一种变温变压恒容吸气性能测试装置的原理及应用

针对制导武器专用热电池在运行时内部温度、气压剧变的问题,开发了一种变温、变压、恒容条件下材料吸气性能测试装置。运用理想气体模型,对装置过渡温区进行设计和修正,使其达到精度要求,并利用该装置有效表征了Li-B基吸气材料在变温、变压、恒容条件下的吸气性能。

An Accurate 1.08GHz CMOS LC Voltage-Controlled Oscillator

An accurate 1.08GHz CMOS LC voltage-controlled oscillator is implemented in a 0.35μm standard 2P4M CMOS process.A new convenient method of calculating oscillator period is presented.With this period calculation technique,the frequency tuning curves agree well with the experiment.At a 3.3V supply,the LC-VCO measures a phase noise of -82.2dBc/Hz at a 10kHz frequency offset while dissipating 3.1mA current.The chip size is 0.86mm×0.82mm.

Research on Volume Identification with the Method of Discharging at the Velocity of Sound

The method of volume identification in pneumatics was studied through theoretical analysis and experimental investigation. Regarding discharging from a container as a thermodynamic process with invariable index the dependence of the container’s volume on the pressure in the container and the index, during discharging at the velocity of sound, is deduced. Then through a lot of experiments, the value of index n of the process is found with a given precision and a specified volume range. Furthermore, the feasibility and practicability of this method are verified by experiments.

A low harmonic 12-pulse rectifier based on zigzag autotransformer by current injection at DC side

To improve the harmonic suppression ability of multi-pulse rectifier,a 12-pulse rectifier based on zigzag autotransformer by DC side active compensation strategy is proposed.By controlling the small capacity current inverter to generate compensating currents and injecting the currents directly into the DC side of the system,the grid-side currents of the rectifier can be approximated to sine wave.Using zigzag autotransformer as phase-shifting transformer can block the zero sequence current components and reduce the equivalent capacity of the rectifying system.The study on harmonic distortion rate of grid-side currents with the variation of the load shows that the harmonic content of the compensated rectifier decreases significantly under various load conditions.The harmonic content of the grid-side currents of the proposed active injection rectifier is only 1.17%,and the equivalent capacity of the rectifier is calculated.The results show that the rectifier can not only suppress the harmonic currents,but also have a lower equivalent capacity.

Design of a 4.224GHz Quadrature LC-VCO

A 4. 224GHz quadrature voltage-controlled oscillator （QVCO） applied in MB-OFDM UWB synthesizers is implemented in 0.18μm RF-CMOS technology. An improved structure of the QVCO is presented for better phase noise. A novel configuration of a MOS varactor is designed for good linearity of K as well as a new digital capacitor controlled array topology with lower parasitic capacitance and lower Ron. Measurement results show a phase noise of - 90.4dBc/Hz at 100kHz offset and - 116.7dBc/Hz at 1MHz offset from a carrier close to 4. 224GHz. The power dissipation is 10. 55mW from a 1.8V supply.

Permissible Stress Level of Brick Masonry under Compressive Cyclic Loading

Laboratory tests revealed that the behavior of brick masonry under compressive cyclic loading is characterized by three distinct stress-strain curves. These three curves are termed as envelope curve, common point curve and stability point curve. The envelope curve is obtained by superimposing the cyclic peaks on the monotonic stress-strain curve. The common point curve is the locus of intersection points of loading and unloading curves of the cycles. If for the same cycle, the loading and unloading are repeated several times, the intersection points of loading and unloading paths will stabilize at a lower bound. The locus of these stabilized points （lower bound points） of all cycles form the stability point curve. Therefore, the stability point curve can be used as a measure for the allowable stress for masonry under cyclic loadings. The proposed cyclic allowable stress level is associated with the accumulation of residual （plastic） strain levels as a result of cyclic loading history. The permissible stress level was found to be about two thirds of the cyclic peak stress of the specimen.

FCS-MPC for four-switch three-phase AC-DC converters with DC-link capacitor voltage balancing

Due to the decrease in the number of switches for the four-switch three-phase alternating current-direct current(FSTP AC-DC)converter,it can easily lead to DC-link capacitor voltage imbalance and the system stability reduction.In order to solve these problems,a finite control set model predictive control(FCS-MPC)for FSTP AC-DC converters with DC-link capacitor voltage balancing is proposed.In this strategy,in order to facilitate calculation,theαβcoordinate system model is established and all voltage vectors are evaluated by establishing a cost function.During the whole process,phase locked loop(PLL)and complex modulation strategy are not required.In the new established cost function,the additional objective term of suppressing capacitor voltage fluctuation is to eliminate effectively the capacitor voltages oscillations and deviations and improve the system reliability.The simulation results show that the proposed strategy can keep the capacitor voltage balancing and has good dynamic and static performance.