly also its Reynolds numbers. The Reynolds number effect can therefore no longer be ignored in design and optimization of wind turbines. Reliable profile t...Wind turbine size has increased continuously and correspondingly also its Reynolds numbers. The Reynolds number effect can therefore no longer be ignored in design and optimization of wind turbines. Reliable profile test data should be available. A suitable facility for testing wind turbine profiles at high Reynolds numbers is the Cryogenic Wind Tunnel Cologne DNW-KKK. By means of injecting liquid nitrogen the tunnel can be cooled down to 100 K and the Reynolds number therefore can be raised accordingly. The maximum Reynolds number for 2D profile tests can reach 27x10^6. In this paper the test uncertainty and the flow quality of DNW-KKK were analyzed. Then some test results on the Reynolds number effect of the wind turbine profiles will be presented. The Reynolds number effect is different from model to model. Especially for thick profiles and flow control devices the Reynolds number effect is not always like the description in literature.展开更多
An electrostatic micromotor is compared with a conventional electromagnetic mieromotor, and the scaling effect of driving forces is analysed according to their different operation principles. Characteristic dimension ...An electrostatic micromotor is compared with a conventional electromagnetic mieromotor, and the scaling effect of driving forces is analysed according to their different operation principles. Characteristic dimension L represents the linear scale of micromotors. Electromagnetic driving force is proportional to high-order power of characteristic dimension L whereas electrostatic driving force is not. So, in micro domain, the effect of electrostatic force is larger than that of electromagnetic force, which makes electrostatic micromotor more competitive against electromagnetic alternative in MEMS. In assessing the performance of a micromotor, the power per unit volume and efficiency are the two most important criteria. Hence, the two kinds of micromotors are further compared from these two aspects. The results indicate that electrostatic a micromotor has higher power per unit volume and efficiency, moreover, its structure is simple, it can be made sufficiently small. For those advantages of electrostatic micromotors, they can be used in optical devices, aerospace equipment and medical instruments.展开更多
DC distribution networks are often employed in isolated power systems like in marine and aeronautical applications. An interesting alternative to DC machines for the supply of DC grids is constituted by a three-phase ...DC distribution networks are often employed in isolated power systems like in marine and aeronautical applications. An interesting alternative to DC machines for the supply of DC grids is constituted by a three-phase alternator feeding an AC/DC rectifier. In this paper, alternative solutions are investigated where the AC alternator is equipped with more （iV） three-phase windings and feeds the DC load through more （N） cascade-connected rectifiers. The advantages of this solution with respect to the conventional three-phase topology are highlighted along with their dependence on the number （N） of the alternator windings. For this purpose, test results are reported and discussed on a prototype generator whose stator coils can be differently connected to obtained one, two, three or four windings. The major benefits （in terms of DC output current quality and field current ripple） are found when passing from the three-phase solution to the dual winding topology; conversely, relatively little advantage is gained by increasing the number of stator windings above two.展开更多
To analyze wind-induced response characteristics of a wind turbine tower more accurately, the blade-tower coupling effect was investigated. The mean wind velocity of the rotating blades and tower was simulated accordi...To analyze wind-induced response characteristics of a wind turbine tower more accurately, the blade-tower coupling effect was investigated. The mean wind velocity of the rotating blades and tower was simulated according to wind shear effects, and the fluctuating wind velocity time series of the wind turbine were simulated by a harmony superposition method. A dynamic finite element method (FEM) was used to calculate the wind-induced response of the blades and tower. Wind-induced responses of the tower were calculated in two cases (one included the blade-tower coupling effect, and the other only added the mass of blades and the hub at the top of the tower), and then the maximal displacements at the top of the tower of the tow cases were compared with each other. As a result of the influence of the blade-tower coupling effect and the total base shear of the blades, the maximal displacement of the first case increased nearly by 300% compared to the second case. To obtain more precise analysis, the blade-tower coupling effect and the total base shear of the blades should be considered simultaneously in the design of wind turbine towers.展开更多
A transparent 3-mercaptopropyl trimethoxysilane(MPTMS)/Ag/MoO3 composite anode is introduced to fabricate green organic light-emitting diodes(OLEDs). Effects of the composite anode on brightness and operating voltage ...A transparent 3-mercaptopropyl trimethoxysilane(MPTMS)/Ag/MoO3 composite anode is introduced to fabricate green organic light-emitting diodes(OLEDs). Effects of the composite anode on brightness and operating voltage of OLEDs are researched. By optimizing the thickness of each layer of the MPTMS/Ag/MoO3 structure, the transmittance of MPTMS/Ag(8 nm)/Mo O3(30 nm) reaches over 75% at about 520 nm. The sheet resistance is 3.78 ?/□, corresponding to this MPTMS/Ag(8 nm)/MoO3(30 nm) structure. For the OLEDs with the optimized anode, the maximum electroluminescence(EL) current efficiency reaches 4.5 cd/A, and the maximum brightness is 37 036 cd/m2. Moreover, the OLEDs with the optimized anode exhibit a very low operating voltage(2.6 V) for obtaining brightness of 100 cd/m2. We consider that the improved device performance is mainly attributed to the enhanced hole injection resulting from the reduced hole injection barrier height. Our results indicate that employing the MPTMS/Ag/MoO3 as a composite anode can be a simple and promising technique in the fabrication of low-operating voltage and high-brightness OLEDs.展开更多
文摘双馈风力发电机通过串联补偿线路外送风电时,会出现由感应发电机效应(induction generator effect,IGE)和次同步控制相互作用(sub-synchronous control interaction,SSCI)引起的次同步振荡问题。为分析该问题,以给其抑制措施提供依据,建立了用于次同步振荡分析的双馈风力发电机模型,采用频率扫描法分析了IGE的机理和影响因素,从转子侧电流环的闭环控制角度推导分析了SSCI的机理和影响因素,并采用时域仿真法分别分析和验证了风速、串补度对IGE的影响及转子侧电流环控制参数对SSCI特性的影响。研究结果表明:串补度的增加和风速的减小会引起IGE;电流环控制器比例系数和积分系数的增大会引起SSCI。
文摘Wind turbine size has increased continuously and correspondingly also its Reynolds numbers. The Reynolds number effect can therefore no longer be ignored in design and optimization of wind turbines. Reliable profile test data should be available. A suitable facility for testing wind turbine profiles at high Reynolds numbers is the Cryogenic Wind Tunnel Cologne DNW-KKK. By means of injecting liquid nitrogen the tunnel can be cooled down to 100 K and the Reynolds number therefore can be raised accordingly. The maximum Reynolds number for 2D profile tests can reach 27x10^6. In this paper the test uncertainty and the flow quality of DNW-KKK were analyzed. Then some test results on the Reynolds number effect of the wind turbine profiles will be presented. The Reynolds number effect is different from model to model. Especially for thick profiles and flow control devices the Reynolds number effect is not always like the description in literature.
文摘An electrostatic micromotor is compared with a conventional electromagnetic mieromotor, and the scaling effect of driving forces is analysed according to their different operation principles. Characteristic dimension L represents the linear scale of micromotors. Electromagnetic driving force is proportional to high-order power of characteristic dimension L whereas electrostatic driving force is not. So, in micro domain, the effect of electrostatic force is larger than that of electromagnetic force, which makes electrostatic micromotor more competitive against electromagnetic alternative in MEMS. In assessing the performance of a micromotor, the power per unit volume and efficiency are the two most important criteria. Hence, the two kinds of micromotors are further compared from these two aspects. The results indicate that electrostatic a micromotor has higher power per unit volume and efficiency, moreover, its structure is simple, it can be made sufficiently small. For those advantages of electrostatic micromotors, they can be used in optical devices, aerospace equipment and medical instruments.
文摘DC distribution networks are often employed in isolated power systems like in marine and aeronautical applications. An interesting alternative to DC machines for the supply of DC grids is constituted by a three-phase alternator feeding an AC/DC rectifier. In this paper, alternative solutions are investigated where the AC alternator is equipped with more （iV） three-phase windings and feeds the DC load through more （N） cascade-connected rectifiers. The advantages of this solution with respect to the conventional three-phase topology are highlighted along with their dependence on the number （N） of the alternator windings. For this purpose, test results are reported and discussed on a prototype generator whose stator coils can be differently connected to obtained one, two, three or four windings. The major benefits （in terms of DC output current quality and field current ripple） are found when passing from the three-phase solution to the dual winding topology; conversely, relatively little advantage is gained by increasing the number of stator windings above two.
基金supported by the National Natural Science Foundation of China (No. 50708015)the Program for New Century Excellent Talents in University (No. NCET-06-0270), China
文摘To analyze wind-induced response characteristics of a wind turbine tower more accurately, the blade-tower coupling effect was investigated. The mean wind velocity of the rotating blades and tower was simulated according to wind shear effects, and the fluctuating wind velocity time series of the wind turbine were simulated by a harmony superposition method. A dynamic finite element method (FEM) was used to calculate the wind-induced response of the blades and tower. Wind-induced responses of the tower were calculated in two cases (one included the blade-tower coupling effect, and the other only added the mass of blades and the hub at the top of the tower), and then the maximal displacements at the top of the tower of the tow cases were compared with each other. As a result of the influence of the blade-tower coupling effect and the total base shear of the blades, the maximal displacement of the first case increased nearly by 300% compared to the second case. To obtain more precise analysis, the blade-tower coupling effect and the total base shear of the blades should be considered simultaneously in the design of wind turbine towers.
基金supported by the National Natural Science Foundation of China(No.21174036)the National High Technology Research and Development Program of China(863 Program)(No.2012AA011901)the National Basic Research Program of China(973 Program)(No.2012CB723406)
文摘A transparent 3-mercaptopropyl trimethoxysilane(MPTMS)/Ag/MoO3 composite anode is introduced to fabricate green organic light-emitting diodes(OLEDs). Effects of the composite anode on brightness and operating voltage of OLEDs are researched. By optimizing the thickness of each layer of the MPTMS/Ag/MoO3 structure, the transmittance of MPTMS/Ag(8 nm)/Mo O3(30 nm) reaches over 75% at about 520 nm. The sheet resistance is 3.78 ?/□, corresponding to this MPTMS/Ag(8 nm)/MoO3(30 nm) structure. For the OLEDs with the optimized anode, the maximum electroluminescence(EL) current efficiency reaches 4.5 cd/A, and the maximum brightness is 37 036 cd/m2. Moreover, the OLEDs with the optimized anode exhibit a very low operating voltage(2.6 V) for obtaining brightness of 100 cd/m2. We consider that the improved device performance is mainly attributed to the enhanced hole injection resulting from the reduced hole injection barrier height. Our results indicate that employing the MPTMS/Ag/MoO3 as a composite anode can be a simple and promising technique in the fabrication of low-operating voltage and high-brightness OLEDs.
