一寸一寸醒来

一寸一寸醒来 就让我靠着鸟吧 好叫儿子们放心

“一丝不挂”源流考辨

＂一丝不挂＂是个常见成语,但对这个成语的源流,即这个成语共有几种意义,各种意义之间是什么关系,人们并不十分清楚,有的认识甚至是错误的。本文考察认为,＂一丝不挂＂就构词语素的组合而言,具有不同的本义,应该分析为四个同形词位。其中表示＂一根（半截）丝线也不挂＂义的＂一（寸）丝不挂＂是最早也是最基本的用法,以此为基础产生＂心无牵挂＂的比喻义和＂赤身裸体＂的引申义。有人把＂一（寸）丝不挂＂的＂丝＂理解为＂钓丝＂,看做＂心无牵挂＂比喻义的来源,其实是出于对有关文献用例的误解,既不符合古人遣词造句的习惯,也不符合古人比喻取义的事理。

Calculation of Apparent Activation Energy of Coal Oxidation at Low Temperatures by Measuring CO Yield

By analyzing previous studies on activation energy of coal oxidation at low temperatures, a theoretical calculation model of apparent activation energy is established. Yield of CO is measured by using the characteristic detector of coal oxidation at 30-90 ℃. The impact of parameters, such as airflow and particle size, on activation energies is analyzed. Finally, agreement was obtained between activation energies and the dynamic oxygen absorbed in order to test the accuracy of the model. The results show that： 1） a positive exponential relation between concentration of CO and temperature in the process of the experiment is obtained： increases are almost identical and the initial CO is low; 2） the apparent activation energies increase gradually with the sizes of particle at the same airflow, but the gradients increase at a decreasing rate; 3） the apparent activation energies increase linearly with airflow. For the five coal particles, the differences among the energies are relatively high when the airflow was low, but the differences were low when the airflow was high; 4） the optimum sizes of particle, 0.125-0.25 ram, and the optimum volume of airflow, 100 mL/min, are determined from the model; 5） the apparent activation energies decrease with an increase in oxygen absorbed. A negative exponential relation between the two is obtained,

The Uniformly Valid Solution for a Top System of Two Free Dimensions with Parameter

A general top system of two free dimensions with parameter is studied and the four cases satisfied by the frequency of the system are discussed.Using the multiple scale method,its uniformly valid asymptotic solution,which is expressed by complex amplitudes,of the first order is obtained.And solvable conditions satisfied by the complex amplitudes are given,and then the relative result is generalized.

CFD based extraction column design-Chances and challenges

This paper shows that one-dimensional （I-D） [and three-dimensional （3-D） computational fluid dynamics （CFD）] simulations can replace the state-of-the-art usage of pseudo-homogeneous dispersion or back mixing models. This is based on standardized lab-scale cell experiments for the determination of droplet rise, breakage, coalescence and mass transfer parameters in addition to a limited number of additional mini-plant experiments with original fluids. Alternatively, the hydrodynamic parameters can also be derived using more sophisticated 3- D CFD simulations. Computational 1-D modeling served as a basis to replace pilot-plant experiments in any column geometry. The combination of 3-D CFD simulations with droplet population balance models （DPBM） increased the accuracy of the hydrodynamic simulations and gave information about the local droplet size. The high computational costs can be reduced by open source CFD codes when using a flexible mesh generation. First combined simulations using a three way coupled CFD/DPBM/mass-transfer solver pave the way for a safer design of industrial-sized columns, where no correlations are available.

The Gelfand-Kirillov dimension of a unitary highest weight module

During the last decade, a great deal of activity has been devoted to the calculation of the HilbertPoincar′e series of unitary highest weight representations and related modules in algebraic geometry. However,uniform formulas remain elusive—even for more basic invariants such as the Gelfand-Kirillov dimension or the Bernstein degree, and are usually limited to families of representations in a dual pair setting. We use earlier work by Joseph to provide an elementary and intrinsic proof of a uniform formula for the Gelfand-Kirillov dimension of an arbitrary unitary highest weight module in terms of its highest weight. The formula generalizes a result of Enright and Willenbring(in the dual pair setting) and is inspired by Wang's formula for the dimension of a minimal nilpotent orbit.

One and two dimensional chloride ion diffusion of fly ash concrete under flexural stress

A preloading frame is firstly designed to accurately apply external flexural stress to concrete specimens. Then a method is developed to measure one and two dimensional (1D and 2D) chloride ion concentrations at different distances from the surface of concrete under flexural stress. Using this method and the preloading frame, 1D and 2D stress-diffusion is systematically investigated for fly ash concretes made with different fly ash contents (0%, 10%, 20%, 40%, and 60%), and water to binder ratios (0.3, 0.35, and 0.4). The stress accelerating effect on 1D and 2D chloride ion diffusion is also quantitatively analyzed through a comparison between stress-diffusion and nonstress-diffusion. A diffusion accelerating effect caused by external flexural stress can clearly be observed through the comparison. In order to quantify the stress accelerating effect, a stress accelerating factor is proposed in this paper. The relationship between stress accelerating factor and external stress-to-ultimate stress ratio is given as an exponential function. Finally, the process of the initiation, prorogation, and distribution of microcracks on the tensile face of specimen is observed in-situ by using a small-sized loading frame and scanning electron microscope (SEM). The above research provides an insight into chloride attack on the edge reinforcing bars of concrete structures under flexural stress, such as large-span beam and board in the field of civil engineering.

Stepwise decomposition and relative radiometric normalization for small footprint LiDAR waveform

As an advanced generation instrument of earth observation,small footprint full waveform light detection and ranging(LiDAR) technology has been widely used in the past few years.Decomposition and radiative correction is an important step in waveform data processing,it influences the accuracy of both information extraction and further applications.Based on a stepwise strategy,this study adopts Gaussian mixture model to approximate the LiDAR waveform.In addition to waveform decomposition,a relative correction model is proposed in this paper,the model considers the transmit pulses as well as the different of the travel path for implementing LiDAR waveform relative correction.Validation of the stepwise decomposition and relative correction model are carried out on LiDAR waveform acquired over Zhangye,China.The results indicate that stepwise decomposition identified the number of peaks in LiDAR waveforms,center position and width of each peak well.The relative radiometric correction also improves the similarity of waveforms which acquired at the same target.

Controlled fabrication and microwave absorbing mechanism of hollow Fe3O4@C microspheres

Uniform core-shell SiO2@Fe_3O_4@C microspheres were prepared by a one-step hydrothermal method with SiO_2 microspheres as the template, and the hollow Fe_3O_4@C(HFC) microspheres were achieved via etching SiO_2 template. By changing the sizes of SiO_2 microspheres, a series of HFC microspheres with variable cavity sizes were obtained to study the relationship between cavity size and microwave absorbing(MA) performance for the first time. The morphology and structure of samples were characterized in detail. The results showed that the MA performance of HFC sample depended on its cavity size. In particular, the hollow structure was good for improving MA performance and could make MA move to the high-frequency region. More importantly, as the cavity size increases, the resonance frequency of HFC-i(i=1,2, 3, 4) samples moved to a low frequency, and the optimal matching thickness of HFC-i samples was increasing. Among all HFC-i samples, HFC-3 showed the most excellent MA performance,which could be mainly explained by the quarter-wavelength matching model, intrinsical magnetic and dielectric loss. Furthermore,the MA performance of HFC mixture blended by the equal mass fraction of HFC-2, HFC-3 and HFC-4 was the comprehensive results of three HFC-i samples. All the above suggested that the cavity size in HFC sample had a great influence on the MA performance.

Importance of Au nanostructures in CO2 electrochemical reduction reaction

Electrochemical conversion of CO2 into fuels is a promising means to solve greenhouse effect and recycle chemical energy. However, the CO2 reduction reaction(CO2 RR) is limited by the high overpotential, slow kinetics and the accompanied side reaction of hydrogen evolution reaction. Au nanocatalysts exhibit high activity and selectivity toward the reduction of CO2 into CO. Here, we explore the Faradaic efficiency(FE)of CO2 RR catalyzed by 50 nm gold colloid and trisoctahedron. It is found that the maximum FE for CO formation on Au trisoctahedron reaches 88.80% at -0.6 V, which is 1.5 times as high as that on Au colloids(59.04% at -0.7 V). The particle-size effect of Au trisoctahedron has also been investigated, showing that the FE for CO decreases almost linearly to 62.13% when the particle diameter increases to 100 nm. The Xray diffraction characterizations together with the computational hydrogen electrode(CHE) analyses reveal that the(2 2 1) facets on Au trisoctahedron are more feasible than the(1 1 1) facets on Au colloids in stabilizing the critical intermediate COOH*, which are responsible for the higher FE and lower overpotential observed on Au trisoctahedron.

Size-dependent elastic properties of thin films: surface anisotropy and surface bonding

Surface eigenstress and eigendisplacement models were used to investigate the surface stress, surface relaxation and surface elasticity of thin films with different surface orientations. Molecular dynamics simulations and first-principles calculations were conducted on face-centered cubic Au films with the focus on relaxation induced nonlinear initial deformation. The simu- lation results verify the theoretical predictions of the size dependency of surface energy density and surface stress, and the non- linear scaling law of the size-dependent Young＇s modulus of thin films. The mechanism of the size-dependent behaviors was further explored at the atomic bonding level with the charge density field. The Au atomic bonding at surfaces is enhanced compared to its interior counterpart and therefore the nominal Young＇s modulus of the Au thin films is larger when the film thickness is smaller.surface elasticity,