电动汽车驱动系统用永磁同步电动机起动过程的模糊控制与仿真

在Matlab/Sinulink下 ,针对电动汽车驱动用永磁同步电动机PMSM的驱动系统起动过程 ,建立了模糊控制仿真结构模型 。

电动汽车驱动系统用永磁同步电动机起动过程的模糊控制与仿真

在Matlab/Sinulink下,针对电动汽车驱动用永磁同步电动机PMSM的驱动系统起动过程,建立了模糊控制仿真结构模型,并进行了仿真。

5000kW 1000～1500r/min交-直-交变频调速同步电动机设计特点

本文简略介绍了由交-直-交负载换相逆变器(LCI)供电的交流调速同步电动机设计的特点,着重叙述谐波的抑制、电磁负荷的选取、阻尼绕组及电抗参数的确定等内容。

编队卫星姿态的自适应协同控制

研究了无向信息交互条件下的多卫星姿态同步和跟踪问题,分别在模型参数精确已知和存在模型参数不确定性的情形下设计分散式协同控制算法。当模型参数精确已知时,基于滑动模态变量设计的协同控制力矩,实现了编队卫星姿态的同步机动,即保证编队卫星姿态的同步,并同时跟踪期望的时变参考姿态轨迹。当在轨卫星存在模型参数不确定性和常值未知扰动力矩时,提出了一种自适应协同控制律,仍能实现多卫星姿态的同步机动。基于Lyapunov-Krasovskii的分析表明,当星间链路存在任意未知的定常通讯时延时,本文设计的控制器有效。数值仿真算例验证了本文提出的控制算法。

EFFECTIVE DOUBLE LOOP CONTROL FOR A SQUARE WAVE BRUSHLESS DC MOTOR

A new type of brushless DC motor has been developed by using a square wave rare earth permanent magnet synchronous motor with its double loop control circuit. The double loop control scheme of the drive system yields a combination of desired characteristics including simplified control structure, small ripple torque, high speed accuracy, wide operating speed range, and fast dynamic response. Experimental results confirm excellent characteristics of the motor.

Position Sensorless Control for Permanent Magnet Synchronous Motor Using Sliding Mode Observer

An approach of position sensorless control for permanent magnet synchronous motor （ PMSM ） is put forward based on a sliding mode observer. The mathematical model of PMSM in a stationary αβ reference frame is adopted, and the system is controlled by the digital signal processor （ DSP; TMS320LF2407 according to the control achieve closed loop operation of the motor, the stator theory of sliding mode observer. In order to magnetic field should be vertical with the rotor magnetic field and be synchronous with rotor rotating, so the position and speed of PMSM is estimated in real time and the estimated position is modified continuously. The simulation results indicate that the proposed observer has high precision is more robust to the parametric variation and load in estimation of PMSM position and speed, and torque disturbance.

Study on three dimensional electromagnetic model for permanent magnet linear synchronous motor

In this paper, with the non-salient pole permanent magnet linear synchronous motor (PMLSM)being cited, by using Fourier transform method and "slot-by-slot", "pole -by-pole" current approach, a 3D electromagnetic field model of PMLSM is established. Special attention is paid to its structure and the influence of longitudinal and transverse end effect. The distribution of electromagnetic field of PMLSM can be obtained directly and promptly by using FFT algorithm. It can also be used for the analysis of other LSM.

Energy management and coordination control of microgrid in elevated station of urban rail transit

The rapid development of urban rail transit brings convenience to the public,but its huge energy consumption problem cannot be ignored.A microgrid composed of photovoltaic power generation unit,regenerative braking energy feedback unit and battery energy storage unit is proposed,which provides green power for the station.In order to suppress the fluctuation of photovoltaic power generation and the intermittence of regenerative braking feedback energy,the energy management mode of microgrid is designed according to the illumination situation,braking energy feedback situation,battery state of charge and so on.In addition,a coordination control method based on virtual synchronous generator(VSG)is proposed to realize smooth switching among modes.Finally,the proposed energy management and coordination control method for elevated station microgrid is verified by Matlab/Simulink.The results show that the elevated station microgrid can operate safely and reliably under various energy management modes and realize smooth switching among modes.

Passive control of Permanent Magnet Synchronous Motor chaotic systems

Permanent Magnet Synchronous Motor model can exhibit a variety of chaotic phenomena under some choices of system parameters and external input. Based on the property of passive system, the essential conditions were studied, by which Permanent Magnet Synchronous Motor chaotic system could be equivalent to passive system. Using Lyapunov stability theory, the convergence condition deciding the system's characters was discussed. In the convergence condition area, the equivalent passive system could be globally asymptotically stabilized by smooth state feedback.

The analysis of the line-start permanent magnetic synchronous motor basing on the FEM

In this article, the 2D transient FEM has been used to analyze the dynamic process of the three phase LS-PMSM running characteristic. By verifying it through the experiment, we obtain the conclusion that the simulation result is consistent with the experiment result. At the same time, by analyzing the situation of the magnetic bridge, we also obtain the result that the EMF waves are changing with the situation of the magnetic poles on and we can optimize the motor’s structure at the same time.

A novel fuzzy logic direct torque controller for a permanent magnet synchronous motor with a field programmable gate array

A high-performance digital servo system built on the platform of a field programmable gate array (FPGA),a fully digitized hardware design scheme of a direct torque control (DTC) and a low speed permanent magnet synchronous motor (PMSM) is proposed. The DTC strategy of PMSM is described with Verilog hardware description language and is employed on-chip FPGA in accordance with the electronic design automation design methodology. Due to large torque ripples in low speed PMSM,the hysteresis controller in a conventional PMSM DTC was replaced by a fuzzy controller. This FPGA scheme integrates the direct torque controller strategy,the time speed measurement algorithm,the fuzzy regulating technique and the space vector pulse width modulation principle. Experimental results indicate the fuzzy controller can provide a controllable speed at 20 r min-1 and torque at 330 N m with satisfactory dynamic and static performance. Furthermore,the results show that this new control strategy decreases the torque ripple drastically and enhances control performance.

Vector control of permanent magnet synchronous motor based on dynamic matrix control

Aiming at the control problem of strongly nonlinear and coupled permanent magnet synchronous motor(PMSM)oil rig,this paper presents a predictive control method based on dynamic matrix model.In this method,the dynamic matrix algorithm using multistep prediction technique is applied to the speed loop control of the motor vector control.And its control effect is compared with the traditional proportional integral(PI)control of the motor.By comparing the initial dynamic response and the steady-state recovery under load interference of the two methods,it is shown that the dynamic response and the robustness of the motor controlled by the new method is better than that controlled by conventional PI method.And the feasibility of new control in the application of PMSM oil rig is verified.

Sliding mode control of chaos in the noise-perturbed permanent magnet synchronous motor with non-smooth air-gap

Permanent magnet synchronous motor (PMSM) is widely used in mining, and there exists chaotic behav- ior when it runs. In order to dispel its adverse effect on security in mining, the chaotic system of PMSM was analyzed. With noise disturbances, the complex dynamic characteristics of chaos were also analyzed, and proved the objective existence of chaos. As we all know, it is very difficult for conventional PMSM control to meet the design requirements, therefore, in order to ensure the robustness of the system, the chaotic orbits were stabilized to arbitrary chosen fixed points and periodic orbits by means of sliding mode method. Finally MATLAB simulations were presented to confirm the validity of the controller. The results show that the PMSM with the sliding mode control has a good dynamic performance and steady state accuracy.

Optimal design of auxiliary-teeth to solve circulation current reduction of permanent magnet linear synchronous motor

A discontinuity of magnetic circuits according to the end effect is generated in the permanent magnet linear synchronous motor （PMLSM）. Due to the unbalanced back electro-motive force （EMF） and impedance produced, unbalanced current is generated. The cireulatin8 current, which is caused by a decrease in the thrust, is generated by the unbalanced current. The optimal design of auxiliary-teeth at the end of the mover was carried out to solve the unbalance of phase by using design of experiment （DOE）, and compared with the basic model through finite element analysis （FEA）. As a result, the auxiliary-teeth model compensates for the decrease of thrust caused by the unbalanced phase. Also, this model is proven to reduce the detent force by the vibration and noise of the PMLSM and copper loss caused by the circulating current.

Design of relative position sensing system for high-speed maglev train

In the high-speed maglev system,accurate real-time information of the train position is essential forstable,safe and efficient train operation.To detect the relative position of the high-speed maglev trainfrom a reference position,a location method based on long stator slot detection was proposed.Besides,aprototype system has been successfully developed.The hardware structure of the system,as well as itsworking principle was described.Moreover,a subdivision algorithm for calculating the pole location anglesignal was elucidated.Experiments show that the proposed method is feasible.The technical indexes ofthe detection system satisfy the requirements of the vehicle operation control system.The relative positionsensing system can be put into practice.

Passive control of Permanent Magnet Synchronous Motor chaotic system based on state observer

Passive system theory was applied to propose a new passive control method with nonlinear observer of the Permanent Magnet Synchronous Motor chaotic system. Through constructing a Lyapunov function, the subsystem of the Permanent Magnet Synchronous Motor chaotic system could be proved to be globally stable at the equilibrium point. Then a controller with smooth state feedback is designed so that the Permanent Magnet Synchronous Motor chaotic system can be equivalent to a passive system. To get the state variables of the controller, the nonlinear observer is also studied. It is found that the outputs of the nonlinear observer can approximate the state variables of the Permanent Magnet Synchronous Motor chaotic system if the system’s nonlinear function is a globally Lipschitz function. Simulation results showed that the equivalent passive system of Permanent Magnet Synchronous Motor chaotic system could be globally asymptotically stabilized by smooth state feedback in the observed parameter convergence condition area.

An adaptive load torque observer using hyperstability for PMSM servo system

An adaptive load torque observer is presented to compensate the torque ripple in PMSM servo system. A simple adaptive scheme is derived using Popov ＇ s hyperstability theory. The torque ripple detected by the observer is compensated by a feed forwarding equivalent current which gives fast response. The noisy current information is exempt from the observer to avoid its deterioration to the quality of the observer. The speed measurement delay is considered by using observed speed sinee the instantaneous velocity can＇t be estimated precisely at low speed because of too few position pulses from the absolute encoder during one time interval. Simulation and experimental results demonstrate that the proposed method can improve the dynamic performance of PMSM servo system satisfyingly.

Study on cogging force of permanent magnet linear synchronous motor

Presented the methods to obtain the cogging force of permanent magnet linear synchronous motors(PMLSMs), analyzed the characteristics of the cogging force, and provided a basis for reducing the effect of the cogging force. 2-dimensional finite element method(2D FEM) was used to solve the whole motor when its mover was at dif- ferent position, so that the relation was derived between the cogging force and the mover position. The analysis results show that the cogging force between the two ends of the primary iron-core and the secondary permanent magnets (PMs) is sinusoidal function of the mover position under certain conditions only. Two proposed methods, namely direct and indirect methods, are applied to calculate the cogging force between the primary iron-core teeth and the secondary PMs. The agreement of the two methods is validated.

STUDY ON THE CHARACTERISTICS OF LOW FREQUENCY SYNCHROMOTOR USED IN MINE HOIST SYSTEMS FED BY THE CYCLOINVERTER

The Low Frequency Synchromotor Drive Mine Hoist System fed by the cycloinverter has good features from the technological and economical point of view. According to the erating char acteristic of the mine hoist system, an advanced analysis is given to the construction, the operating characteristics and the harmonics of the magnetomotive force of the synchromotor fed by the cy cloinverter, and the beneficial suggestions are also given in this paper.

Passivity-based control of synchronous motors in mine hoist systems

An adaptive PBC strategy for SM with a time-varying load torque to track fluxand speed trajectories was proposed.The key point of this method was the identificationof terms,known as workless forces,which appeared in the dynamic equations of SM buthad no effect on the energy balance equation of the closed loop.PBC,combined withadaptive control schemes,not only preserved the advantages of PBC such as nonexistenceof singularity,but also rejected the flux and speed tracking error caused by statorand rotor resistance variation.The rotor currents of SM were estimated via a state observer.This algorithm simplified the control structure and enhanced the robustness of thecontrol system.The feasibility and effectiveness were confirmed by experimental resultsbased on dSPACE.