Gas outbursts in underground mining occur under conditions of high gas desorption rate and gas content,combined with high stress regime, low coal strength and high Young's modulus. This combination of gas and stre...Gas outbursts in underground mining occur under conditions of high gas desorption rate and gas content,combined with high stress regime, low coal strength and high Young's modulus. This combination of gas and stress factors occurs more often in deep mining. Hence, as the depth of mining increases, the potential for outburst increases. This study proposes a conceptual model to evaluate outburst potential in terms of an outburst indicator. The model was used to evaluate the potential for gas outburst in two mines, by comparing numerical simulations of gas flow behavior under typical stress regimes in an Australian gassy mine extracting a medium-volatile bituminous coal, and a Chinese gassy coal mine in Qinshui Basin(Shanxi province) extracting anthracite coal. We coupled the stress simulation program(FLAC3D) with the gas simulation program(SIMED II) to compute the stress and gas pressure and gas content distribution following development of a roadway into the targeted coal seams. The data from gas content and stress distribution were then used to quantify the intensity of energy release in the event of an outburst.展开更多
The desulfurization performance of the UDS solvents was investigated at an industrial side-stream plant and was compared with that of MDEA solvent.A mass transfer performance model was employed for explaining the COS ...The desulfurization performance of the UDS solvents was investigated at an industrial side-stream plant and was compared with that of MDEA solvent.A mass transfer performance model was employed for explaining the COS absorption into different solvents.Meanwhile,the regeneration performance of the UDS solvents was evaluated in side-stream tests.Results indicate that under the conditions covering an absorption temperature of 40℃,a pressure of 8.0 MPa,and a gas to liquid volume ratio(V/L)of around 230,the H2S content in purified gas can be reduced to 4.2 mg/m3 and 0 by using solvents UDS-II and UDS-III,respectively.Moreover,the total sulfur content in both purified gases is less than 80 mg/m3.As a result,the UDS-III solvent shows by 30 percentage points higher in COS removal efficiency than MDEA.In addition,the total volume mass transfer coefficient of UDS solvent is found to be twice higher than that of MDEA.Furthermore,the UDS solvents exhibit satisfactory thermal stability and regeneration performance.展开更多
A systematic investigation of the microstructure of CrA1CxN1-x coatings as a function of carbon contents was conducted. Quaternary CrA1CxN1-x coatings were deposited on Si wafers by a hybrid coating system combining a...A systematic investigation of the microstructure of CrA1CxN1-x coatings as a function of carbon contents was conducted. Quaternary CrA1CxN1-x coatings were deposited on Si wafers by a hybrid coating system combining an arc-ion plating technique and a DC reactive magnetron sputtering technique using Cr and AI targets in the Ar/N2/CH4 gaseous mixture. The effect of carbon content on microstructure of CrA1C^N~ x coatings was investigated with instrumental analyses of X-ray diffraction, X-ray photoelectron, and high-resolution transmission electron microscopy. The results show that the carbon content of CrA1CxN1-x coatings linearly increases with increasing CH4/（CH4/N2） gas flow rate ratio. The surface roughness of the CrA1CxN1-x coating layer decreases with the increase of carbon content.展开更多
Aiming at acute characteristics of flammability,explosibility,causticity and leakiness of high sour natural gas,giving full consideration to local natural conditions in Sichuan Province and starting with purification ...Aiming at acute characteristics of flammability,explosibility,causticity and leakiness of high sour natural gas,giving full consideration to local natural conditions in Sichuan Province and starting with purification process,the paper analyzed process configurations,energy utilization and conservation,safety and environment protection measures. The integrated technology and engineering scheme for high sour natural gas purification was established and successfully used in industrial application.展开更多
The foaming phenomenon of N-methyldiethanolamine(MDEA) solution used in desulfurization process occurs frequently in the natural-gas purification plant. The foaming phenomenon has a strong impact on operation of the p...The foaming phenomenon of N-methyldiethanolamine(MDEA) solution used in desulfurization process occurs frequently in the natural-gas purification plant. The foaming phenomenon has a strong impact on operation of the process unit. The salt impurities are the main reason for causing the foaming of MDEA solution, so the full analysis of salt impurities is necessary. A method for comprehensive analysis of salt impurities in MDEA solution used in desulfurization process was established. Anions and non-metallic cations of MDEA solution were determined by different conditions of ion chromatograph, respectively. Metallic cations of the solution were detected by atomic absorption spectrophotometer with the N2O-C2H2 flame absorption. The analytical results of salt impurities in the desulfurization solution can provide a theoretical basis for an accurate analysis of the factors affecting the foaming of MDEA to unveil further control measures.展开更多
To deal with the exploitation difficulties of gas fields in Northeast Sichuan with deep marine strata, after researching the relative standards domestic and abroad extensively, summarizing and promoting the successful...To deal with the exploitation difficulties of gas fields in Northeast Sichuan with deep marine strata, after researching the relative standards domestic and abroad extensively, summarizing and promoting the successful experiences and failure lessons of project construction technology application scientifically, Sinopec has established an integrated technical standard system for the exploration and development of ultra deep and high sour gas fields. The system consists of 51 enterprise standards and covers 7 professions including geophysical prospecting, drilling, drilling log, well logging, gas formation test and production, sour gas gathering and transferring system, and HSE (health,safety,environment). It guides and guarantees the safe, high-quality and high-efficiency project construction effectively by means of enhancing the engineering design criterion, recommending the data processing and interpretation methods, identifying the requirements of operation and field inspection and standardizing the application of technical equipments.展开更多
On the Loess Plateau of China, a dry soil layer may form due to excess transpiration, leading to degradation of black locust(Robinia pseudoacacia) stands. In order to better manage projects involving black locust, thi...On the Loess Plateau of China, a dry soil layer may form due to excess transpiration, leading to degradation of black locust(Robinia pseudoacacia) stands. In order to better manage projects involving black locust, this study was intended to investigate the response of black locust transpiration rate to soil water availability as affected by meteorological factors using two representative soils(loamy clay and sandy loam) on the Loess Plateau. Four soil water contents were maintained for black locust seedlings grown in pots initially outdoors and then in a climate-controlled chamber, by either drying or irrigating the pots. In both environments, daily transpiration rates were related by a power function to air temperature and by a logistic function to reference evapotranspiration(ET0). Transpiration rates were more susceptible to changes in the meteorological conditions in the sandy loam than in the loamy clay soil. The transpiration rate in the well-watered treatment was greater for black locust grown in the sandy loam than in the loamy clay soil. Normalized transpiration rates were unaffected by ET0 until a critical value of soil water content(θc) was attained; the θc value decreased significantly for the loamy clay soil but increased significantly for the sandy loam soil when ET0 increased. These suggested that the effect of the meteorological condition on the transpiration characteristics of black locust was dependent on soil texture.展开更多
基金CSIRO Energy TechnologyChina Scholarship CouncilChina Fundamental Research Foundation for National University of China University of Geosciences (No.CUGL120258)
文摘Gas outbursts in underground mining occur under conditions of high gas desorption rate and gas content,combined with high stress regime, low coal strength and high Young's modulus. This combination of gas and stress factors occurs more often in deep mining. Hence, as the depth of mining increases, the potential for outburst increases. This study proposes a conceptual model to evaluate outburst potential in terms of an outburst indicator. The model was used to evaluate the potential for gas outburst in two mines, by comparing numerical simulations of gas flow behavior under typical stress regimes in an Australian gassy mine extracting a medium-volatile bituminous coal, and a Chinese gassy coal mine in Qinshui Basin(Shanxi province) extracting anthracite coal. We coupled the stress simulation program(FLAC3D) with the gas simulation program(SIMED II) to compute the stress and gas pressure and gas content distribution following development of a roadway into the targeted coal seams. The data from gas content and stress distribution were then used to quantify the intensity of energy release in the event of an outburst.
基金financial support from the National Key Science and Technology Project of China (2011ZX05017-005)the Fundamental Research Funds for the Central Universities (No.22A201514010)
文摘The desulfurization performance of the UDS solvents was investigated at an industrial side-stream plant and was compared with that of MDEA solvent.A mass transfer performance model was employed for explaining the COS absorption into different solvents.Meanwhile,the regeneration performance of the UDS solvents was evaluated in side-stream tests.Results indicate that under the conditions covering an absorption temperature of 40℃,a pressure of 8.0 MPa,and a gas to liquid volume ratio(V/L)of around 230,the H2S content in purified gas can be reduced to 4.2 mg/m3 and 0 by using solvents UDS-II and UDS-III,respectively.Moreover,the total sulfur content in both purified gases is less than 80 mg/m3.As a result,the UDS-III solvent shows by 30 percentage points higher in COS removal efficiency than MDEA.In addition,the total volume mass transfer coefficient of UDS solvent is found to be twice higher than that of MDEA.Furthermore,the UDS solvents exhibit satisfactory thermal stability and regeneration performance.
基金Project supported by a grant from the Fundamental R&D Program for Core Technology of Materials funded by the Ministry of Knowledge Economy, KoreaProject (2010-0001-226) supported by NCRC(National Core Research Center) Program through the National Research Foundation of Korea funded by the Ministry of Education, Science and Technology
文摘A systematic investigation of the microstructure of CrA1CxN1-x coatings as a function of carbon contents was conducted. Quaternary CrA1CxN1-x coatings were deposited on Si wafers by a hybrid coating system combining an arc-ion plating technique and a DC reactive magnetron sputtering technique using Cr and AI targets in the Ar/N2/CH4 gaseous mixture. The effect of carbon content on microstructure of CrA1C^N~ x coatings was investigated with instrumental analyses of X-ray diffraction, X-ray photoelectron, and high-resolution transmission electron microscopy. The results show that the carbon content of CrA1CxN1-x coatings linearly increases with increasing CH4/（CH4/N2） gas flow rate ratio. The surface roughness of the CrA1CxN1-x coating layer decreases with the increase of carbon content.
文摘Aiming at acute characteristics of flammability,explosibility,causticity and leakiness of high sour natural gas,giving full consideration to local natural conditions in Sichuan Province and starting with purification process,the paper analyzed process configurations,energy utilization and conservation,safety and environment protection measures. The integrated technology and engineering scheme for high sour natural gas purification was established and successfully used in industrial application.
基金Financial support received from the Major National Science and Technology Projects of China (No. 2011ZX05017)SWPU Science & Technology Innovation Youth Team for Pollution Control of Oil & Gas Fields (No. 2013XJZT003)
文摘The foaming phenomenon of N-methyldiethanolamine(MDEA) solution used in desulfurization process occurs frequently in the natural-gas purification plant. The foaming phenomenon has a strong impact on operation of the process unit. The salt impurities are the main reason for causing the foaming of MDEA solution, so the full analysis of salt impurities is necessary. A method for comprehensive analysis of salt impurities in MDEA solution used in desulfurization process was established. Anions and non-metallic cations of MDEA solution were determined by different conditions of ion chromatograph, respectively. Metallic cations of the solution were detected by atomic absorption spectrophotometer with the N2O-C2H2 flame absorption. The analytical results of salt impurities in the desulfurization solution can provide a theoretical basis for an accurate analysis of the factors affecting the foaming of MDEA to unveil further control measures.
文摘To deal with the exploitation difficulties of gas fields in Northeast Sichuan with deep marine strata, after researching the relative standards domestic and abroad extensively, summarizing and promoting the successful experiences and failure lessons of project construction technology application scientifically, Sinopec has established an integrated technical standard system for the exploration and development of ultra deep and high sour gas fields. The system consists of 51 enterprise standards and covers 7 professions including geophysical prospecting, drilling, drilling log, well logging, gas formation test and production, sour gas gathering and transferring system, and HSE (health,safety,environment). It guides and guarantees the safe, high-quality and high-efficiency project construction effectively by means of enhancing the engineering design criterion, recommending the data processing and interpretation methods, identifying the requirements of operation and field inspection and standardizing the application of technical equipments.
基金supported by the National Natural Science Foundation of China(Nos.41171186 and 41101206)
文摘On the Loess Plateau of China, a dry soil layer may form due to excess transpiration, leading to degradation of black locust(Robinia pseudoacacia) stands. In order to better manage projects involving black locust, this study was intended to investigate the response of black locust transpiration rate to soil water availability as affected by meteorological factors using two representative soils(loamy clay and sandy loam) on the Loess Plateau. Four soil water contents were maintained for black locust seedlings grown in pots initially outdoors and then in a climate-controlled chamber, by either drying or irrigating the pots. In both environments, daily transpiration rates were related by a power function to air temperature and by a logistic function to reference evapotranspiration(ET0). Transpiration rates were more susceptible to changes in the meteorological conditions in the sandy loam than in the loamy clay soil. The transpiration rate in the well-watered treatment was greater for black locust grown in the sandy loam than in the loamy clay soil. Normalized transpiration rates were unaffected by ET0 until a critical value of soil water content(θc) was attained; the θc value decreased significantly for the loamy clay soil but increased significantly for the sandy loam soil when ET0 increased. These suggested that the effect of the meteorological condition on the transpiration characteristics of black locust was dependent on soil texture.
