Lubricating mineral base oils are normally extracted from lube-oil cuts with furfural solvent.Aromatic content in the raffinate phase from extraction process is an essential parameter that affects the quality of the l...Lubricating mineral base oils are normally extracted from lube-oil cuts with furfural solvent.Aromatic content in the raffinate phase from extraction process is an essential parameter that affects the quality of the lubricating base-oils.For determination of aromatic content by the usual ASTM D3238 method,density,refractive index and molecular weight of the raffinate are required.In this work,a new generalized correlation is developed for de-termination the aromatic content by using only the measured viscosity of lubricating oil.With a mole fraction of aromatic compounds,the kinematic viscosity may be obtained at any temperature between 60-100°C along with their molecular weight and refractive index.展开更多
Based on analyses of the components of crude oil hydrocarbons and carbon isotopes,the content of normal alkane decreased from 49.00% to 20.10% when moving from the No.3 to No.5 tectonic belt of the Lenghu area of the ...Based on analyses of the components of crude oil hydrocarbons and carbon isotopes,the content of normal alkane decreased from 49.00% to 20.10% when moving from the No.3 to No.5 tectonic belt of the Lenghu area of the Qaidam Basin,while cycloalkanes increased from 30.00% to 52.20% and aromatic and branch chain alkanes increased gradually as well. The maturity of sterane in crude oil is higher than that of its source-rock,which shows that the hydrocarbons were generated from a deep source-rock of high maturity around the tectonic belts of the Lenghu area. The analysis of the characteristics of carbon isotopes also shows that these isotopes of hydrocarbon compounds in the No.4 and No.5 tectonic belt are apparently heavier than those in the No.3 belt. The results of our research show that the hydrocarbons in the No.3 tectonic belt are mainly from a relatively rich sapropelic substance,while the hydrocarbons in the No.4 and No.5 tectonic belt originated mainly from organic matter of a relatively rich humic type substance.展开更多
The effects of operating conditions on the distribution of olefins in the FCC gasoline, obtained during catalytic cracking reaction in the presence of the GOR-Q catalyst and conventional MLC-500 catalyst, have been st...The effects of operating conditions on the distribution of olefins in the FCC gasoline, obtained during catalytic cracking reaction in the presence of the GOR-Q catalyst and conventional MLC-500 catalyst, have been studied in detail. The test results showed that the GOR-Q catalyst could obviously reduce the content of several kinds of olefins in FCC gasoline. Olefins in the FCC gasoline consist mainly of C5- C7 compounds, that are composed of C=C bond with normal or mono- branched chains. The reduction of gasoline olefin content could be achieved by decreasing the content of above-mentioned olefins. Lower reaction temperature, lower weight hourly space velocity （WHSV） and higher catalyst to oil ratio would help to reduce the content of olefins with a C = C double bond, normal olefins, mono-branched-chain olefins and diolefins. To decrease the loss of gasoline octane number, the operation for olefin reduction should be firstly focused on increasing the catalyst to oil ratio.展开更多
In order to reduce the olefin content in gasoline manufactured by the MGG （Maximizing Liquefied Gas and Gasoline） process while retaining the LPG yield, RIPP has developed a novel catalyst consisting of a more pore-...In order to reduce the olefin content in gasoline manufactured by the MGG （Maximizing Liquefied Gas and Gasoline） process while retaining the LPG yield, RIPP has developed a novel catalyst consisting of a more pore-opened matrix and the modified Y-zeolite and the ZRP zeolite modified with metal oxides. Test results have revealed that compared with the commercial catalyst RAG under comparable reaction conditions the reaction conversion rate and product distribution provided by the novel catalyst were similar, but the olefin content in gasoline obtained thereof was decreased with the octane rating unchanged along with a slight reduction of olefin content in the LPG fraction. The hydrothermal stability of the novel catalyst was better than the commercial catalyst RAG.展开更多
A number of mud volcanoes exist in the southern Junggar Basin. To date few systematic studies on natural gas geochemistry of mud volcanoes have been conducted in China. In June 1991 and August 2010, the authors invest...A number of mud volcanoes exist in the southern Junggar Basin. To date few systematic studies on natural gas geochemistry of mud volcanoes have been conducted in China. In June 1991 and August 2010, the authors investigated the mud volcanoes in the southern Junggar Basin twice, and the mud volcanism weakened gradually as seen from the variations such as the decrease of gas pressure and output, the downthrow and dry up of the mud pool. The volcanic intensity was significantly weaker than that in Taiwan. The natural gas from the mud volcanoes in the southern Junggar Basin has similar geochemical characteristics, indicating the same source or origin. The main component of the mud volcano gas is alkane gas with contents of 91.15%-97.49%, and the gas is high-quality commercial gas since methane dominates in the alkane. The 513C1 values are -49.1‰-0.6‰, which are in accordance with the peak δ3C1 frequency of mud volcano gas around the world, and the alkane gas displays positive carbon isotopic series, i.e., δ3C1〈δ3C2〈δ13C3, suggesting typical thermogenic origin. The helium in the mud volcano gas is typically crust-derived due to the low R/Ra values of 0.011-0.054. The mud volcano gas is coal-derived since the δ13C2 values are all greater than -28‰, and C1/C1-4 and δ13C1 values are in accordance with those of natural gas derived from the Lower-Middle Jurassic coal-measures. Therefore, alkane gas from mud volcanoes in the southern Junggar Basin is mainly sourced from the Lower-Middle Jurassic coal-measures.展开更多
文摘Lubricating mineral base oils are normally extracted from lube-oil cuts with furfural solvent.Aromatic content in the raffinate phase from extraction process is an essential parameter that affects the quality of the lubricating base-oils.For determination of aromatic content by the usual ASTM D3238 method,density,refractive index and molecular weight of the raffinate are required.In this work,a new generalized correlation is developed for de-termination the aromatic content by using only the measured viscosity of lubricating oil.With a mole fraction of aromatic compounds,the kinematic viscosity may be obtained at any temperature between 60-100°C along with their molecular weight and refractive index.
基金Project 2009011 supported by the Resource Exploration Projects of the Ministry of Land and Resources of Chinathe State Key Laboratory of Petroleum Resource and Prospecting of China Petroleum University (Beijing)
文摘Based on analyses of the components of crude oil hydrocarbons and carbon isotopes,the content of normal alkane decreased from 49.00% to 20.10% when moving from the No.3 to No.5 tectonic belt of the Lenghu area of the Qaidam Basin,while cycloalkanes increased from 30.00% to 52.20% and aromatic and branch chain alkanes increased gradually as well. The maturity of sterane in crude oil is higher than that of its source-rock,which shows that the hydrocarbons were generated from a deep source-rock of high maturity around the tectonic belts of the Lenghu area. The analysis of the characteristics of carbon isotopes also shows that these isotopes of hydrocarbon compounds in the No.4 and No.5 tectonic belt are apparently heavier than those in the No.3 belt. The results of our research show that the hydrocarbons in the No.3 tectonic belt are mainly from a relatively rich sapropelic substance,while the hydrocarbons in the No.4 and No.5 tectonic belt originated mainly from organic matter of a relatively rich humic type substance.
文摘The effects of operating conditions on the distribution of olefins in the FCC gasoline, obtained during catalytic cracking reaction in the presence of the GOR-Q catalyst and conventional MLC-500 catalyst, have been studied in detail. The test results showed that the GOR-Q catalyst could obviously reduce the content of several kinds of olefins in FCC gasoline. Olefins in the FCC gasoline consist mainly of C5- C7 compounds, that are composed of C=C bond with normal or mono- branched chains. The reduction of gasoline olefin content could be achieved by decreasing the content of above-mentioned olefins. Lower reaction temperature, lower weight hourly space velocity （WHSV） and higher catalyst to oil ratio would help to reduce the content of olefins with a C = C double bond, normal olefins, mono-branched-chain olefins and diolefins. To decrease the loss of gasoline octane number, the operation for olefin reduction should be firstly focused on increasing the catalyst to oil ratio.
文摘In order to reduce the olefin content in gasoline manufactured by the MGG （Maximizing Liquefied Gas and Gasoline） process while retaining the LPG yield, RIPP has developed a novel catalyst consisting of a more pore-opened matrix and the modified Y-zeolite and the ZRP zeolite modified with metal oxides. Test results have revealed that compared with the commercial catalyst RAG under comparable reaction conditions the reaction conversion rate and product distribution provided by the novel catalyst were similar, but the olefin content in gasoline obtained thereof was decreased with the octane rating unchanged along with a slight reduction of olefin content in the LPG fraction. The hydrothermal stability of the novel catalyst was better than the commercial catalyst RAG.
文摘A number of mud volcanoes exist in the southern Junggar Basin. To date few systematic studies on natural gas geochemistry of mud volcanoes have been conducted in China. In June 1991 and August 2010, the authors investigated the mud volcanoes in the southern Junggar Basin twice, and the mud volcanism weakened gradually as seen from the variations such as the decrease of gas pressure and output, the downthrow and dry up of the mud pool. The volcanic intensity was significantly weaker than that in Taiwan. The natural gas from the mud volcanoes in the southern Junggar Basin has similar geochemical characteristics, indicating the same source or origin. The main component of the mud volcano gas is alkane gas with contents of 91.15%-97.49%, and the gas is high-quality commercial gas since methane dominates in the alkane. The 513C1 values are -49.1‰-0.6‰, which are in accordance with the peak δ3C1 frequency of mud volcano gas around the world, and the alkane gas displays positive carbon isotopic series, i.e., δ3C1〈δ3C2〈δ13C3, suggesting typical thermogenic origin. The helium in the mud volcano gas is typically crust-derived due to the low R/Ra values of 0.011-0.054. The mud volcano gas is coal-derived since the δ13C2 values are all greater than -28‰, and C1/C1-4 and δ13C1 values are in accordance with those of natural gas derived from the Lower-Middle Jurassic coal-measures. Therefore, alkane gas from mud volcanoes in the southern Junggar Basin is mainly sourced from the Lower-Middle Jurassic coal-measures.
