Objectives:This study aimed to evaluate the effectiveness of slow deep breathing relaxation exercise(SDBRE)in reducing patients’pain levels during chest tube removal(CTR)post coronary artery bypass grafting(CABG)surg...Objectives:This study aimed to evaluate the effectiveness of slow deep breathing relaxation exercise(SDBRE)in reducing patients’pain levels during chest tube removal(CTR)post coronary artery bypass grafting(CABG)surgery.Methods:In 2019,fifty post-CABG patients were conveniently selected from a cardiac intensive care unit in Jordan’s major referral heart institute.The patients were randomly assigned to either an intervention group or a control group.A total of 25 patients were assigned into the experimental group who received slow deep breathing relaxation Exercise(SDBRE)alongside the conventional care before CTR.The remaining 25 patients constituted the control group(50%)that had CTR following conventional care.The Visual Analogue Scale(VAS)was used to measure the participants’pain levels during three phases:before CTR(Time 1),5-min post CTR(Time 2),and 15-min post CTR(Time 2)to compare the intervention effect between the two groups.Results:The data analysis findings for the control and intervention group of patients showed that there was a statistically significant decline in their pain level across time for both groups(H¼32.71,P<0.01;H=47.23,P<0.01)respectively.The intervention group had significantly lower pain levels than the control group at Time 2(3.50[1.20,5.30]vs.7.90[7.00,9.00],P<0.01)and Time 3(0.00[0.00,1.30]vs.3.60[2.40,4.10]P<0.01).Conclusions:Using SDBRE during CTR is an effective technique for reducing pain which can minimize the need for analgesics and their associated adverse effects.展开更多
In longwall mines, atmospheric pressure fluctuations can disturb the pressure balance between the gob and the ventilated working area, resulting in a phenomenon known as ‘‘gob breathing". Gob breathing triggers...In longwall mines, atmospheric pressure fluctuations can disturb the pressure balance between the gob and the ventilated working area, resulting in a phenomenon known as ‘‘gob breathing". Gob breathing triggers gas flows across the gob and the working areas and may result in a condition where an oxygen deficient mixture or a methane accumulation in the gob flows into the face area. Computational Fluid Dynamics(CFDs) modeling was carried out to analyze this phenomenon and its impact on the development of an explosive mixture in a bleeder-ventilated panel scheme. Simulation results indicate that the outgassing and ingassing across the gob and the formation of Explosive Gas Zones(EGZs) are directly affected by atmospheric pressure changes. In the location where methane zones interface with mine air, EGZ fringes may form along the face and in the bleeder entries. These findings help assess the methane ignition and explosion risks associated with fluctuating atmospheric pressures.展开更多
To investigate airflow pattern and its impact on particle deposition, finite-volume based computational fluid dynamics （CFD） simulations were conducted in the diseased triple-bifitrcation airways. Computations were ...To investigate airflow pattern and its impact on particle deposition, finite-volume based computational fluid dynamics （CFD） simulations were conducted in the diseased triple-bifitrcation airways. Computations were carried out for twenty Reynolds numbers ranging from 100 to 2 000 in the step of 100. Particles in the size range of 1-10 μm were conducted. Two particle deposition mechanisms （gravitational sedimentation and inertial impaction） were considered. The results indicate that there are strong relationship between airflow structures and particle deposition patterns. Deposition efficiency is different for different particles in the whole range of the respiratory rates. Particles in different sizes can deposit at different sites. Smaller particles can be uniformly deposited at the inside wall of the considered model. Larger particles can be mainly deposited in the proximal bifurcations. Deposition fraction varies a lot for different inlet Reynolds numbers. For lower Reynolds numbers, deposition fraction is relatively small and varies a little with varying the diameters. For Reynolds number to target the aerosols at the specific site. higher Reynolds numbers, there is a most efficient diameter for each展开更多
文摘Objectives:This study aimed to evaluate the effectiveness of slow deep breathing relaxation exercise(SDBRE)in reducing patients’pain levels during chest tube removal(CTR)post coronary artery bypass grafting(CABG)surgery.Methods:In 2019,fifty post-CABG patients were conveniently selected from a cardiac intensive care unit in Jordan’s major referral heart institute.The patients were randomly assigned to either an intervention group or a control group.A total of 25 patients were assigned into the experimental group who received slow deep breathing relaxation Exercise(SDBRE)alongside the conventional care before CTR.The remaining 25 patients constituted the control group(50%)that had CTR following conventional care.The Visual Analogue Scale(VAS)was used to measure the participants’pain levels during three phases:before CTR(Time 1),5-min post CTR(Time 2),and 15-min post CTR(Time 2)to compare the intervention effect between the two groups.Results:The data analysis findings for the control and intervention group of patients showed that there was a statistically significant decline in their pain level across time for both groups(H¼32.71,P<0.01;H=47.23,P<0.01)respectively.The intervention group had significantly lower pain levels than the control group at Time 2(3.50[1.20,5.30]vs.7.90[7.00,9.00],P<0.01)and Time 3(0.00[0.00,1.30]vs.3.60[2.40,4.10]P<0.01).Conclusions:Using SDBRE during CTR is an effective technique for reducing pain which can minimize the need for analgesics and their associated adverse effects.
基金the financial support of the National Institute for Occupational Safety and Health–United States(No.211-2014-60050)
文摘In longwall mines, atmospheric pressure fluctuations can disturb the pressure balance between the gob and the ventilated working area, resulting in a phenomenon known as ‘‘gob breathing". Gob breathing triggers gas flows across the gob and the working areas and may result in a condition where an oxygen deficient mixture or a methane accumulation in the gob flows into the face area. Computational Fluid Dynamics(CFDs) modeling was carried out to analyze this phenomenon and its impact on the development of an explosive mixture in a bleeder-ventilated panel scheme. Simulation results indicate that the outgassing and ingassing across the gob and the formation of Explosive Gas Zones(EGZs) are directly affected by atmospheric pressure changes. In the location where methane zones interface with mine air, EGZ fringes may form along the face and in the bleeder entries. These findings help assess the methane ignition and explosion risks associated with fluctuating atmospheric pressures.
基金Project(51178466) supported by the National Natural Science Foundation of ChinaProject(200545) supported by the Foundation for the Author of National Excellent Doctoral Dissertation of ChinaProject(2011JQ006) supported by the Fundamental Research Funds of the Central Universities of China
文摘To investigate airflow pattern and its impact on particle deposition, finite-volume based computational fluid dynamics （CFD） simulations were conducted in the diseased triple-bifitrcation airways. Computations were carried out for twenty Reynolds numbers ranging from 100 to 2 000 in the step of 100. Particles in the size range of 1-10 μm were conducted. Two particle deposition mechanisms （gravitational sedimentation and inertial impaction） were considered. The results indicate that there are strong relationship between airflow structures and particle deposition patterns. Deposition efficiency is different for different particles in the whole range of the respiratory rates. Particles in different sizes can deposit at different sites. Smaller particles can be uniformly deposited at the inside wall of the considered model. Larger particles can be mainly deposited in the proximal bifurcations. Deposition fraction varies a lot for different inlet Reynolds numbers. For lower Reynolds numbers, deposition fraction is relatively small and varies a little with varying the diameters. For Reynolds number to target the aerosols at the specific site. higher Reynolds numbers, there is a most efficient diameter for each
