The 3-D ECOMSED ocean model was applied to establish a time-dependent boundary model for Jiaozhou Bay (JZB), in which the operator-splitting technique was used and the ‘dry and wet’ method was introduced. The influe...The 3-D ECOMSED ocean model was applied to establish a time-dependent boundary model for Jiaozhou Bay (JZB), in which the operator-splitting technique was used and the ‘dry and wet’ method was introduced. The influence caused by JZB reclamation on the surface level, residual currents, tidal system and tidal energy of M2 tidal system were predicted and analyzed. The results show that JZB reclamation has slight impact on the M2 tidal system, in which the variation of amplitude and phase is less than 1%.The changes of the currents and residual currents in Qian Bay and near the reclamation areas are greater, but in other areas the changes are smaller, in which the currents have a change of around 1%, while the residual currents change ranges from 1.82%–9.61%. After reclamation, the tidal energy fluxes increase by 2.62%–5.24% inside and outside the JZB mouth, but decrease by 20.21%–87.23% near Qian Bay and the reclamation area.展开更多
In Morocco, the phosphate industry generates by washing during the ore beneficiation in humid way, big quantities of sludge loaded in fine mineral particles （or slimes） with contents of water in the order of 90-95%....In Morocco, the phosphate industry generates by washing during the ore beneficiation in humid way, big quantities of sludge loaded in fine mineral particles （or slimes） with contents of water in the order of 90-95%. The specific consumption in water for the beneficiation of one tone of dry ore is approximately 0.6 m3. The management of this sludge and the recycling of process water are played to a schema of solid-liquid separation by flocculation, settling then stocking in basins of several dozens hectares. Recovered clear waters are recycled into the circuit of washing. The principal motivation of this work which is a part of EL MAA project is dedicated to the study of the impact of the speed of agitation on the flocculation behavior in terms of dewatering of the phosphate slimes and recycling of the process water. Study was driven on sample of slimes taken in entrance of the thickeners of a Moroccan washing plants, before flocculation. The raw slimes have a concentration in solid of 75.5 g·L^-1, a P205 grade of 17.3% and a free settling velocity 9 cm·h^-1. Fine fraction -2 μm, responsible for the poor settling of slimes is composed in practice of nearly 96% of smectite. It represents 9% of the dry solid content in the slimes. Measurements reveal important variations of the granulometric and textural properties of large floes in response to flocculation, opening ways of optimization for the velocity gradient.展开更多
The paper shows a method of designing a heat exchanger recovering heat from the condensation of water vapour contained in flue gases. A heat exchanger condenses water vapour and SO2 （sulphur dioxide） in the presence...The paper shows a method of designing a heat exchanger recovering heat from the condensation of water vapour contained in flue gases. A heat exchanger condenses water vapour and SO2 （sulphur dioxide） in the presence of inert gases （CO2, CO, N2, O2） contained in flue gases. A mathematical model and a sample design of a heat exchanger were presented. The heat exchange is capable of recovering from a dozen or so to several dozen percent of heat from flue gases escaping into the atmosphere. A second advantage of the heat exchanger is the possibility to reduce the emissions of SO2 considerably. Depending on the parameters, it can be even a sevenfold reduction in the emissions. The main mathematical tool used for designing the condensing heat exchanger is the Colburn-Hougen method. The authors omitted that part of the method which requires iterative calculations. The Mollier diagram was used instead.展开更多
文摘The 3-D ECOMSED ocean model was applied to establish a time-dependent boundary model for Jiaozhou Bay (JZB), in which the operator-splitting technique was used and the ‘dry and wet’ method was introduced. The influence caused by JZB reclamation on the surface level, residual currents, tidal system and tidal energy of M2 tidal system were predicted and analyzed. The results show that JZB reclamation has slight impact on the M2 tidal system, in which the variation of amplitude and phase is less than 1%.The changes of the currents and residual currents in Qian Bay and near the reclamation areas are greater, but in other areas the changes are smaller, in which the currents have a change of around 1%, while the residual currents change ranges from 1.82%–9.61%. After reclamation, the tidal energy fluxes increase by 2.62%–5.24% inside and outside the JZB mouth, but decrease by 20.21%–87.23% near Qian Bay and the reclamation area.
文摘In Morocco, the phosphate industry generates by washing during the ore beneficiation in humid way, big quantities of sludge loaded in fine mineral particles （or slimes） with contents of water in the order of 90-95%. The specific consumption in water for the beneficiation of one tone of dry ore is approximately 0.6 m3. The management of this sludge and the recycling of process water are played to a schema of solid-liquid separation by flocculation, settling then stocking in basins of several dozens hectares. Recovered clear waters are recycled into the circuit of washing. The principal motivation of this work which is a part of EL MAA project is dedicated to the study of the impact of the speed of agitation on the flocculation behavior in terms of dewatering of the phosphate slimes and recycling of the process water. Study was driven on sample of slimes taken in entrance of the thickeners of a Moroccan washing plants, before flocculation. The raw slimes have a concentration in solid of 75.5 g·L^-1, a P205 grade of 17.3% and a free settling velocity 9 cm·h^-1. Fine fraction -2 μm, responsible for the poor settling of slimes is composed in practice of nearly 96% of smectite. It represents 9% of the dry solid content in the slimes. Measurements reveal important variations of the granulometric and textural properties of large floes in response to flocculation, opening ways of optimization for the velocity gradient.
文摘The paper shows a method of designing a heat exchanger recovering heat from the condensation of water vapour contained in flue gases. A heat exchanger condenses water vapour and SO2 （sulphur dioxide） in the presence of inert gases （CO2, CO, N2, O2） contained in flue gases. A mathematical model and a sample design of a heat exchanger were presented. The heat exchange is capable of recovering from a dozen or so to several dozen percent of heat from flue gases escaping into the atmosphere. A second advantage of the heat exchanger is the possibility to reduce the emissions of SO2 considerably. Depending on the parameters, it can be even a sevenfold reduction in the emissions. The main mathematical tool used for designing the condensing heat exchanger is the Colburn-Hougen method. The authors omitted that part of the method which requires iterative calculations. The Mollier diagram was used instead.
