期刊文献+
共找到6篇文章
< 1 >
每页显示 20 50 100
原子吸收光度法测定工业氟硅酸中铜含量 被引量:3
1
作者 郭扬武 傅祖玲 《理化检验(化学分册)》 CAS CSCD 北大核心 2002年第1期46-46,共1页
关键词 工业氟硅酸 测定 原子吸收光度法 标准加入法
下载PDF
容器材质对化工行业标准《工业氟硅酸》检验影响的探讨
2
作者 杜肖宾 杨宏 徐娇 《浙江化工》 CAS 2020年第3期46-48,共3页
HG/T 2832《工业氟硅酸》中,测定氟硅酸时采用玻璃容器可能影响产品含量。本文从反应原理、容器材质、美国相关标准等方面进行说明,分析试验结果,探讨了容器材质对《工业氟硅酸》检验的影响。
关键词 工业氟硅酸 容器材质 含量测定
下载PDF
工业氟硅酸中硫酸根的快速测定
3
作者 肖晓辉 《株冶科技》 2001年第1期45-47,共3页
用硝酸钾沉淀氟硅酸根离子,滤液与氯化钡形成悬浊液,并用增聚剂脱水,于(=440nm处进行散光测定。ε=1.7×104L/cm,线性范围0-120(g/50mL,测定范围:0-2.5mg/L。
关键词 硝酸钾 氯化钡 光电比浊 硫酸根 工业氟硅酸 测定 铅电解液
下载PDF
工业磷肥副产氟硅酸合成硅铝MCM-41介孔分子筛的研究 被引量:1
4
作者 范阳春 刘铁良 +1 位作者 金放 丁一刚 《武汉工程大学学报》 CAS 2017年第6期587-593,共7页
以工业副产氟硅酸为硅源,九水合硝酸铝(Al(NO_3)3·9(H_2O))为铝源,十六烷基三甲基溴化铵(CTAB)为模板剂,在溶胶混合物的组成为:n(SiO_2)∶n[Al(NO_3)3·9(H_2O)]∶n(NH_3·H_2O)∶n(CTAB)=1∶0.01-0.10∶10∶0.25-1.00∶1... 以工业副产氟硅酸为硅源,九水合硝酸铝(Al(NO_3)3·9(H_2O))为铝源,十六烷基三甲基溴化铵(CTAB)为模板剂,在溶胶混合物的组成为:n(SiO_2)∶n[Al(NO_3)3·9(H_2O)]∶n(NH_3·H_2O)∶n(CTAB)=1∶0.01-0.10∶10∶0.25-1.00∶150(摩尔比)的条件下,水热合成含铝硅基介孔分子筛Si/Al-MCM-41.对水热合成过程中的Si/Al比,模板剂的用量,水热温度和时间等条件以及模板剂的脱除方式对分子筛结构的影响进行了研究.并通过X射线荧光光谱仪,氮气吸脱附,透射电镜,热重分析等对样品进行表征.结果表明:在合成条件为:n(CTAB)/n(Si)=2,水热温度70℃,时间5 h得到的样品的比表面积和孔体积较大,分别为1 086 m^2/g和0.70 cm^3/g. 展开更多
关键词 工业氟硅酸 介孔 MCM-41 水热法
下载PDF
关于召开制定工业湿法磷酸等十三项标准工作方案会的通知
5
《化工科技市场》 CAS 2006年第7期61-61,共1页
根据国家发展和改革委员会发改办工业(2006)1093号文《关于下达2006年行业标准项目计划的通知》的要求,全国化学标准化技术委员会无机化工分会订于2006年8月22-25日在秦皇岛市召开制定工业湿法磷酸、六氟磷酸锂和六氟磷酸锂电解液二... 根据国家发展和改革委员会发改办工业(2006)1093号文《关于下达2006年行业标准项目计划的通知》的要求,全国化学标准化技术委员会无机化工分会订于2006年8月22-25日在秦皇岛市召开制定工业湿法磷酸、六氟磷酸锂和六氟磷酸锂电解液二项化工行业标准;修订工业过硼酸钠、工业硅溶胶、工业偏硅酸钠、工业氧化铁、工业过碳酸钠、工业聚磷酸铵、工业焦亚硫酸钠、工业无水氟化钾、工业重质碳酸钙、工业高氯酸钾和工业氟硅酸11项化工行业标准工作方案会。 展开更多
关键词 工业氟硅酸 标准工作 湿法磷酸 国家发展和改革委员会 化工行业标准 标准化技术委员会 六氟磷酸锂 焦亚硫酸钠 无水氟化钾 重质碳酸钙
下载PDF
Synthesis of ZSM-5 with the silica source from industrial hexafluorosilicic acid as transalkylation catalyst 被引量:1
6
作者 Fang Jin Xianqiao Wang +3 位作者 Tieliang Liu Linbo Xiao Ming Yuan Yangchun Fan 《Chinese Journal of Chemical Engineering》 SCIE EI CAS CSCD 2017年第9期1303-1313,共11页
A new effective process to improve the utilization of industrial fluorosilicic acid of phosphate fertilizer by-product has been investigated to comprehensive application of the silicon and fluorine source. Two-step am... A new effective process to improve the utilization of industrial fluorosilicic acid of phosphate fertilizer by-product has been investigated to comprehensive application of the silicon and fluorine source. Two-step ammoniation was applied to recover high-quality silica. The recovered silica can be used to hydrothermal synthesize ZSM-5 zeolite without impurity phase contamination, which was confirmed by XRD, TG, SEM, BET and EDS characteristic techniques. It was found that with the increase of SiO_2/Al_2O_3 ratio and the extension of reaction time, the crystal type transform from the orthorhombic to the monoclinic phase. The impurity fluorine content of the recovered SiO_2 from H_2SiF_6 has great influence on the hydrothermal process for ZSM-5 crystal structure formation.Moreover, the increase of fluorine ions content in the hydrothermal process can control the crystal morphology and size of synthesized ZSM-5. Catalytic properties of synthesized HZSM-5 with different SiO_2/Al_2O_3 ratio in transalkylation of toluene and 1,2,4-trimethylbenzene show good and stable catalytic performance. The ZSM-5 synthesized with recovered silica source exhibits similar catalyst life as the performance of small particle size HZSM-5, because the ZSM-5 synthesized with the silica source from industrial hexafluorosilicic acid prefers a thin disk crystal along the b axis direction, which shortens the diffusion distance of generated products. 展开更多
关键词 ZSM-5沸石 烷基转移催化剂 工业氟硅酸 水热合成 沸石分子筛 硅源 ZSM-5分子筛 HZSM-5
下载PDF
上一页 1 下一页 到第
使用帮助 返回顶部