量子力学的非定域性

以科学实验为依据,阐述EPR纠缠光子时的非定域特征,并由微现粒子的实际存在状况,推论出量子力学的非定域性质及表现形式。提出:这种非定域性无疑是可能开发的量子信息技术的宝贵资源,是否也是一些神秘生命现象的物理基础?

Synthesis,characterization and photocatalytic performance of rod-shaped Pt/PbWO_4 composite microcrystals

Rod-shaped PbW O4 microcrystals of length 1 μm were fabricated by a hydrothermal route and subsequent calcination. Pt nanoparticles（NPs） of different contents（0.5 wt%,1 wt% and 2 wt%） were subsequently deposited on the PbW O4 microcrystals,producing robust Pt/PbW O4 composite microcrystals. The PbW O4 microcrystals and Pt/PbW O4 photocatalysts were characterized by X-ray diffraction,N2 sorption measurements,scanning electron microscopy,transmission electron microscopy,and X-ray photoelectron,photoluminescence,Fourier-transform infrared,and ultraviolet-visible diffuse reflectance spectroscopies. The photocatalytic performances of the catalysts were evaluated by the consecutive photocatalytic degradation of acid orange II dye. The Pt/PbW O4 composite microcrystals exhibited high photocatalytic activity and stability. The deposition of Pt NPs produced surface plasmon resonance（SPR）,which induced a large visible light absorption. A Pt NP content of 1-2 wt% resulted in an ~2 times increase in photocatalytic activity,compared with the activity of Pt/PbW O4. The crystal structure and high crystallinity of PbW O4 resulted in its favorable photocatalytic property,and the SPR effect of the Pt NPs promoted visible light harvesting. The Pt NPs also enhanced the separation of photo-generated electrons and holes,which further promoted the photocatalytic reaction.

Preparation of electrolytic copper powders with high current efficiency enhanced by super gravity field and its mechanism

Super gravity field was employed to enhance electrolytic reaction for the preparation of copper powders.The morphology, microstructure and size of copper powders were characterized by scanning electron microscopy,X-ray diffractometry and laser particle analysis.The results indicated that current efficiencies of electrolytic copper powders under super gravity field increased by more than 20% compared with that under normal gravity condition.Cell voltage under super gravity field was also much lower.The size of copper powders decreased with the increase of gravity coefficient(G).The increase of current efficiency can be contributed to the disturbance of electrode/electrolyte interface and enhanced mass transfer of Cu2+ in super gravity field.Meanwhile,the huge gravity acceleration would promote the detachment of copper powders from electrode surface during electrolytic process,which can prevent the growth of copper powders.

Effect of Ultrafine Particles on Flow Field and Transport Properties near the Interface Around a Moving Bubble

Laser Doppler Anemometer has been used to measure the flow field characteristics near the interface around a moving bubble in the presence of ultrafine particles. In order to model a moving bubble, the bubble was fixed into the counter flow liquid by a metal mesh. Experimental materials are air and water, and the particles are complex oxidate powder. Experiments were carried out under the operating conditions: the liquid flow velocity u 0 is 12.6 cm/s, the equivalent diameter d e is 0.6 cm, the mass concentration of particle is 0.2 0 0 ,the average particle diameter is about 10 nm and the density is 2 g/cm 3. The velocity profiles of both frontal and tail vortex areas were measured respectively. The experimental results show that the velocity fields are obviously changed in the existence of particles. In the frontal area of the bubble, both tangential and normal velocities decrease due to the presence of particles, but in tail vortex area, the tangential velocities increase remarkably, and normal velocities rise gradually from the center towards the fringe in the opposite tendency to that of no particles. The influences of flow field change in the presence of particles on gas liquid mass transfer are analyzed and discussed.

SPH-FEM simulations of microwave-treated basalt strength

Microwave precondition has been highlighted as a promising technology for softening the rock mass prior to rock breakage by machine to reduce drill bit/cutter wear as well as inverse production rate.To numerically explore the effect of numerical parameters on rock static strength simulation,and determine the numerical mechanical parameters of microwave-treated basalts for future drilling and cutting simulations,numerical models of uniaxial compression strength(UCS)and Brazilian tensile strength(BTS)were established with the coupling of smoothed particle hydrodynamics and finite element method(SPH-FEM).To eliminate the large rock strength errors caused by microwave-induced damage,the cohesion and internal friction angle of microwave-treated basalt specimens with the same microwave treatment parameters were calibrated based on a linear Mohr-Coulomb theory.Based on parametric sensitivity analysis of SPH simulation of UCS and BTS,experimental UCS and BTS values were simultaneously captured according to the same set of calibrated cohesion and internal friction angle data,and the UCS modeling results are in good agreement with experimental tests.Furthermore,the effect of microwave irradiation parameter on the basalt mechanical behaviors was evaluated.

Microemulsion synthesis and photocatalytic activity of visible light-active BiVO_4 nanoparticles

A water-in-oil microemulsion made up of a cyclohexane/n-hexyl alcohol/Polyethylene glycol tertoctylphenyl/aqueous solution including Bi3+ and VO+3 ions yields the spherical BiVO4 precursors with the size from 5 to 300 nm. Well-crystallized monoclinic scheelite BiVO4 particles with nanometer or micrometer size are fabricated in control by heating microemulsion precursors under various temperatures. The corresponding nucleation and growth process of as-prepared samples has also been investigated via TEM,which demonstrates the detailed morphological evolution of nuclei inside the precursors. As-prepared BiVO4 photocatalysts exhibit enhanced photocatalytic activity under visible-light irradiation in comparison with the bulk BiVO4 prepared by solid-state reaction. The highest RB degrading efficiency of 98% in 180 min under visible-light irradiation is observed for the sample calcined at 600 °C.

Production of Graphene Nanospheres by Annealing of Graphene Oxide in Solution

We report a simple method to produce graphene nanospheres （GNSs） by annealing graphene oxide （GO） solution at high-temperature with the assistance of sparks induced by the microwave absorption of graphite flakes dispersed in the solution. The GNSs were formed by rolling up of the annealed GO, and the diameters were mostly in the range 300-700 nm. The GNS exhibited a hollow sphere structure surrounded by graphene walls with a basal spacing of 0.34 nm. Raman spectroscopy and X-ray photoelectron spectroscopy of the GNSs confirmed that the GO was efficiently reduced during the fabrication process. The resulting GNSs may open up new opportunities both for fundamental research and applications, and this method may be extended to the synthesis of other nanomaterials and the fabrication of related nanostructures.

Optical tweezers technique and its applications

Since their advent in the 1980s,optical tweezers have attracted more and more attention due to their unique non-contact and non-invasion characteristics and their wide applications in physics,biology,chemistry,medical science and nanoscience.In this paper,we introduce the basic principle,the history and typical applications of optical tweezers and review our recent experimental works on the development and application of optical tweezers technique.We will discuss in detail several technological issues,including high precision displacement and force measurement in single-trap and dual-trap optical tweezers,multi-trap optical tweezers with each trap independently and freely controlled by means of space light modulator,and incorporation of cylindrical vector optical beams to build diversified optical tweezers beyond the conventional Gaussian-beam optical tweezers.We will address the application of these optical tweezers techniques to study biophysical problems such as mechanical deformation of cell membrane and binding energy between plant microtubule and microtubule associated proteins.Finally we present application of the optical tweezers technique for trapping,transporting,and patterning of metallic nanoparticles,which can be harnessed to manipulate surface plasmon resonance properties of these nanoparticles.

Cytotoxicity of mitochondrial-targeting silica-coated manganese oxide nanoparticles

The mitochondrion is a promising target for diagnosis and therapy. Mitochondrial-targeting silica-coated manganese oxide nanoparticles(Mn O@Si O2-PPh3+ NPs) were successfully synthesized to explore the mitochondrial cytotoxicity of nanoparticles. The mitochondrial targeting property was confirmed by a laser scanning confocal microscopy experiment. Even after incubation for only 4 h, the cytotoxicity of Mn O@Si O2-PPh3+ NPs against cancer cells was obvious; the ATP content was significantly decreased to 40%; and the mitochondrial membrane potential was depleted. All of these results indicated the collapse of mitochondrial function and the start of a cell apoptosis pathway. Our findings suggest that mitochondrial-mediated apoptosis could be strengthened by targeting to the subcellular compartment.