期刊文献+
共找到9篇文章
< 1 >
每页显示 20 50 100
用差频方法演示可闻声多普勒效应 被引量:3
1
作者 刘方礼 司明扬 《物理实验》 1990年第2期61-62,共2页
可闻声多普勒效应的传统演示方法,是让观察者直接听运动声源发出的声音,从而鉴别音调或频率的变化。我们感到这种演示方法存在如下两个问题:第一、要让现察者能听到音调有明显的变化,就要求声源的运动速度较高,而在通常实验条件下,这一... 可闻声多普勒效应的传统演示方法,是让观察者直接听运动声源发出的声音,从而鉴别音调或频率的变化。我们感到这种演示方法存在如下两个问题:第一、要让现察者能听到音调有明显的变化,就要求声源的运动速度较高,而在通常实验条件下,这一要求并不容易达到。当运动速度不高时,多普勒频移量很小,一般人耳要分辨微小的频移是比较困难的,因而演示效果不明显;第二,当声源运动发生多普勒频移的同时,观察者所听到的声强也在发生变化,这对鉴别多普勒频移效应又增加了困难。为了克服上述困难。 展开更多
关键词 差频方法 可闻声多普勒效应 演示实验
下载PDF
可调基准频率源的便携式石英晶体微天平分析仪 被引量:1
2
作者 廖玉枝 司士辉 +2 位作者 陈金华 卢阳 杜明 《分析化学》 SCIE EI CAS CSCD 北大核心 2019年第7期992-997,共6页
基于差频方法开发了一款石英晶体微天平(Quartz crystal microbalance,QCM)仪器。测试结果表明,参考标准晶体与检测晶体的差频值在±10~±30kHz范围内,精确度小于0.0028%(差频数据的相对误差),准确度小于0.2825%(差频理论值与... 基于差频方法开发了一款石英晶体微天平(Quartz crystal microbalance,QCM)仪器。测试结果表明,参考标准晶体与检测晶体的差频值在±10~±30kHz范围内,精确度小于0.0028%(差频数据的相对误差),准确度小于0.2825%(差频理论值与测量值误差)。本研究利用DDS数字发生器产生可调的基准频率源,使差频值在最优范围内,设计制作了基于Arduino单片机作为核心控制源的便携式石英晶体微天平分析仪。仪器拥有3.5寸液晶屏显示动态曲线,SD卡同步存储数据,可根据实验条件调节基准频率。气相与纯水中的平均频率漂移值小于0.13Hz/min与0.23Hz/min,表明仪器有较好稳定性。仪器差频响应与NaCl溶液浓度呈良好线性关系,相关系数为0.9891。不同粘度丙三醇的响应实验表明,Δf与(ηlρl)^1/2呈线性关系,说明仪器响应性良好。同时,本仪器还可与电化学工作站联用,用于Cu沉积过程在线检测,1ng的Cu引起0.61Hz频率的变化,为理论值的82.4%。 展开更多
关键词 石英晶体微天平 数字率直接合成 差频方法
下载PDF
THP—Ⅱ气体露点测量仪
3
作者 张盛福 张鹏 《郑州轻工业学院学报(自然科学版)》 CAS 2004年第4期70-72,共3页
开发了一种经济实用的露点测量仪.该仪器采用差频方法,使测量低湿区气体的露点分辨率达到了-55℃;因采用软件进行温度补偿,进一步提高了测量精度,具有测量准确、适用范围广、成本低等优点.
关键词 气体露点测量仪 单片机 湿敏电容 差频方法 分辨率 传感器
下载PDF
一种高精度可现场使用的QCM分析仪研制
4
作者 廖玉枝 司士辉 +2 位作者 陈金华 卢阳 杜明 《中国高新科技》 2019年第10期53-54,共2页
利用DDS数字发生器产生可调的基准频率源,使差频值在最优范围内,设计制作基于Arduino单片机作为核心控制源的便携式石英晶体微天平分析仪。氯化钠质量响应相关系数为0.9989;与不同粘度丙三醇的响应实验表明,Δf与1/2呈线性关系,说明仪... 利用DDS数字发生器产生可调的基准频率源,使差频值在最优范围内,设计制作基于Arduino单片机作为核心控制源的便携式石英晶体微天平分析仪。氯化钠质量响应相关系数为0.9989;与不同粘度丙三醇的响应实验表明,Δf与1/2呈线性关系,说明仪器响应性良好。铜的电沉积实验结果1ngCu引起0.61Hz频率的变化,为理论值的82.4%,表明本仪器还可与电化学工作站联用。 展开更多
关键词 石英晶体微天平 DDS 差频方法
下载PDF
Phase Difference Method for DOA Estimation 被引量:2
5
作者 陈志菲 孙进才 侯宏 《Journal of Marine Science and Application》 2010年第4期445-450,共6页
The phase difference method (PDM) is presented for the direction of arrival (DOA) estimation of the narrowband source. It estimates the DOA by measuring the reciprocal of the phase range of the sensor output spectra a... The phase difference method (PDM) is presented for the direction of arrival (DOA) estimation of the narrowband source. It estimates the DOA by measuring the reciprocal of the phase range of the sensor output spectra at the interest frequency bin. The peak width and variance of the PDM are presented. The PDM can distinguish closely spaced sources with different and unknown center frequencies as long as they are separated with at least one frequency bin. The simulation results show that the PDM has a better resolution than that of the conventional beamforming. 展开更多
关键词 direction of arrival(DOA) phase difference peak width variance RESOLUTION
下载PDF
Efficient numerical analysis of guided wave structures by compact FDFD with PVL method
6
作者 吴大刚 《Journal of Southeast University(English Edition)》 EI CAS 2004年第2期153-156,共4页
An efficient numerical simulation technique is introduced to extract the propagation characteristics of a millimeter guided wave structure. The method is based on the application of the Krylov subspace model order red... An efficient numerical simulation technique is introduced to extract the propagation characteristics of a millimeter guided wave structure. The method is based on the application of the Krylov subspace model order reduction technique (Padé via Lanczos) to the compact finite difference frequency domain (FDFD) method. This new technique speeds up the solution by decreasing the originally larger system matrix into one lower order system matrix. Numerical experiments from several millimeter guided wave structures demonstrate the efficiency and accuracy of this algorithm. 展开更多
关键词 model order reduction finite difference frequency domain (FDFD) guided wave structure Padé via Lanczos (PVL)
下载PDF
Multiple moving sources passive location based on multiset canonical correlation analysis
7
作者 禹华钢 Huang Gaoming Gao Jun 《High Technology Letters》 EI CAS 2013年第2期197-202,共6页
To solve the problem of multiple moving sources passive location, a novel blind source separa- tion (BSS) algorithm based on the muhiset canonical correlation analysis (MCCA) is presented by exploiting the differe... To solve the problem of multiple moving sources passive location, a novel blind source separa- tion (BSS) algorithm based on the muhiset canonical correlation analysis (MCCA) is presented by exploiting the different temporal structure of uncorrelated source signals first, and then on the basis of this algorithm, a novel multiple moving sources passive location method is proposed using time difference of arrival (TDOA) and frequency difference of arrival (FDOA) measurements. The key technique of this location method is TDOA and FDOA joint estimation, which is based on BSS. By blindly separating mixed signals from multiple moving sources, the multiple sources location problem can be translated to each source location in turn, and the effect of interference and noise can also he removed. The simulation results illustrate that the performance of the MCCA algorithm is very good with relatively light computation burden, and the location algorithm is relatively simple and effective. 展开更多
关键词 multiset canonical correlation analysis (MCCA) blind source separation (BSS) time difference of arrival (TDOA) frequency difference of arrival (FDOA) passive location mul-tiple sources
下载PDF
A fast acquisition method of DSSS signals using differential decoding and fast Fourier transform 被引量:2
8
作者 杨伟君 张朝杰 +2 位作者 金小军 金仲和 徐兆斌 《Journal of Central South University》 SCIE EI CAS 2013年第5期1285-1291,共7页
In low earth orbit (LEO) satellite or missile communication scenarios, signals may experience extremely large Doppler shifts and have short visual time. Thus, direct sequence spread spectrum (DSSS) systems should be a... In low earth orbit (LEO) satellite or missile communication scenarios, signals may experience extremely large Doppler shifts and have short visual time. Thus, direct sequence spread spectrum (DSSS) systems should be able to achieve acquisition in a very short time in spite of large Doppler frequencies. However, the traditional methods cannot solve it well. This work describes a new method that uses a differential decoding technique for Doppler mitigation and a batch process of FFT (fast Fourier transform) and IFFT (invert FFT) for the purpose of parallel code phase search by frequency domain correlation. After the code phase is estimated, another FFT process is carried out to search the Doppler frequency. Since both code phase and Doppler frequency domains are searched in parallel, this architecture can provide acquisition fifty times faster than conventional FFT methods. The performance in terms of the probability of detection and false alarm are also analyzed and simulated, showing that a signal-to-noise ratio (SNR) loss of 3 dB is introduced by the differential decoding. The proposed method is an efficient way to shorten the acquisition time with slightly hardware increasing. 展开更多
关键词 low earth orbit (LEO) satellite spread spectrum fast acquisition fast Fourier transform (FFT) Doppler mitigation
下载PDF
Raman spectroscopy de-noising based on EEMD combined with VS-LMS algorithm 被引量:3
9
作者 俞潇 许亮 +1 位作者 莫家庆 吕小毅 《Optoelectronics Letters》 EI 2016年第1期16-19,共4页
This paper proposes a novel de-noising algorithm based on ensemble empirical mode decomposition(EEMD) and the variable step size least mean square(VS-LMS) adaptive filter.The noise of the high frequency part of spectr... This paper proposes a novel de-noising algorithm based on ensemble empirical mode decomposition(EEMD) and the variable step size least mean square(VS-LMS) adaptive filter.The noise of the high frequency part of spectrum will be removed through EEMD,and then the VS-LMS algorithm is utilized for overall de-noising.The EEMD combined with VS-LMS algorithm can not only preserve the detail and envelope of the effective signal,but also improve the system stability.When the method is used on pure R6G,the signal-to-noise ratio(SNR) of Raman spectrum is lower than 10dB.The de-noising superiority of the proposed method in Raman spectrum can be verified by three evaluation standards of SNR,root mean square error(RMSE) and the correlation coefficient ρ. 展开更多
关键词 ALGORITHMS Mean square error Raman scattering System stability
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部