期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
室内外气压平衡装置过风管施工技术
1
作者 钱玉龙 《广东土木与建筑》 2024年第4期101-103,共3页
以某办公楼为例,对室内外气压平衡装置过风管施工技术进行研究,综述了通过在门顶设置室内外气压平衡装置(过风管道、孔口百叶、管道内隔音装置),消除门启闭时所产生空气正负压,使室内外气压保持平衡,并通过管内粘贴玻纤毡复合玻璃棉板... 以某办公楼为例,对室内外气压平衡装置过风管施工技术进行研究,综述了通过在门顶设置室内外气压平衡装置(过风管道、孔口百叶、管道内隔音装置),消除门启闭时所产生空气正负压,使室内外气压保持平衡,并通过管内粘贴玻纤毡复合玻璃棉板和设置橡皮阀,以消除风管运行产生的噪音,减少风管壁的冷能量损失,并起到隔音效果。 展开更多
关键词 室内气压 平衡装置 玻璃隔断 过风管 Z型外观造型 正负压 玻纤毡复合玻璃棉板 橡皮阀 镀锌薄壁钢板
下载PDF
大型低温环境室竖向气压变化特点分析
2
作者 李兆坚 邱一男 +2 位作者 徐元元 郑直 何仁 《低温工程》 CAS CSCD 北大核心 2022年第1期42-45,67,共5页
为了找出大型低温环境室室内正压设计方法存在的问题,对低温环境室在不同室温下的竖向气压变化特点进行分析,提出室内竖向气压分布的计算方法,该算法的准确性得到了实测数据的验证,其平均相对误差为5.9%。分析结果表明:大型深冷低温环... 为了找出大型低温环境室室内正压设计方法存在的问题,对低温环境室在不同室温下的竖向气压变化特点进行分析,提出室内竖向气压分布的计算方法,该算法的准确性得到了实测数据的验证,其平均相对误差为5.9%。分析结果表明:大型深冷低温环境室的竖向气压变化很大,且在降温过程中室内正压不断增大。对于高度为20 m、室温为-165℃的大型深冷低温环境室,其下部正压值可超过421 Pa,远高于低温环境室室内正压以往的设计值(5—10 Pa)和安全防护值(200 Pa),因此应大幅度提高其室内正压的设计值和安全防护值。为确保室内全部空间维持正压,低温环境室的室内正压控制点应设置在顶部。 展开更多
关键词 低温 环境室 高大空间 室内气压 竖向压力分布
下载PDF
恒定流条件下气垫式调压室室内水位与气压的模拟 被引量:3
3
作者 彭志远 杨建东 郭文成 《水动力学研究与进展(A辑)》 CSCD 北大核心 2016年第2期239-244,共6页
恒定条件下,气垫式调压室室内气压与水位随机组运行工况变化而变化,该变化不仅取决于上库水位、机组出力等,而且取决于气垫式调压室室内气压设定值。若上库水位变幅较大,气压设定值将直接关系到气垫式调压室运行安全。为此,该文建立了... 恒定条件下,气垫式调压室室内气压与水位随机组运行工况变化而变化,该变化不仅取决于上库水位、机组出力等,而且取决于气垫式调压室室内气压设定值。若上库水位变幅较大,气压设定值将直接关系到气垫式调压室运行安全。为此,该文建立了设有气垫式调压室的引水发电系统恒定流数学模型,推导出了室内水位与气压的解析解,分析了上游水位、引用流量、初始设置水位、调压室顶部高程对室内气压与水位的影响,探讨了室内水位变幅与上库水位变幅之间的匹配关系,由此给出了室内水位/气压设定值选取范围,对电站设计和运行具有参考价值。 展开更多
关键词 气垫式调压室 恒定流 室内水位/气压设定值 匹配关系
原文传递
Sedimentation behavior of indoor airborne microparticles 被引量:3
4
作者 LIMing WU Chao PAN Wei 《Journal of China University of Mining and Technology》 EI 2008年第4期588-593,共6页
Experiments on the behavior of airborne microparticle sediments and their adhesion on glass slides were conducted in a laboratory located on the first floor of a teaching building. Clean tiles and glass slides were pl... Experiments on the behavior of airborne microparticle sediments and their adhesion on glass slides were conducted in a laboratory located on the first floor of a teaching building. Clean tiles and glass slides were placed at different angles (0°, 45° and 90°) with respect to the horizontal plane in the laboratory. The sedimentation of microparticles was investigated at certain time intervals (1 d, 3 d, l0 d and 30 d). The results of testing, at day 30, show that the diameters of particles on the horizontal tiles varied from 20 to 80 μm; few particles with diameter less than 0.5 μm or greater than 100 μm were found. The amount of particle sediment on all the slides increased along over time, while the average diameter of particles was not correlated with time, nor with the angle of placement. The maximum particle size, the total particle surface area, the total perimeter of all particles and the cover ratio of light (the proportion of total area of particles to the observed area of the slides surfaces) did not change significantly within the first 10 days. Inspection of all the samples for the last 20 days, however, showed that these variables increased substantially with the passage of time and were in reverse proportion to the placement angles, which indicates a concentration of particles, as well as physical and chemical changes. 展开更多
关键词 PARTICLE SEDIMENTATION size distribution SURFACE indoor air
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部