快速成型机中的树脂液面刮平装置研究

在快速造型中，待树脂淹过已固化层并稳定后，才能进行扫描。由于树脂的粘性较大，流动性差以及固化层表面张力的作用，如果完全靠树脂的自然流动达到液面静止，时间较长，本文设计了一种刮平装置，能够使液面尽快稳定下来，时间显著缩短。

关于弯曲液面蒸气压的两点讨论

以外压对蒸气压的影响及开尔文方程为理论依据,讨论了外压对弯曲液面蒸气压的影响,其结果与外压对平液面蒸气压的影响相同。讨论了液体内部气泡的蒸气压,给出了气泡内蒸气压的计算公式,并对现实中的实例进行了计算说明。

FLNG液舱晃荡压力影响因素及安全性评估研究

针对大型浮式液化天然气储卸生产装置FLNG的液舱晃荡压力变化特征,在深水试验池中开展带液舱模型的FLNG水池模型试验研究。通过试验,获得了FLNG在风浪流联合作用下的浮体六自由度运动,以及相应的液面高度变化数据。通过液舱的液面高度变化数据,提出平液面假设,并在此基础上,求得液舱晃荡引起的舱壁压力变化结果。研究中进一步讨论了液舱晃荡压力的影响因素,并将试验数据与CCS船级社规范计算结果进行对比,为FLNG液舱晃荡压力引起的结构安全性评估提供技术支持。

Solution-processed perovskite solar cells

Perovskite solar cells(PSCs) have emerged as one of the most promising candidates for photovoltaic applications. Low-cost, low-temperature solution processes including coating and printing techniques makes PSCs promising for the greatly potential commercialization due to the scalability and compatibility with large-scale, roll-to-roll manufacturing processes. In this review, we focus on the solution deposition of charge transport layers and perovskite absorption layer in both mesoporous and planar structural PSC devices. Furthermore, the most recent design strategies via solution deposition are presented as well, which have been explored to enlarge the active area, enhance the crystallization and passivate the defects, leading to the performance improvement of PSC devices.

Determining the hydrodynamic forces on a planing hull in steady motion

A combination of methods was developed that can determine hydrodynamic forces on a planing hull in steady motion.Firstly,a potential-based boundary-element method was used to calculate the hydrodynamic pressure,induced resistance and lift.Then the frictional resistance component was determined by the viscous boundary layer theory.Finally,a particular empirical technique was applied.to determine the region of upwash geometry and determine spray resistance.Case studies involving four models of Series 62 planing craft were run.These showed that the suggested method is efficient and capable,with results that are in good agreement with experimental measurements over a wide range of volumetric Froude numbers.

Prediction of Pressure Gradient and Holdup in Small Eoetvoes Number Liquid-Liquid Segregated Flow

The segregated flow pattern, which occurs in a 26.1 mm diameter, horizontal, stainless steel test section, is investigated. Pressure gradient and in situ phase distribution data were obtained for different combinations of phase superficial velocities ranging from 0.05 m.s^-1 to 0,96 m.s^-1. For the current small Eoetvoes number liquid-liquid system （EOD=4.77）, the dominant effect of interfacial tension and wall-wetting properties of the liquids over the gravity is considered. The approach introduces the closure relationship for the case of turbulent flow m a rough pipe, and attempts to modify the two-fluid model to account for the curved interface. In present flow rates range, wave amplitudes were found small, while interfacial mixing was observed. An adjustable definition for hydraulic diame- ters of two fluids and interfacial friction factor is adopted. The predicted pressure gradient and in situ phase distribution data have been compared with present experimental data and those reported in the literature.

Partition Equilibrium Between Charged Membrane and Single Electrolyte Aqueous Solution

Ionic partition equilibrium in charged membrane immersed in solution of single electrolyte with monovalence or multi-valence is systematically investigated and several expressions are established for determination of partition coefficients. On this basis, the effects of the ratio of membrane charge density to bulk electrolyte solution concentration, the charge sign and valence of electrolyte ions and the type of membrane on the partition equilibrium were analyzed and simulated within chosen parameters. It is revealed that ion partition is not related solely with the respective concentrations but also definitely with the concentration ratio of fixed group to bulk solution in addition to the charge sign and the valence. For a counterion, the partition coefficient increases with this ratio and the valence; while for a coion, the partition coefficient decreases with this ratio and the valence. The theoretical calculations were compared with the experimental data and a good agreement was observed.

Large Area Flat-screen Liquid Crystal Television

A modular flat-screen liquid crystal television display is described.The picture elements of the modules may be emissive,reflective or transmissive.The flat-screen liquid crystal television also comprised of an electrical control circuit capable of categorizing incoming television picture signals corresponding to the modules in the array and directing the electrical signals to the drive circuits of each module according to the portion of the television picture to be reproduced by the picture elements of that module.The picture elements are preferably formed in a light modulating film composed of a liquid crystal dispersion in a polymeric binder.A color display was also produced by placing a patterned red-green-blue filter adjacent the active matrix so that each picture element could also be coordinated with the color components of a color video signal.

A preliminary research of a falling liquid film on a vertical wavy plane

The flow of a freely falling liquid film of low Reynolds number down a vertical long periodic sine-shaped wavy plate of small corrugations is researched theoretically. A model based on perturbation method and power series is presented. A stream function is introduced into the governing equations and two sets of equations describing the film flow separately at zeroth and first order are developed. The zeroth order equation is solved directly. The first order equations is solved at the leading approximation. Effect of parameters Re, M, λ and ε on the free surface wave of film is discussed.

Symmetry and nonexistence of positive solutions to an integral system with weighted functions

Consider the system of integral equations with weighted functions in Rn,{u(x) =∫Rn|x-y|α-nQ(y)v(y)qdy1,v(x)=∫Rn|x-y|α-nK(y)u(y)pdy,where 0 < α < n,1/(p+1) + 1/(q+1)≥(n-α)/n1,α/(n-α) < p1q < ∞1,Q(x) and K(x) satisfy some suitable conditions.It is shown that every positive regular solution(u(x)1,v(x)) is symmetric about some plane by developing the moving plane method in an integral form.Moreover,regularity of the solution is studied.Finally,the nonexistence of positive solutions to the system in the case 0 < p1q <(n+α)/(n-α) is also discussed.

Correlation of the Cerebral Microvascular Blood Flow with Brain Temperature and Electro-Acupuncture Stimulation

Objective:To investigate the relationship between the temperature and the microvascular blood flow of the cerebral cortex, and the influence of electro-acupuncture (EA) on the cortical microcirculation. Methods: High temperature spots on the anterior ectosylvian and low temperature spots on the posterior suprasylvian on the cortical surface of 20 cats were identified using cortical infrared thermography (CIT); the blood flow in the microcirculation on these spots was measured with laser-Doppler flowmetry. EA was given at Zusanli (ST 36) and changes in the blood flow in the cerebral cortex microcirculation were detected. Results: 1) The mean temperatures on the high (34.83±0.24°C) and low (32.28±0.27°C) temperature spots were significantly different (P<0.001); this was indicative of a temperature difference on the cortical surface; 2) The average blood flow in the microcirculation of the high (266.8±19.2 PU) and low (140.8±9.9 PU) temperature spots was significantly different (P<0.001). 3) On the cortical high temperature spots, the mean blood flow in the microcirculation significantly increased from 266.8±86.8 PU before EA, to 422.5±47.4 PU following 5 minutes of EA (58.35%; P<0.01), and 431.8±52.8 PU 5 minutes after ceasing EA (61.84%; P<0.01). 4) On the low temperature spots, there were no significant differences in blood flow following 5 minutes of EA (146.3±11.5 PU), and 5 minutes after ceasing EA (140.5±11.6 PU), when compared with that before acupuncture (140.8±9.9 PU; P>0.9). Conclusion: The high temperature spots of the cortex are active functional regions of neurons with higher blood flow and a stronger response to EA. EA induces a significant increase in blood flow in the high temperature spots of the cortex.

Growth of 2D MoP single crystals on liquid metals by chemical vapor deposition

Two-dimensional(2 D) transition metal phosphides(TMPs) are predicted with many novel properties and various applications. As a member of TMPs family, molybdenum phosphide(MoP) exhibits many exotic physicochemical properties. However, the synthesis of high-quality2 D MoP single crystals is not reported due to the lack of reliable fabrication method, which limits the exploration of 2 D MoP. Here, we report the growth of high-quality ultrathin MoP single crystals with thickness down to 10 nm on liquid metals via chemical vapor deposition(CVD). The smooth surface of liquid Ga is regarded as a suitable growth substrate for producing 2 D MoP single crystals. The Mo source diffuses toward the Ga surface due to the high surface energy to react with phosphorus source, thus to fabricate ultrathin MoP single crystals. Then, we study the second harmonic generation(SHG) of 2 D MoP for the first time due to its intrinsic noncentrosymmetric structure. Our study provides an new approach to synthesize and explore other 2 D TMPs for future applications.