Given that fretting wear causes failure in steel wires, we carried out tangential fretting wear tests of steel wires on a self-made fretting wear test rig under contact loads of 9 and 29 N and fretting amplitudes rang...Given that fretting wear causes failure in steel wires, we carried out tangential fretting wear tests of steel wires on a self-made fretting wear test rig under contact loads of 9 and 29 N and fretting amplitudes ranging from 5 to 180 μm. We observed morphologies of fretted steel wire surfaces on an S-3000N scanning electron microscope in order to analyze fretting wear mecha-nisms. The results show that the fretting regime of steel wires transforms from partial slip regime into mixed fretting regime and gross slip regime with an increase in fretting amplitudes under a given contact load. In partial slip regime, the friction coefficient has a relatively low value. Four stages can be defined in mixed fretting and gross slip regimes. The fretting wear of steel wires in-creases obviously with increases in fretting amplitudes. Fretting scars present a typical morphology of annularity, showing slight damage in partial slip regime. However, wear clearly increases in mixed fretting regime where wear mechanism is a combination of plastic deformation, abrasive wear and oxidative wear. In gross slip regime, more severe degradation is present than in the other regimes. The main fretting wear mechanisms of steel wires are abrasive wear, surface fatigue and friction oxidation.展开更多
Objective. To testify the phenomenon that large amplitude action potential appears at the early stage of facial paralysis, and to search for the mechanism through clinical and experimental ...Objective. To testify the phenomenon that large amplitude action potential appears at the early stage of facial paralysis, and to search for the mechanism through clinical and experimental studies. Patients(animals) and methods. The action potentials of the orbicular ocular and oral muscles were recorded in 34 normal persons by electromyogram instruments. The normal range of amplitude percentage was found out according to the normal distribution. One hundred patients with facial paralysis were also studied. The action potentials of facial muscles were recorded in 17 guinea pigs before and after the facial nerve was compressed and the facial nerve was examined under electromicroscope before and after the compression. Results. The amplitude percentage of the suffered side to the healthy side was more than 153 percent in 6 of the 100 patients. Large amplitude action potential occured in 35 per cent guinea pigs which were performed the experiment of facial nerve compression. Electromicroscopic examination revealed separation of the lammae of the facial nerve’s myelin sheath in the guinea pigs which exhibited large amplitude action potential. Conclusion. The facial nerve exhibited a temporary over excitability at the early stage of facial nerve injury in some patients and guinea pigs. If the injury was limited in the myelin sheath, the prognosis was relatively good.展开更多
The microscopic-scale Richtmyer-Meshkov(RM) instability of a single-mode Cu-He interface subjected to a cylindrically converging shock is studied through the classical molecular dynamics simulation. An unperturbed int...The microscopic-scale Richtmyer-Meshkov(RM) instability of a single-mode Cu-He interface subjected to a cylindrically converging shock is studied through the classical molecular dynamics simulation. An unperturbed interface is first considered to examine the flow features in the convergent geometry, and notable distortions at the circular inhomogeneity are observed due to the atomic fluctuation. Detailed processes of the shock propagation and interface deformation for the single-mode interface impacted by a converging shock are clearly captured. Different from the macroscopic-scale situation, the intense molecular thermal motions in the present microscale flow introduce massive small wavelength perturbations at the single-mode interface, which later significantly impede the formation of the roll-up structure. Influences of the initial conditions including the initial amplitude,wave number and density ratio on the instability growth are carefully analyzed. It is found that the late-stage instability development for interfaces with a large perturbation does not depend on its initial amplitude any more. Surprisingly, as the wave number increases from 8 to 12, the growth rate after the reshock drops gradually. The distinct behaviors induced by the amplitude and wave number increments indicate that the present microscopic RM instability cannot be simply characterized by the amplitude over wavelength ratio(η). The pressure history at the convergence center shows that the first pressure peak caused by the shock focusing is insensitive to η, while the second one depends heavily on it.展开更多
基金supported by the National Natural Science Foundation of China (No 50875252)the Program for New Century Excellent Talents in Universities (NoNCET-06-0479)the Natural Science Foundation of Jiangsu Province (NoBK2008005)
文摘Given that fretting wear causes failure in steel wires, we carried out tangential fretting wear tests of steel wires on a self-made fretting wear test rig under contact loads of 9 and 29 N and fretting amplitudes ranging from 5 to 180 μm. We observed morphologies of fretted steel wire surfaces on an S-3000N scanning electron microscope in order to analyze fretting wear mecha-nisms. The results show that the fretting regime of steel wires transforms from partial slip regime into mixed fretting regime and gross slip regime with an increase in fretting amplitudes under a given contact load. In partial slip regime, the friction coefficient has a relatively low value. Four stages can be defined in mixed fretting and gross slip regimes. The fretting wear of steel wires in-creases obviously with increases in fretting amplitudes. Fretting scars present a typical morphology of annularity, showing slight damage in partial slip regime. However, wear clearly increases in mixed fretting regime where wear mechanism is a combination of plastic deformation, abrasive wear and oxidative wear. In gross slip regime, more severe degradation is present than in the other regimes. The main fretting wear mechanisms of steel wires are abrasive wear, surface fatigue and friction oxidation.
文摘Objective. To testify the phenomenon that large amplitude action potential appears at the early stage of facial paralysis, and to search for the mechanism through clinical and experimental studies. Patients(animals) and methods. The action potentials of the orbicular ocular and oral muscles were recorded in 34 normal persons by electromyogram instruments. The normal range of amplitude percentage was found out according to the normal distribution. One hundred patients with facial paralysis were also studied. The action potentials of facial muscles were recorded in 17 guinea pigs before and after the facial nerve was compressed and the facial nerve was examined under electromicroscope before and after the compression. Results. The amplitude percentage of the suffered side to the healthy side was more than 153 percent in 6 of the 100 patients. Large amplitude action potential occured in 35 per cent guinea pigs which were performed the experiment of facial nerve compression. Electromicroscopic examination revealed separation of the lammae of the facial nerve’s myelin sheath in the guinea pigs which exhibited large amplitude action potential. Conclusion. The facial nerve exhibited a temporary over excitability at the early stage of facial nerve injury in some patients and guinea pigs. If the injury was limited in the myelin sheath, the prognosis was relatively good.
基金supported by the China Postdoctoral Science Foundation(Grant No.2016M602026)the National Natural Science Foundation of China(Grant Nos.11625211,and 11621202)+1 种基金the Science Challenge Project(Grant No.TZ2016001)the Fundamental Research Funds for the Central Universities
文摘The microscopic-scale Richtmyer-Meshkov(RM) instability of a single-mode Cu-He interface subjected to a cylindrically converging shock is studied through the classical molecular dynamics simulation. An unperturbed interface is first considered to examine the flow features in the convergent geometry, and notable distortions at the circular inhomogeneity are observed due to the atomic fluctuation. Detailed processes of the shock propagation and interface deformation for the single-mode interface impacted by a converging shock are clearly captured. Different from the macroscopic-scale situation, the intense molecular thermal motions in the present microscale flow introduce massive small wavelength perturbations at the single-mode interface, which later significantly impede the formation of the roll-up structure. Influences of the initial conditions including the initial amplitude,wave number and density ratio on the instability growth are carefully analyzed. It is found that the late-stage instability development for interfaces with a large perturbation does not depend on its initial amplitude any more. Surprisingly, as the wave number increases from 8 to 12, the growth rate after the reshock drops gradually. The distinct behaviors induced by the amplitude and wave number increments indicate that the present microscopic RM instability cannot be simply characterized by the amplitude over wavelength ratio(η). The pressure history at the convergence center shows that the first pressure peak caused by the shock focusing is insensitive to η, while the second one depends heavily on it.
