土工有限元计算中如何剔除先期固结变形

土体在重力作用下的固结变形历史上大多已经完成,土体内的自重应力场和重力场处于相互平衡状态。以此为初始条件的土工有限元计算,如果直接在模型上施加重力作外载,将产生一个较大固结变形,而这个变形对土体来说是先期完成了的,所以计算会产生不合理的结果。为此,先把初应力作为一种载荷进行理论推导,并据此提出一个如何剔除先期固结变形的方法,即先加重力,通过求解,导出土体自重应力场;然后重新开始分析,把自重应力场当初始应力导入土体单元中,再加重力进行求解,这样就剔除了先期固结变形;最后进行了算例对比分析,证明其是一种合理的方法。

土工有限元中弹塑性分析的实现

为了实现土工有限元的弹塑性分析 ,文章讨论了在Super-Sap中如何实现弹塑性分析的方法 ,重点介绍了利用现成的Super-Sap有限元软件和三维弹塑性有限元计算程序对岩土类材料实现弹塑性分析的原理与步骤。计算实例表明 。

ANALYSIS OF GEOSYNTHETICS REINFORCED EMBANKMENT ON SOFT SOIL BY FEM

The reinforcement effects of geosynthetics in thick soft subsoil case and thin soft subsoil case are studied in this paper,and a Duncan Chang nonlinear numerical model based on the finite element method (FEM) is developed.Moreover,an important conclusion that the thickness of soft subsoil affects greatly the geotechnical behavior of geosynthetic reinforced embankments is drawn.A series of embankment built on soft subsoil is calculated using the FEM program.The results of the computer program,such as the lateral displacements,settlements,and stress level and shear stresses in the subsoil,are presented in great detail and the comparison of those results disposes clearly the huge discrepancy of reinforce benefit between the thick subsoil embankment and thin subsoil embankment.Reinforcement mechanism of geosynthetics is also discussed in this paper and several conclusions are reached.This paper also gives recommendations for design.

A case study of seismic response of earth embankment foundation on liquefiable soils

A case study of seismic response of an earth embankment foundation on liquefiable soils in Kansai area,western Japan was presented. Based on a calibrated cyclic elasto-plastic constitutive model for liquefiable sand and Biot dynamic coupled theory,the seismic analysis was carried out by using a dynamic effective stress finite element method under plane strain condition. A recent design study was illustrated in detail for a river earth embankment subjected to seismic excitation on the saturated deposits with liquefiable sands. Simulated results of the embankment foundation during liquefaction were obtained for acceleration,displacement,and excess pore water pressures,which were considered to yield useful results for earthquake geotechnical design. The results show that the foundation soil reaches a fully liquefied state with high excess pore pressure ratios approaching to 1.0 due to the earthquake shaking. At the end of the earthquake,the extensive liquefaction causes about 1.0 m lateral spreading at the toe and 60 cm settlement at the crest of the earth embankment.

Study on the FEM design of reinforced earth retaining wall with geogrid

At present,limit equilibrium method is often adopted in the design of reinforced earth retaining wall. Geotechnical engineers home and abroad have done a lot of work to improve the traditional calculation methods in recent years,while there are lots of defects. This paper first identifies the location of failure surface and safety factor through the finite element program of PLAXIS and then analyses the influencing factors of the stability of reinforced earth retaining wall with geogrid. The authors adopt strength reduction FEM (finite element method)in the design and stability analysis of reinforced earth retaining wall and have achieved some satisfying results. Without any assumptions,the new design method can automatically judge the failure mode of reinforced earth retaining wall,consider the influence of axial tensile stiffness of the reinforcement stripe on the stability of retaining wall,identify reasonable distance and length of the reinforcement stripe,and choose suitable parameters of reinforcement stripe,including strength,stiffness and pseudo-friction coefficient which makes the design optimal. It is proved through the calculation examples that this method is more reasonable,reliable and economical in the design of reinforced earth retaining wall.

MECHANISM OF WATER-SOIL COUPLED ACTION DURING MINING SUBSIDENCE

This paper,on the basis of the scientific research of engineering geological exploration in a mining area,systematically studies the reasons and influence factors of consolidation and deformation of the saturated soil included in the thick loose water-bearing overburden due to mining subsidence,and analyses the dissipation of hyperstatic pore water pressure during the change of original stress and strain state of the soil. Again,by means of the coupled model based on Cambridge model and Biot's three-dimensional consolidation theory,adopting a great many physico-mechanical parameters measured in various soil layers,the paper analyses the consolidation and deformation of saturated soil affected by mining subsidence with elasto-plastic finite element method.Thus,the research not only reveals the regulation of stress,strain,displacement and hyperstatic pore water pressure dissipation in overlying soil mass,but also opens up a new direction and way for the research of mining subsidence.

Improved Simulation Method for Soil-Geogrid Interaction of Reinforced Earth Structure in FEM

The interaction between geogrid and soil is crucial for the stability of geogrid-reinforced earth structure. In finite element （FE） analysis, geogrids are usually assumed as beam or truss elements, and the interaction between geogrid and soil is considered as Coulomb friction resistance, which cannot reflect the true stress and displacement developed in the reinlbrcement. And the traditional Lagrangian elements used to simulate soil always become highly distorted and lose accuracy in high-stress blocks. An improved geogrid model that can produce shear resistance and passive resistance and a soil model using the Eulerian technique, in combination with the coupled Eulerian-Lagrangian （CEL） method, are used to analyze the interaction between geogrid and soil of reinforced foundation test in ABAQUS. The stress in the backfill, resistance of geogrid, and settlement of foundation were computed and the results of analysis agree well with the experimental results. This simulation method is of referential value for FE analysis of reinforced earth structure.

Seismic response analysis of GRPS embankment under oblique incident P wave

In order to investigate the seismic performance of geosynthetic reinforced and pile supported(GRPS) embankment under seismic loads, an input method for three-dimensional oblique incidence of P wave was proposed. This method is based on the explicit finite element method while considering the viscous-spring artificial boundary(VSAB) condition. Using the proposed method, a numerical study was conducted, and the influence of oblique incidence on the seismic response of GRPS embankment under the oblique incident P waves was analyzed. The results indicate that in comparison with vertical incidence, the oblique incidence can significantly increase the displacement, velocity and acceleration of key locations in the GRPS embankment. The existence of geosynthetics can alleviate the impact of seismic load on the response of the embankment to a certain degree. Moreover, the number of reinforcement layers and modulus of geogrid also greatly influence the seismic performance of GRPS embankment.

Dynamic limit equilibrium analysis of sliding block for rock slope based on nonlinear FEM

Traditional rigid body limit equilibrium method （RBLEM） was adopted for the stability evaluation and analysis of rock slope under earthquake scenario. It is not able to provide the real stress distribution of the structure, while the strength reduction method relies on the arbitrary decision on the failure criteria. The dynamic limit equilibrium solution was proposed for the stability analysis of sliding block based on 3-D multi-grid method, by incorporating implicit stepping integration FEM. There are two independent meshes created in the analysis： One original 3-D FEM mesh is for the simulation of target structure and provides the stress time-history, while the other surface grid is for the simulation of sliding surface and could be selected and designed freely. As long as the stress time-history of the geotechnical structure under earthquake scenario is obtained based on 3-D nonlinear dynamic FEM analysis, the time-history of the force on sliding surface could be derived by projecting the stress time-history from 3-D FEM mesh to surface grid. After that, the safety factor time-history of the sliding block will be determined through applying limit equilibrium method. With those information in place, the structure＇s aseismatic stability ean be further studied. The above theory and method were also applied to the aseismatic stability analysis of Dagangshan arch dam＇s right bank high slope and compared with the the result generated by Quasi-static method. The comparative analysis reveals that the method not only raises the FEM＇s capability in accurate simulation of complicated geologic structure, but also increases the flexibility and comprehensiveness of limit equilibrium method. This method is reliable and recommended for further application in other real geotechnical engineering.

Comparative Analysis of Seismic Response Characteristics of Pile-Soil-Stnicture Interaction System

The study on the earthquake-resistant performance of a pile-soil-structure interaction system is a relatively complicated and primarily important issue in civil engineering practice. In this paper, a computational model and computation procedures for pile-supported structures, which can duly consider the pile-soil interaction effect, arc established by the finite clement method. Numerical implementation is made in the time domain. A simplified approximation for the seismic response analysis of pile-soil-structure systems is briefly presented. Then a comparative study is performed for an engineering example with numerical results computed respectively by the finite clement method and the simplified method. Through comparative analysis, it is shown that the results obtained by the simplified method well agree with those achieved by the finite element method. The numerical results and findings will offer instructive guidelines for earthquake-resistant analysis and design of pile-supported structures.

Discussion and study on contraction joints for RCC gravity dam

Based on the construction property of rolled compacted concrete, three-dimensional finite element relocating mesh method was developed in simulating construction process and computing temperature and stress field. Using this method, the temperature and the thermal stress fields developed in the RCC gravity dam of the Longtan project with or without a longitudinal joint during construction and operation are calculated so as to simulate the construction process. The computation results show that the value of the thermal stresses developed in the dam even, without any longitudinal joint, could meet the design criteria provided the placement temperature is adequately controlled.

Collapse simulation of a super high-rise building subjected to extremely strong earthquakes

In recent years, super high-rise buildings (>500 m) are developing very quickly and become an important frontier of civil engineering. The collapse resistance of super high-rise buildings subjected to extremely strong earthquake is a critical problem that must be intensively studied. This paper builds up a nonlinear finite element model of the tallest building in China, Shang- hai Tower (632 m), and proposes the modeling method and failure criteria for different structural elements. The dynamic char- acters of this building are then analyzed, and the possible failure modes and collapse processes due to earthquakes are pre- dicted, as well as the corresponding collapse mechanism. This work will be helpful in collapse prevention and the seismic design of super high-rise buildings.