基于光伏功率等效面积法的多峰最大功率追踪控制方法

当光伏组串受到不均匀照射时,其输出特性将会从原来的单峰曲线变成有多个峰值点的多峰曲线,因此受到非均匀照射的光伏阵列含有多个局部峰值点(Local Maximum Power Point,LMPP),使用常规的最大功率跟踪控制方法很难准确的追踪到全局最大功率点(Global Maximum Power Point,GMPP)。针对上述问题,首先基于MATLAB仿真软件搭建了光伏组串在受到非均一阴影遮挡情况下的模型;其次研究了其功率-电压(P-U)特性和导数(dP/dU-U)特性,分析了全局最大功率点与光伏功率等效面积之间的关系;最后提出了基于光伏功率等效面积所决定的工作区间定位的新型多峰最大功率点追踪(Maximum Power Point Trace,MPPT)控制方法。仿真结果表明,所提出的光伏功率等效面积法算法能够有效且快速的寻找到全局最大功率点。

Rate decline analysis of multiple fractured horizontal well in shale reservoir with triple continuum

Multiple fractured horizontal well(MFHW) is widely applied in the development of shale gas. To investigate the gas flow characteristics in shale, based on a new dual mechanism triple continuum model, an analytical solution for MFHW surrounded by stimulated reservoir volume(SRV) was presented. Pressure and pressure derivative curves were used to identify the characteristics of flow regimes in shale. Blasingame type curves were established to evaluate the effects of sensitive parameters on rate decline curves, which indicates that the whole flow regimes could be divided into transient flow, feeding flow, and pseudo steady state flow. In feeding flow regime, the production of gas well is gradually fed by adsorbed gases in sub matrix, and free gases in matrix. The proportion of different gas sources to well production is determined by such parameters as storability ratios of triple continuum, transmissibility coefficients controlled by dual flow mechanism and fracture conductivity.

Identification Method of Dynamic Coefficients of Fluid Film Bearings for HDD Spindle Motors

Fluid film bearings are widely used as support elements of rotating shaft for HDD （hard disk drive） spindle motors. Recently, the opportunity for the HDD spindle motors exposed to external vibration has been increasing because the HDDs are used for various information related equipments such as mobile PCs, car navigation systems. Hence, the rotating shaft has a possibility to come in contact with the bearing and it causes wear or seizure to the bearing surface. In order to avoid the problems, it is extremely important to enhance the dynamic characteristics of the fluid film bearings for spindles. However, verification from both theory and experiment of dynamic characteristics such as spring coefficients and damping coefficients is rare and few. In this paper, the bearing vibration characteristics when the HDD spindle is oscillated are investigated theoretically and experimentally. And then the identification method ofoil film coefficients of fluid film bearing spindles is described.

Nonlinear characteristics of induced spontaneous combustion process of sulfide ores

To investigate the relationship between nonlinear parameters and spontaneous combustion tendency of sulfide ores, nine different sulfide ore samples were taken from a pyrite mine in China, and induced spontaneous combustion experiment was carried out in the laboratory. Different stages of the induced spontaneous combustion process were studied by integrating wavelet technology and nonlinear dynamics theory. The results show that ignition points of all the ore samples are above 330 ℃, indicating that sulfide ores of the pyrite mine are difficult to combust spontaneously under normal mining conditions. Spontaneous combustion process includes three stages： incubation stage, development stage and approaching stage. The average temperature rising rate of the three stages are 1.0 ~C/min, 2.0 ~C/min and 4.2 ~C/min, respectively. During the spontaneous combustion process, mean values of approximate entropy and correlation dimension increase at first, and then decrease in the following stage. The mean value of the maximum Lyapunov exponent increases with the passage of reaction time. In a whole, correlation among the three nonlinear parameters firstly weakens, then enhances, and the best correlation period is at approaching stage. As ignition point increases, the maximum Lyapunov exponent of approaching stage decreases. Therefore, combustible tendency of sulfide ores could be qualitatively evaluated based on the maximum Lyapunov exponent of this stage.

Study on detonation characteristic of low energy detonating fuse in bending conditions

Detonation of low energy detonating fuse was studied in numerical simulation and experiments in bending conditions using LS_DYNA3D. The results show that pressure of the explosion and detonation velocity decrease in the same section areas after bending. In bending conditions, detonation wave was similar to small angle comer diffraction. So the detonation velocity was lower than normal velocity.

Biochar Effect on Water Evaporation and Hydraulic Conductivity in Sandy Soil

Biochar, as a kind of soil amendment, has important effects on soil water retention. In this research, 4 different kinds of biochars were used to investigate their influences on hydraulic properties and water evaporation in a sandy soil from Hebei Province, China. Biochar had strong absorption ability in the sandy soil. The ratio of water content in the biochar to that in the sandy soil was less than the corresponding ratio of porosity. Because of the different hydraulic properties between the sandy soil and the biochar, the saturated hydraulic conductivity of the sandy soil gradually decreased with the increasing biochar addition. The biochar with larger pore volume and average pore diameter had better water retention. More water was retained in the sandy soil when the biochar was added in a single layer, but not when the biochar was uniformly mixed with soil. Particle size of the added biochar had a significant influence on the hydraulic properties of the mixture of sand and biochar. Grinding the biochar into powder destroyed the pore structure, which simultaneously reduced the water absorption ability and hydraulic conductivity of the biochar. For this reason, adding biochar powder to the sandy soil would not decrease the water evaporation loss of the soil itself.