变流量生产的压力恢复曲线分析方法

本文比较了变流量压力恢复分析的几种方法,并用油田的一口实例井加以说明.

Oil–water two-phase flow pattern analysis with ERT based measurement and multivariate maximum Lyapunov exponent

Oil–water two-phase flow patterns in a horizontal pipe are analyzed with a 16-electrode electrical resistance tomography(ERT) system. The measurement data of the ERT are treated as a multivariate time-series, thus the information extracted from each electrode represents the local phase distribution and fraction change at that location. The multivariate maximum Lyapunov exponent(MMLE) is extracted from the 16-dimension time-series to demonstrate the change of flow pattern versus the superficial velocity ratio of oil to water. The correlation dimension of the multivariate time-series is further introduced to jointly characterize and finally separate the flow patterns with MMLE. The change of flow patterns with superficial oil velocity at different water superficial velocities is studied with MMLE and correlation dimension, respectively, and the flow pattern transition can also be characterized with these two features. The proposed MMLE and correlation dimension map could effectively separate the flow patterns, thus is an effective tool for flow pattern identification and transition analysis.

高层酒店客房空调水系统水力平衡简析

对于空调水系统,不同类型的建筑对于同程式和异程式系统的选择需根据实际计算确定。高层酒店客房通常采用风机盘管加新风空调系统,由于各客房层之间具有高度相似(相同)的布置,因此每层的风机盘管选型及布置位置也高度相似(相同)。以某高层酒店客房空调水系统为例,分析了不同系统及不同变流量工况时的水力平衡性,为高层酒店客房空调水系统的系统选择提供参考。

The Effects of Voltage and Suction Line Heat Exchanger on a Domestic Refrigerator＇s Performance

This experimental analysis shows the measured reduction in energy consumption as well as the effects of voltage on cycle temperatures, pressures, flow rates and also compressor speed （revolutions per minute）. The domestic refrigerator used R134a as refrigerant. Two energy consumption procedures were adapted from the JIS and ISO standards. The biggest difference between two standards is that the fridge is not opened in the ISO test while it is opened a number of times in the JIS test. The tests were carried out between 190 V and 250 V in steps of 10 V. The reduction in energy consumption was of 49.78 W-h per day or 6.27% of the total consumption. The experiments also showed that the voltage drop resulted in only a small rpm drop which in turn did not result in a noticeable refrigerant flow-rate change. Consequently the temperatures and pressures were not affected.

Time Series as an Aid to Research of Traction Substation Load

In the case of electric or tram traction vehicles, the energy for propulsion purposes, as well as all other purposes, is processed and delivered via traction substations. Knowledge of the course of traction substation loading, especially at the stage of its design, is an extremely important issue because of the choice of the processing equipment of the main circuit or protection devices. In the range of investigations of railway traction substation B in vicinity of Cracow （Poland）, the measurements of current load in hours 4：00 a.m.-8：00 p.m. were realized. The measurements for the analysis were chosen from those realized between 6：00 a.m.-8：00 a.m. （the morning rush time）. Due to the sampling of 2 h summit with a frequency of 2 kHz, the recorded data set contains 1.44 ~ 107 elements. Therefore, the necessary transformation of data was to lower frequency 1 Hz, 10 Hz and 50 Hz. The results of the analysis presented below indicate the effect of such conduct on the obtained results for the parameters of time series models. In view of the unsatisfactory effects of the polynomial approximation, there is a need to seek a more efficient approximation method for achieving the optimum compatibility with the measured process. Continued research should lead to the formulation of procedures, which will determine an acceptable accuracy of the expected variability of traction substation loads.

Analytical investigation for stress measurement with the rheological stress recovery method in deep soft rock

Due to the difficulty and weakness of current stress measurement methods in deep soft rock, a new rheological stress recovery method of the determination of the three-dimensional(3D) stress tensor is proposed. It is supposed that rock stresses will recovery gradually with time and can be measured by embedding transducers into the borehole. In order to explore the applicability and accuracy of this method, analytical solutions are developed for stress measurement with the rheological stress recovery method in a viscoelastic surrounding rock, the rheological properties of which are depicted as both the Burger's model and a 3-parameter solid model. In such conditions, explicit analytical expressions for predicting time-dependent pressures on the transducer are derived. A parametric analysis is then adopted to investigate the influences of the grout solidification time and the mechanical properties of the grout layer. The results indicate that this method is suitable for stress measurement in deep soft rock, the characteristics of which are soft, fractured and subjected to high geo-stress.

Hydroelastic responses of an elastic cylinder impacting on the free surface by MPS-FEM coupled method

In naval engineering and offshore industry,the fluid-structure interaction(FSI)problem is a very common problem,and water entry is a very representative one.The hydroelasticity effects due to slamming are of great interest.In this paper,the water entry problem is simulated by the moving particle semi-implicit&finite element method(MPS-FEM)coupled method.The MPS method is used for the fluid because it is very suitable for the violent free-surface flow.The structure domain is solved by the FEM method because of the maturity in solving structural motion and deformation.The water entry of a rigid cylinder is numerically studied first and the results show good agreements with previous published data.After that,variable analysis is conducted in the water entry simulation of an elastic cylinder,including the structural elasticity and impact velocity.