Dry jet mixing (DJM) for soft soil stabilization has been widely used since 1980s. The quality and strength of stabilized columns are fundamental parameters to evaluate the stabilization work. This paper presents the ...Dry jet mixing (DJM) for soft soil stabilization has been widely used since 1980s. The quality and strength of stabilized columns are fundamental parameters to evaluate the stabilization work. This paper presents the standard penetration test (SPT) method and its test results on cement columns. It is shown that SPT is an effective and simple method for inspecting and evaluating cement columns. The strength characteristics along the length of the column, a good correction between SPT blow count and the unconfined compressive strength are achieved.展开更多
Hydraulic slotting in a gas drainage borehole is an effective method of enhancing gas drainage perfor- mance. However, it frequently occurs that a large amount of slotting products （mainly the coal slurry and gas） i...Hydraulic slotting in a gas drainage borehole is an effective method of enhancing gas drainage perfor- mance. However, it frequently occurs that a large amount of slotting products （mainly the coal slurry and gas） intensely spurt out of the borehole during the slotting, which adversely affects the slotting efficiency. Despite extensive previous investigations on the mechanism and prevention-device design of the spurt during ordinary borehole drilling, a very few studies has focused on the spurt in the s Ottlng pro ] ＂ _ cess. The slotting spurt is mainly caused by two reasons： the coal and gas outburst in the borehole and the borehole deslagging blockage. This paper focuses on the second reason, and investigates the hydraulic deslagging flow patterns in the annular space between the drill pipe and borehole wall Results show that there are six deslagging flow patterns when the drill pipe is still： pure slurry flow, pure gas flow, bubble flow, intermittent flow, layering flow and annular flow. When the drill pipe rotates, each of those six flow patterns changes due to the Taylor vortex effect. Outcomes of this study could help to better understand the slotting-spurt mechanism and provide guidance on the anti-spurt strategies through eliminating the borehole deslagging blockage.展开更多
The cement dry jet mixing method has been used to reinforce soft cohesive ground to increase the strength of soft cohesive ground and to decrease its deformation. The study briefly introduces the curing mechanism of c...The cement dry jet mixing method has been used to reinforce soft cohesive ground to increase the strength of soft cohesive ground and to decrease its deformation. The study briefly introduces the curing mechanism of cement-soil,presents the factors of influencing on compressive strength,mainly analyses the factors including cement mixing ratio,cement strength grade,curing age,moisture content and soil texture and puts forward some rational proposals at last.展开更多
The an thors developed a new composite cement base material by mixing the high tenacity polypropylene （coarse） fiber in plain cement base for the cement-layer-spray technology. By studying the key parameters of the ...The an thors developed a new composite cement base material by mixing the high tenacity polypropylene （coarse） fiber in plain cement base for the cement-layer-spray technology. By studying the key parameters of the fiber dosage, the spray layer thickness, and the fiber reinforced concrete injection time, etc. It is found that the ideal volume ratio of polypropylene （crude） fiber is 0.8% （V/V）, and the secondary lining fiber concrete spraying should start when the shrinkage rate is lower than 0.5 mm/d, and the optimal thickness of shotcrete is 120 mm. The supporting effects and the economic benefits were studied using a real project practice, and the result obtained can be a good reference for practical applications of this new supporting material in the future.展开更多
This study aims to evaluate the presence of free chlorides by the silver nitrate colorimetric spraying method in mortars made with Portland cement CP II Z-32. In order to make an assessment beyond the qualitative anal...This study aims to evaluate the presence of free chlorides by the silver nitrate colorimetric spraying method in mortars made with Portland cement CP II Z-32. In order to make an assessment beyond the qualitative analysis, a calculation of the contaminated areas by free chlorides was performed by measuring the regions using a computer image analysis software （IMAGEJ）. The experimental part of the research involved samples of 5 cm x 10 cm of mortar and 0.1 M solution of silver nitrate in distilled water. The mortar samples were made with cement CP II Z-32 with the following concentrations of chloride incorporated into the mixing water： 0%0, 0.4%, 0.6%, 0.8%, 1.0% and 2.0%, in relation to the mass of cement, totaling 108 samples. The average of percentage results from the contaminated area of the series of samples was respectively 0%, 14.9694%, 19.7444%, 46.0239%, 62.3311% and 96.0083% in relation to the total area, concluding that the method of silver nitrate spraying is applicable and that the white color indicates the presence of chloride ions and other possible aggressive salts to the structure or the concrete.展开更多
Three types of nozzles: a low-pressure multistage nozzle, an effervescent nozzle and a newly developed internal- mixing air-blast nozzle, for atomization of Coal-Water Slurry (CWS) were investigated. Influence of CWS ...Three types of nozzles: a low-pressure multistage nozzle, an effervescent nozzle and a newly developed internal- mixing air-blast nozzle, for atomization of Coal-Water Slurry (CWS) were investigated. Influence of CWS properties including surface tension and apparent viscosity on atomization was studied. Comparisons among the nozzles were carried out in terms of spray droplet mean diameter and fuel output. Versatility of each nozzle was investigated and atomization mechanism of each nozzle was analyzed as well. The results showed that the newly developed internal- mixing air-blast nozzle has high fuel output and small mean droplet size in the spray, but the multistage nozzle has high versatility for handling of low quality CWS.展开更多
文摘Dry jet mixing (DJM) for soft soil stabilization has been widely used since 1980s. The quality and strength of stabilized columns are fundamental parameters to evaluate the stabilization work. This paper presents the standard penetration test (SPT) method and its test results on cement columns. It is shown that SPT is an effective and simple method for inspecting and evaluating cement columns. The strength characteristics along the length of the column, a good correction between SPT blow count and the unconfined compressive strength are achieved.
文摘Hydraulic slotting in a gas drainage borehole is an effective method of enhancing gas drainage perfor- mance. However, it frequently occurs that a large amount of slotting products （mainly the coal slurry and gas） intensely spurt out of the borehole during the slotting, which adversely affects the slotting efficiency. Despite extensive previous investigations on the mechanism and prevention-device design of the spurt during ordinary borehole drilling, a very few studies has focused on the spurt in the s Ottlng pro ] ＂ _ cess. The slotting spurt is mainly caused by two reasons： the coal and gas outburst in the borehole and the borehole deslagging blockage. This paper focuses on the second reason, and investigates the hydraulic deslagging flow patterns in the annular space between the drill pipe and borehole wall Results show that there are six deslagging flow patterns when the drill pipe is still： pure slurry flow, pure gas flow, bubble flow, intermittent flow, layering flow and annular flow. When the drill pipe rotates, each of those six flow patterns changes due to the Taylor vortex effect. Outcomes of this study could help to better understand the slotting-spurt mechanism and provide guidance on the anti-spurt strategies through eliminating the borehole deslagging blockage.
文摘The cement dry jet mixing method has been used to reinforce soft cohesive ground to increase the strength of soft cohesive ground and to decrease its deformation. The study briefly introduces the curing mechanism of cement-soil,presents the factors of influencing on compressive strength,mainly analyses the factors including cement mixing ratio,cement strength grade,curing age,moisture content and soil texture and puts forward some rational proposals at last.
文摘The an thors developed a new composite cement base material by mixing the high tenacity polypropylene （coarse） fiber in plain cement base for the cement-layer-spray technology. By studying the key parameters of the fiber dosage, the spray layer thickness, and the fiber reinforced concrete injection time, etc. It is found that the ideal volume ratio of polypropylene （crude） fiber is 0.8% （V/V）, and the secondary lining fiber concrete spraying should start when the shrinkage rate is lower than 0.5 mm/d, and the optimal thickness of shotcrete is 120 mm. The supporting effects and the economic benefits were studied using a real project practice, and the result obtained can be a good reference for practical applications of this new supporting material in the future.
文摘This study aims to evaluate the presence of free chlorides by the silver nitrate colorimetric spraying method in mortars made with Portland cement CP II Z-32. In order to make an assessment beyond the qualitative analysis, a calculation of the contaminated areas by free chlorides was performed by measuring the regions using a computer image analysis software （IMAGEJ）. The experimental part of the research involved samples of 5 cm x 10 cm of mortar and 0.1 M solution of silver nitrate in distilled water. The mortar samples were made with cement CP II Z-32 with the following concentrations of chloride incorporated into the mixing water： 0%0, 0.4%, 0.6%, 0.8%, 1.0% and 2.0%, in relation to the mass of cement, totaling 108 samples. The average of percentage results from the contaminated area of the series of samples was respectively 0%, 14.9694%, 19.7444%, 46.0239%, 62.3311% and 96.0083% in relation to the total area, concluding that the method of silver nitrate spraying is applicable and that the white color indicates the presence of chloride ions and other possible aggressive salts to the structure or the concrete.
文摘Three types of nozzles: a low-pressure multistage nozzle, an effervescent nozzle and a newly developed internal- mixing air-blast nozzle, for atomization of Coal-Water Slurry (CWS) were investigated. Influence of CWS properties including surface tension and apparent viscosity on atomization was studied. Comparisons among the nozzles were carried out in terms of spray droplet mean diameter and fuel output. Versatility of each nozzle was investigated and atomization mechanism of each nozzle was analyzed as well. The results showed that the newly developed internal- mixing air-blast nozzle has high fuel output and small mean droplet size in the spray, but the multistage nozzle has high versatility for handling of low quality CWS.
