In-situ reactive compatibilization of high-density polyethylene （HDPE）/ground tire rubber （GTR） blends by dicumyl peroxide （DCP） and HY-2045 - a kind of thermoplastic phenolic resin without catalyst was inves...In-situ reactive compatibilization of high-density polyethylene （HDPE）/ground tire rubber （GTR） blends by dicumyl peroxide （DCP） and HY-2045 - a kind of thermoplastic phenolic resin without catalyst was investigated by studying the mor-phology, stress and strain behavior, dynamic mechanical properties and crystallization performance of the blends. Scanning e-lectron microscopy （SEM） results show that there are a lot of fibrous materials distributing in the interface, which connects the dispersed phase with the matrix and obtains better interfacial strength for prominent mechanical properties. The addition of compatibilizers results in the decrease of crystallinity of the blends and the disappearance of an obvious yield phenomenon, which was proved by the differential scanning calorimeter （DSC） test and X-ray diffraction （XRD） characterization Although the crystallinity of the blends decreases,the tensile strength and tensile strain of the blends significantly increases, especially for the HDPE/GTR/DCP/HY-2045 blends, which is possibly attributed to the good compatibility of the blends owing to the in-situ interface crosslinking. In addition, it is found that the compatibilizing HDPE/GTR blends shows a higher tan^ peak temperature and a broaden transition peak for GTR phase.展开更多
The electrochemical treatment of wastewater containing chlorophenols （2-monochlorophenol, 4-monochlorophenol, 2,4-dichlorophenol, 2,4,6-trichlorophenol） was carried out experimentally with synthetic boron-d0ped diam...The electrochemical treatment of wastewater containing chlorophenols （2-monochlorophenol, 4-monochlorophenol, 2,4-dichlorophenol, 2,4,6-trichlorophenol） was carried out experimentally with synthetic boron-d0ped diamond （BDD） thin film electrodes. Current vs time curves under different cell voltages were measured. Removal rate of COD, instant current efficiency （ICE） and energy consumption were investigated under different current densities. The influence of supporting media is reported, which plays an important role in determining the global oxidation rate. The oxidative chloride is stronger than peroxodisulphate. The electrochemical characteristics of boron-doped diamond electrodes were investigated in comparison with active coating Ti substrate anode （ACT）. The experimental results show that BDD is markedly superior to ACT due to its different absorption properties.展开更多
The integrated high gravity-ultrasonic/ozonation/electrolysis technology was applied in the pretreatment of wastewater containing nitrobenzene. The effect ofpH value, high gravity factor, liquid flow-rate and electric...The integrated high gravity-ultrasonic/ozonation/electrolysis technology was applied in the pretreatment of wastewater containing nitrobenzene. The effect ofpH value, high gravity factor, liquid flow-rate and electric current density on removal of COD and nitrobenzene compounds was investigated. Experimental results have determined the optimal pro- cess regime involving a high gravity factor of 100, an electric current density of 20 mA/cm2, a liquid flow-rate of 100 L/h, and an initial liquid pH value of 11. After the wastewater had been treated for 180 rain, the degradation of nitrobenzene and COD reached 99% and 80%, respectively, with the biochemical coefficient （BOD/COD） equating to 0.64, and the subse- quent treatment of wastewater could be carried out by conventional biochemical means. Compared with traditional aeration- ozone contactors, a rotating packed bed with high mass transfer characteristics could be used to increase the ozonation treat- ment efficiency.展开更多
The new reactor concepts are characterized by higher efficiency, better utilization of nuclear fuel and nuclear waste minimization. This approach means that it is necessary to continue a continued research and test of...The new reactor concepts are characterized by higher efficiency, better utilization of nuclear fuel and nuclear waste minimization. This approach means that it is necessary to continue a continued research and test of new materials in order to apply them in new reactors. In this study, the authors fbcused on the analysis of SiC alloys because, due to their particular properties, this alloy can be used in high temperature conditions where the pure silicon, semiconductor material par excellence, is inadequate to support them.展开更多
文摘In-situ reactive compatibilization of high-density polyethylene （HDPE）/ground tire rubber （GTR） blends by dicumyl peroxide （DCP） and HY-2045 - a kind of thermoplastic phenolic resin without catalyst was investigated by studying the mor-phology, stress and strain behavior, dynamic mechanical properties and crystallization performance of the blends. Scanning e-lectron microscopy （SEM） results show that there are a lot of fibrous materials distributing in the interface, which connects the dispersed phase with the matrix and obtains better interfacial strength for prominent mechanical properties. The addition of compatibilizers results in the decrease of crystallinity of the blends and the disappearance of an obvious yield phenomenon, which was proved by the differential scanning calorimeter （DSC） test and X-ray diffraction （XRD） characterization Although the crystallinity of the blends decreases,the tensile strength and tensile strain of the blends significantly increases, especially for the HDPE/GTR/DCP/HY-2045 blends, which is possibly attributed to the good compatibility of the blends owing to the in-situ interface crosslinking. In addition, it is found that the compatibilizing HDPE/GTR blends shows a higher tan^ peak temperature and a broaden transition peak for GTR phase.
基金Project(20113282241450) supported by the Science and Technology Program from Ministry of Transport of China
文摘The electrochemical treatment of wastewater containing chlorophenols （2-monochlorophenol, 4-monochlorophenol, 2,4-dichlorophenol, 2,4,6-trichlorophenol） was carried out experimentally with synthetic boron-d0ped diamond （BDD） thin film electrodes. Current vs time curves under different cell voltages were measured. Removal rate of COD, instant current efficiency （ICE） and energy consumption were investigated under different current densities. The influence of supporting media is reported, which plays an important role in determining the global oxidation rate. The oxidative chloride is stronger than peroxodisulphate. The electrochemical characteristics of boron-doped diamond electrodes were investigated in comparison with active coating Ti substrate anode （ACT）. The experimental results show that BDD is markedly superior to ACT due to its different absorption properties.
基金the National Nature Science Foundation of China (No. 21206153)the Science and Science and Technology Development Program of Taiyuan Municipal Government (No. 120164053) for financial support
文摘The integrated high gravity-ultrasonic/ozonation/electrolysis technology was applied in the pretreatment of wastewater containing nitrobenzene. The effect ofpH value, high gravity factor, liquid flow-rate and electric current density on removal of COD and nitrobenzene compounds was investigated. Experimental results have determined the optimal pro- cess regime involving a high gravity factor of 100, an electric current density of 20 mA/cm2, a liquid flow-rate of 100 L/h, and an initial liquid pH value of 11. After the wastewater had been treated for 180 rain, the degradation of nitrobenzene and COD reached 99% and 80%, respectively, with the biochemical coefficient （BOD/COD） equating to 0.64, and the subse- quent treatment of wastewater could be carried out by conventional biochemical means. Compared with traditional aeration- ozone contactors, a rotating packed bed with high mass transfer characteristics could be used to increase the ozonation treat- ment efficiency.
文摘The new reactor concepts are characterized by higher efficiency, better utilization of nuclear fuel and nuclear waste minimization. This approach means that it is necessary to continue a continued research and test of new materials in order to apply them in new reactors. In this study, the authors fbcused on the analysis of SiC alloys because, due to their particular properties, this alloy can be used in high temperature conditions where the pure silicon, semiconductor material par excellence, is inadequate to support them.
