The effects of green high performance concrete (GHPC) admixture on the anti-chloride permeability and anti- chloride corrodibility of concrete are studied by a series of experiments designed on the basis of the diffus...The effects of green high performance concrete (GHPC) admixture on the anti-chloride permeability and anti- chloride corrodibility of concrete are studied by a series of experiments designed on the basis of the diffusion principle and electro-chemical principle. The GHPC admixture consists of fly ash, gangue, slag, red mud, etc., of which the mass fraction of industrial residues is over 96 %. The anti-permeabilities and anti-corrodibilities of the tested GHPC and normal concrete (NC) are evaluated by the Diffusion Coefficients of chloride which was obtained by measuring the concentration of chloride in the tested systems by the voltage difference method. It is found that the adoption of GHPC admixture greatly improves the anti-chloride permeability and anti-chloride corrodibility by modifying the inner structure and contracting the porosity of concrete to the reduce considerably the diffusion rate of chloride. The admixture is desirable regarding its engineering performances as well as economical and environmental interests.展开更多
The deterioration of concrete by sulfuric acid attack in sewage environments has become a serious problem for many existing sewage structures. In this study, the properties of concrete using the blast furnace slag hav...The deterioration of concrete by sulfuric acid attack in sewage environments has become a serious problem for many existing sewage structures. In this study, the properties of concrete using the blast furnace slag have been examined. It was shown that by using the blast furnace slag fine aggregate and blast furnace slag fine powder, it is possible to enhance the resistance of mortar and concrete to sulfuric acid. The resistance to sulfuric acid of mortar and concrete can be improved by using a blast-furnace slag fine aggregate in the total amount of fine aggregate. When mortar or concrete reacts to sulfuric acid, dihydrated gypsum film is formed around the particulate of the fine aggregate. This dihydrated gypsum film could retard the penetration of sulfuric acid, thus, improving the resistance to sulfuric acid. Furthermore, it has been proved that the relationship between the erosion depth by sulfuric acid attack and the product of immersion period and concentration of sulfuric acid can be expressed linearly. However, this relationship is dependent on the type of materials of concrete.展开更多
In the near future, fresh water will be very difficult to get and scarce. It is said that in 2025 half of the mankind will live in the areas where fresh water is not enough. Also, UN and WMO （World Meteorological Org...In the near future, fresh water will be very difficult to get and scarce. It is said that in 2025 half of the mankind will live in the areas where fresh water is not enough. Also, UN and WMO （World Meteorological Organization） are predicting five billion people will be in short of even drinking water. Also, in the present, there are some areas where sea water or chloride contained sand are used as mixing water with or without intension. The authors believe that the possibilities of using sea water as mixing water in concrete should be investigated seriously. In this paper, the authors would like to show various possibilities of using sea water as mixing water in RC （reinforced concrete） members. The possibilities are shown as follows： （1） mixed with pozzolanic materials （Blast furnace slag powder, etc.） expecting to fix the free chloride ion; （2） Mixed with corrosion inhibitor; （3） reinforced with stainless steel or corrosion resistant reinforcement; and （4） used in very dry or submerged conditions.展开更多
Behavior of structural elements under blast loading is different from that under usual loading conditions that are considered in conventional structural deigns. Cantilever slabs are more vulnerable than most other ele...Behavior of structural elements under blast loading is different from that under usual loading conditions that are considered in conventional structural deigns. Cantilever slabs are more vulnerable than most other elements under blast loads because of their shape. Understanding the blast behavior of cantilever slabs is useful in strengthening them against blast loads. In this paper, blast loading design envelopes for cantilever slabs are proposed using which, the blast behavior of conventional cantilever slabs can be identified. The paper describes the theories behind these envelopes and the way they can be applied to improve conventional designs. These envelopes have been prepared using numerical techniques. The theories used are accepted, verified and validated theories. The paper shows the possibility of converting a conventional cantilever slab design into impulsive regime design with minor adjustments to the structural design. It points out the importance of increasing slab thickness and controlling steel/concrete ratio for strengthening conventional cantilever slab designs and the requirement of reinforcement at top and bottom fibers.展开更多
Construction of mass concrete structures face more challenges in temperature difference and complex stress under low temperature than the ambient temperature. It has been proved by the practice that, not only improvin...Construction of mass concrete structures face more challenges in temperature difference and complex stress under low temperature than the ambient temperature. It has been proved by the practice that, not only improving tensile strength of structural concrete as soon as possible and removing of constrain as much as possible, but also calculation of the thermal stress in the process of construction and maintenance, controlling structure of concrete tensile strength and temperature difference stress ratio can ensure the safety and defect-free.展开更多
In this work, strength assessments and percentage of water absorption of self compacting concrete containing ground granulated blast furnace slag （GGBFS） and A1203 nanoparticles as binder have been investigated. Por...In this work, strength assessments and percentage of water absorption of self compacting concrete containing ground granulated blast furnace slag （GGBFS） and A1203 nanoparticles as binder have been investigated. Portland cement was replaced by different amounts of GGBFS and the properties of concrete specimens were investigated. Although it negatively impacts the physical and mechanical properties of concrete at early ages of curing, GGBFS was found to improve the physical and mechanical properties of concrete up to 45 wt% at later ages. A1203 nanoparticles with the average particle size of 15 nm were added partially to concrete with the optimum content of GGBFS and physical and mechanical properties of the specimens were measured. A1203 nanoparticle as a partial replacement of cement up to 3.0 wt% could accelerate C-S-H gel formation as a result of increased crystalline Ca（OH）2 amount at the early ages and hence increase strength and improve the resistance to water permeability of concrete specimens. The increase of the A1203 nanoparticles＇ content by more than 3.0 wt% would cause the reduction of the strength because of the decreased crystalline Ca（OH）2 content required for C-S-H gel formation. Several empirical relationships have been presented to predict flexural and split tensile strength of the specimens by means of the corresponding compressive strength at a certain age of curing. Accelerated peak appearance in conduction calorimetry tests, more weight loss in thermogravimetric analysis and more rapid appearance of the peaks related to hydrated products in X-ray diffraction results, all indicate that A1203 nanoparticles could improve mechanical and physical properties of the concrete specimens.展开更多
In the present study, compressive strength, pore structure, thermal behavior and microstrncture characteristics of concrete containing ground granulated blast furnace slag and TiO2 nanoparticles as binder were investi...In the present study, compressive strength, pore structure, thermal behavior and microstrncture characteristics of concrete containing ground granulated blast furnace slag and TiO2 nanoparticles as binder were investigated. Portland cement was replaced by different amounts of ground granulated blast furnace slag and the properties of concrete specimens were investigated. Al- though it negatively impacts the properties of concrete at early ages, ground granulated blast furnace slag up to 45 wt% was found to improve the physical and mechanical properties of concrete at later ages. TiO2 nanoparticles with the average particle size of 15 nm were partially added to concrete with the optimum content of ground granulated blast furnace slag and physical and mechanical properties of the specimens were measured. TiO2 nanoparticle as a partial replacement of cement up to 3 wt% could accelerate C-S-H gel formation as a result of increased crystalline Ca（OH）2 amount at the early age of hydration and hence increase compressive strength of concrete. The increased TiO2 nanoparticles＇ content of more than 3 wt% may cause reduced compressive strength because of the decreased crystalline Ca（OH）2 content required for C-S-H gel formation and unsuitable dispersed nanoparticles in the concrete matrix. TiO2 nanoparticles could improve the pore structure of concrete and shift the distributed pores to harmless and less-harm pores.展开更多
文摘The effects of green high performance concrete (GHPC) admixture on the anti-chloride permeability and anti- chloride corrodibility of concrete are studied by a series of experiments designed on the basis of the diffusion principle and electro-chemical principle. The GHPC admixture consists of fly ash, gangue, slag, red mud, etc., of which the mass fraction of industrial residues is over 96 %. The anti-permeabilities and anti-corrodibilities of the tested GHPC and normal concrete (NC) are evaluated by the Diffusion Coefficients of chloride which was obtained by measuring the concentration of chloride in the tested systems by the voltage difference method. It is found that the adoption of GHPC admixture greatly improves the anti-chloride permeability and anti-chloride corrodibility by modifying the inner structure and contracting the porosity of concrete to the reduce considerably the diffusion rate of chloride. The admixture is desirable regarding its engineering performances as well as economical and environmental interests.
文摘The deterioration of concrete by sulfuric acid attack in sewage environments has become a serious problem for many existing sewage structures. In this study, the properties of concrete using the blast furnace slag have been examined. It was shown that by using the blast furnace slag fine aggregate and blast furnace slag fine powder, it is possible to enhance the resistance of mortar and concrete to sulfuric acid. The resistance to sulfuric acid of mortar and concrete can be improved by using a blast-furnace slag fine aggregate in the total amount of fine aggregate. When mortar or concrete reacts to sulfuric acid, dihydrated gypsum film is formed around the particulate of the fine aggregate. This dihydrated gypsum film could retard the penetration of sulfuric acid, thus, improving the resistance to sulfuric acid. Furthermore, it has been proved that the relationship between the erosion depth by sulfuric acid attack and the product of immersion period and concentration of sulfuric acid can be expressed linearly. However, this relationship is dependent on the type of materials of concrete.
文摘In the near future, fresh water will be very difficult to get and scarce. It is said that in 2025 half of the mankind will live in the areas where fresh water is not enough. Also, UN and WMO （World Meteorological Organization） are predicting five billion people will be in short of even drinking water. Also, in the present, there are some areas where sea water or chloride contained sand are used as mixing water with or without intension. The authors believe that the possibilities of using sea water as mixing water in concrete should be investigated seriously. In this paper, the authors would like to show various possibilities of using sea water as mixing water in RC （reinforced concrete） members. The possibilities are shown as follows： （1） mixed with pozzolanic materials （Blast furnace slag powder, etc.） expecting to fix the free chloride ion; （2） Mixed with corrosion inhibitor; （3） reinforced with stainless steel or corrosion resistant reinforcement; and （4） used in very dry or submerged conditions.
文摘Behavior of structural elements under blast loading is different from that under usual loading conditions that are considered in conventional structural deigns. Cantilever slabs are more vulnerable than most other elements under blast loads because of their shape. Understanding the blast behavior of cantilever slabs is useful in strengthening them against blast loads. In this paper, blast loading design envelopes for cantilever slabs are proposed using which, the blast behavior of conventional cantilever slabs can be identified. The paper describes the theories behind these envelopes and the way they can be applied to improve conventional designs. These envelopes have been prepared using numerical techniques. The theories used are accepted, verified and validated theories. The paper shows the possibility of converting a conventional cantilever slab design into impulsive regime design with minor adjustments to the structural design. It points out the importance of increasing slab thickness and controlling steel/concrete ratio for strengthening conventional cantilever slab designs and the requirement of reinforcement at top and bottom fibers.
文摘Construction of mass concrete structures face more challenges in temperature difference and complex stress under low temperature than the ambient temperature. It has been proved by the practice that, not only improving tensile strength of structural concrete as soon as possible and removing of constrain as much as possible, but also calculation of the thermal stress in the process of construction and maintenance, controlling structure of concrete tensile strength and temperature difference stress ratio can ensure the safety and defect-free.
文摘In this work, strength assessments and percentage of water absorption of self compacting concrete containing ground granulated blast furnace slag （GGBFS） and A1203 nanoparticles as binder have been investigated. Portland cement was replaced by different amounts of GGBFS and the properties of concrete specimens were investigated. Although it negatively impacts the physical and mechanical properties of concrete at early ages of curing, GGBFS was found to improve the physical and mechanical properties of concrete up to 45 wt% at later ages. A1203 nanoparticles with the average particle size of 15 nm were added partially to concrete with the optimum content of GGBFS and physical and mechanical properties of the specimens were measured. A1203 nanoparticle as a partial replacement of cement up to 3.0 wt% could accelerate C-S-H gel formation as a result of increased crystalline Ca（OH）2 amount at the early ages and hence increase strength and improve the resistance to water permeability of concrete specimens. The increase of the A1203 nanoparticles＇ content by more than 3.0 wt% would cause the reduction of the strength because of the decreased crystalline Ca（OH）2 content required for C-S-H gel formation. Several empirical relationships have been presented to predict flexural and split tensile strength of the specimens by means of the corresponding compressive strength at a certain age of curing. Accelerated peak appearance in conduction calorimetry tests, more weight loss in thermogravimetric analysis and more rapid appearance of the peaks related to hydrated products in X-ray diffraction results, all indicate that A1203 nanoparticles could improve mechanical and physical properties of the concrete specimens.
文摘In the present study, compressive strength, pore structure, thermal behavior and microstrncture characteristics of concrete containing ground granulated blast furnace slag and TiO2 nanoparticles as binder were investigated. Portland cement was replaced by different amounts of ground granulated blast furnace slag and the properties of concrete specimens were investigated. Al- though it negatively impacts the properties of concrete at early ages, ground granulated blast furnace slag up to 45 wt% was found to improve the physical and mechanical properties of concrete at later ages. TiO2 nanoparticles with the average particle size of 15 nm were partially added to concrete with the optimum content of ground granulated blast furnace slag and physical and mechanical properties of the specimens were measured. TiO2 nanoparticle as a partial replacement of cement up to 3 wt% could accelerate C-S-H gel formation as a result of increased crystalline Ca（OH）2 amount at the early age of hydration and hence increase compressive strength of concrete. The increased TiO2 nanoparticles＇ content of more than 3 wt% may cause reduced compressive strength because of the decreased crystalline Ca（OH）2 content required for C-S-H gel formation and unsuitable dispersed nanoparticles in the concrete matrix. TiO2 nanoparticles could improve the pore structure of concrete and shift the distributed pores to harmless and less-harm pores.
