润滑油微焦化试验方法研究初探

介绍了一种润滑油模拟试验方法———微焦化试验。该方法是评定润滑油高温稳定性能的有效的薄膜热氧化试验 ,经研究认为该试验方法与Caterpiller 1G2 台架试验有较好的相关性。

一“花”一“世界” 心与心共鸣——作文个性化表达例析

作文应该以个性化的特点去感染读者,进而产生心与心的共鸣。为实现一"花"一"世界"的目标,让作文富有个性,教师应从四个方面去努力:叙事的"情境化";写景的"微焦化";修辞的"故事化";遣词的"雅语化"。

Droplet Pattern Formation and Translation in New Microfluidic Flow- Focusing Devices

We conducted experiments on specially designed microfluidic chips that generate droplets through a microfluidic ow-focusing approach. The fluid flow in the microfluidic channel produced a shear flow field at low Reynolds numbers. The droplets in the microfluidic system exhibited special droplet pattern formations similar to periodic crystal-like lattices because of the competition between shear forces and surface tension. By adjusting the flow rate ratio of the water （droplet phase） to oil （continuous phase） phases and changing the outlet channel widths, the droplets formed monolayer dispersion to double-layer formation to monolayer squeezing when the outlet channel widths were 250 or 300 μm. We also obtained droplets with monolayer dispersion, three-layer arrangements, double-layer squeezing, and monolayer squeezing when the outlet channel width was 350 μm. The outlet channel width was increased to 400 μm, and four-layer arrangements were observed. We also studied the translation of droplet formation, which resulted in a detailed strategy to control drop size and droplet pattern formation for emulsi cation in microfluidic devices. We expect that our strategy can provide theoretical guidance to synthesize dispersion or polydisperse colloid particles.

esearch and Application of Burned Microporous High Alumian—Graphite（Al／C） Brick in Blast Furnace

This paper inroduces the research background,technology,product property and application of burned microporous high alumina-graphite brick (Al2O3-C brick) used in blast furnace,The difference of property between Al2O3-C brick and other blast furnace refractories is discussed .The results of simulative tests show that ,Al2O3-C brick has good alkali resistance,slag resistance,thermal shock resistance,oxidation resistance,high thermal conductivity,low permeability and low solubility in molten iron,The brick with micropores of average radius less than 1μm has been successively applied to fourteen blast furnaces, the lining life of the brick is almost as long as that of Si3N4 bonded SiC brick Al2O3-C brick will be widely used in lower stack ,belly,bosh and hearth in the future.

Increased tumor necrosis factor receptor 1 expression in human colorectal adenomas

AIM: To determine the expression statuses of tumor necrosis factor (TNF)-α, its receptors (TNF-R) and downstream effector molecules in human colorectal adenomas. METHODS: We measured the serum concentrations of TNF-α and its receptors in 62 colorectal adenoma patients and 34 healthy controls. The protein expression of TNF-α, TNF-R1, TNF-R2 and downstream signals of the TNF receptors, such as c-Jun N-terminal kinase (JNK), nuclear factor-κ B and caspase-3, were also investigated in human colorectal adenomas and in normal colorectal mucosal tissues by immunohistochemistry. Immunofluorescence confocal microscopy was used to investigate the consistency of expression of TNF-R1 and phospho-JNK (p-JNK). RESULTS: The serum levels of soluble TNF-R1 (sTNF-R1) in adenoma patients were significantly higher than in the control group (3.67 ± 0.86 ng/mL vs 1.57 ± 0.72 ng/mL, P < 0.001). Receiver operating characteristic analysis revealed the high diagnostic sensitivity of TNF-R1 measurements (AUC was 0.928) for the diagnosis of adenoma, and the best cut-off level of TNF-R1 was 2.08 ng/mL, with a sensitivity of 93.4% and a specificity of 82.4%. There were no significant differences in the serum levels of TNF-α or sTNF-R2 between the two groups. Immunohistochemistry showed high levels of TNF-R1 and p-JNK expression in the epithelial cells of adenomas. Furthermore, a high incidence of co-localization of TNF-R1 and p-JNK was identified in adenoma tissue. CONCLUSION: TNF-R1 may be a promising biomarker of colorectal adenoma, and it may also play an important role in the very early stages of colorectal carcinogenesis.

Performance Appraisal of Controlled Low-strength Material Using Sewage Sludge and Refuse Incineration Bottom Ash

This research evaluated the use of sewage sludge and refuse incineration bottom ash to replace calcium sulfoaluminate cement （CSA） in making controlled low-strength material （CLSM）. Various properties of CLSM mixtures were characterized in terms of unconfined compressive strength, microstructure and leachability. It was found that the strength of tested CLSM mixtures ranged from 3.6 to 9.0 MPa, over the upper excavatable limit of 2.1 MPa. The micro-structural analysis revealed that sewage sludge and bottom ash were crystallochemically in- corporated within CLSM system_s by forming the needle-like ettringite （C3A＇3CS＇_H32） with exiguous tu.bers via the typical Pozzolanic Reaction, leading to a dense and low-porosity microst;＇ucture. Furthermore,-the toxicity characteristic leaching procedure evidenced that the cumulative leachable metals in the leachate were much below the regulatory thresholds. The potential for us!ng sewage sludge and bottom ash!n CLSM makin.g was thus confirmed.

Efficacy of Photogem（Hematoporphyrin Derivative） as a Photoactivatable Larvicide against Aedes aegypti （Diptera： Culicidae） Larvae

Dengue vector is responsible for millions of deaths every year and has caused disastrous impacts on health systems. The continuous use of chemical insecticides, such as carbamates, pyrethroids and organophosphates generates resistant populations of the mosquito, therefore, new control methods must be investigated. The joint action of the population and guidelines for preventing the reproduction of the mosquito associated with the use of photoactivatable insecticides can be the alternative for the control of epidemiological outbreaks in affected regions. In this study, the photo-larvicidal activity of Photogem^（PG）, a derivative of hematoporphyrin, was investigated against 2nd-early 3rd instar of Aedes aegypti larvae （Diptera： Culicidae） under different lighting conditions （artificial lighting system and sunlight）. The dynamics of PG accumulation was characterized by CLSM （confocal laser scanning microscopy） and total time PG eliminationin solution was investigated by ultraviolet-visible spectrophotometry. The maximum photo-activity of PG was observed in 0.5 h under sunlight exposure which achieved 100% larval mortality. Fluorescence images showed a uniform distribution of PG along the digestive tract. PG remained stable in the sunlight for 48 h and in an artificial lighting system for longer periods, therefore, it can be used for the control ofAedes aegypti larvae as a new alternative to chemical insecticides. The method is considered environmentally friendly due to its rapid degradation in the presence of light. Further studies are required, so that the potential of the technique can be explored in real breeding places.

Velocity Measurement of Induced Flow by a Laser Focusing Shock Wave

The objective of this study is to apply the shock wave for control in a micro channel. The shock wave was generated by a laser focusing of pulsed laser beam in the channel. Using a pulse laser to generate a shock wave, a non-stationary flow was induced in the small space between the parallel plates. The spherical and cylindrical shock propagations were observed with schlieren method. The shock Mach number decreases with time and approaches to unity. As reported in the previous investigations, the shock speed was attenuated in a short distance and time. In the present experiment, It was not found a remarkable difference in the shock speed between the spherical and cylindrical shock experiments. Subsequently, the flow induced by the cylindrical shock wave was studied using PIV technique. A smoke tracer was used in the experiment and its velocity was measured within 100 μs. A numerical simulation was carried out to investigate the momentum relaxation between the gas and smoke particle. A suitable shock initiation model was introduced in the simulation. The experimental results show that a wide acceleration and deceleration zone exist behind the shock wave. Also, the relaxation distance in the experimental data is much longer than that in numerical simulation.