In this study, a three-dimensional mesoscale model was used to numerically simulate the well-known "98.7" heavy rainfall event that affected the Yangtze Valley in July 1998. Two experiments were conducted to...In this study, a three-dimensional mesoscale model was used to numerically simulate the well-known "98.7" heavy rainfall event that affected the Yangtze Valley in July 1998. Two experiments were conducted to analyze the impact of moist processes on the development of meso-β scale vortices(MβV) and their triggering by mesoscale wind perturbation(MWP). In the experiment in which the latent heat feedback(LHF) scheme was switched off, a stable low-level col field(i.e., saddle field—a region between two lows and two highs in the isobaric surface) formed, and the MWP triggered a weak MβV. However, when the LHF scheme was switched on as the MWP was introduced into the model, the MβV developed quickly and intense rainfall and a mesoscale low-level jet(mLLJ) were generated. The thickness of the air column and average temperature between 400 and 700 hPa decreased without the feedback of latent heat, whereas they increased quickly when the LHF scheme was switched on, with the air pressure falling at low levels but rising at upper levels. A schematic representation of the positive feedbacks among the mesoscale vortex, rainfall, and mLLJ shows that in the initial stage of the MβV, the MWP triggers light rainfall and the latent heat occurs at low levels, which leads to weak convergence and ageostrophic winds. In the mature stage of the MβV, convection extends to the middle-to-upper levels, resulting in an increase in the average temperature and a stretching of the air column. A low-level cyclonic circulation forms under the effect of Coriolis torque, and the m LLJ forms to the southeast of the MβV.展开更多
WT8.BZ]The effects of postgrowth rapid thermal annealing have been studied on the optical properties of 3-nm-height InAs/GaAs quantum dots covered by 3-nm-thick In xGa 1-x As (x=0,0 1 and 0 2) overgrowth layer...WT8.BZ]The effects of postgrowth rapid thermal annealing have been studied on the optical properties of 3-nm-height InAs/GaAs quantum dots covered by 3-nm-thick In xGa 1-x As (x=0,0 1 and 0 2) overgrowth layer.At a higher annealing temperature (T≥750℃),the photoluminescence peak of InGaAs layer has been observed at the lower-energy side of InAs quantum-dot peak.In addition,a similar blueshift in photoluminescence (PL) emission energy is observed for all samples when the annealing temperature increases from 650 to 850℃.However,the trend of photoluminescence linewidth towards narrowing is totally different for InAs quantum dots with different In mole fraction in InGaAs overgrowth layer.The results suggest that the intermixing in the lateral direction plays an important role in obtaining a better understanding of the modification of optical properties induced by the rapid thermal annealing.展开更多
The effect of rapid thermal annealing on the optical properties of astrained InAs/InP single quantum well structrure has been investigated in this paper.The luminescence intensity of the quantum well at 8 K was increa...The effect of rapid thermal annealing on the optical properties of astrained InAs/InP single quantum well structrure has been investigated in this paper.The luminescence intensity of the quantum well at 8 K was increased by a factor of 4 and 1.55 meV blue shift of the quantum well photoluminescence peak was observed after annealing at the optimal condition of 700℃ for 5 s. Furthermore,we found that the luminescence efficiency of the deep radiative levels in the samples was also affected by rapid thermal annealing.Our experimental results have demonstrated that Rapid thermal annealing significantly improves the crystalline quality of strained quantum well structures after growth and is an important way for enhancement of the performance of the laser device.展开更多
As human improve their ability to fabricate materials, alloys have evolved from simple to complex compositions, accordingly improving functions and performances,promoting the advancements of human civilization. In rec...As human improve their ability to fabricate materials, alloys have evolved from simple to complex compositions, accordingly improving functions and performances,promoting the advancements of human civilization. In recent years, high-entropy alloys（HEAs） have attracted tremendous attention in various fields. With multiple principal components, they inherently possess unique microstructures and many impressive properties, such as high strength and hardness, excellent corrosion resistance, thermal stability, fatigue,fracture, and irradiation resistance, in terms of which they overwhelm the traditional alloys. All these properties have endowed HEAs with many promising potential applications.An in-depth understanding of the essence of HEAs is important to further developing numerous HEAs with better properties and performance in the future. In this paper, we review the recent development of HEAs, and summarize their preparation methods, composition design, phase formation and microstructures, various properties, and modeling and simulation calculations. In addition, the future trends and prospects of HEAs are put forward.展开更多
基金supported by the National Grand Fundamental Research 973 Program of China (Grant No.2015CB452800)the National Natural Science Foundation of China (Grant Nos.41275099,41205073 and 41275012)the Natural Science Foundation of the Nanjing Joint Center of Atmospheric Research (Grant No.NJCAR2016MS02)
文摘In this study, a three-dimensional mesoscale model was used to numerically simulate the well-known "98.7" heavy rainfall event that affected the Yangtze Valley in July 1998. Two experiments were conducted to analyze the impact of moist processes on the development of meso-β scale vortices(MβV) and their triggering by mesoscale wind perturbation(MWP). In the experiment in which the latent heat feedback(LHF) scheme was switched off, a stable low-level col field(i.e., saddle field—a region between two lows and two highs in the isobaric surface) formed, and the MWP triggered a weak MβV. However, when the LHF scheme was switched on as the MWP was introduced into the model, the MβV developed quickly and intense rainfall and a mesoscale low-level jet(mLLJ) were generated. The thickness of the air column and average temperature between 400 and 700 hPa decreased without the feedback of latent heat, whereas they increased quickly when the LHF scheme was switched on, with the air pressure falling at low levels but rising at upper levels. A schematic representation of the positive feedbacks among the mesoscale vortex, rainfall, and mLLJ shows that in the initial stage of the MβV, the MWP triggers light rainfall and the latent heat occurs at low levels, which leads to weak convergence and ageostrophic winds. In the mature stage of the MβV, convection extends to the middle-to-upper levels, resulting in an increase in the average temperature and a stretching of the air column. A low-level cyclonic circulation forms under the effect of Coriolis torque, and the m LLJ forms to the southeast of the MβV.
文摘WT8.BZ]The effects of postgrowth rapid thermal annealing have been studied on the optical properties of 3-nm-height InAs/GaAs quantum dots covered by 3-nm-thick In xGa 1-x As (x=0,0 1 and 0 2) overgrowth layer.At a higher annealing temperature (T≥750℃),the photoluminescence peak of InGaAs layer has been observed at the lower-energy side of InAs quantum-dot peak.In addition,a similar blueshift in photoluminescence (PL) emission energy is observed for all samples when the annealing temperature increases from 650 to 850℃.However,the trend of photoluminescence linewidth towards narrowing is totally different for InAs quantum dots with different In mole fraction in InGaAs overgrowth layer.The results suggest that the intermixing in the lateral direction plays an important role in obtaining a better understanding of the modification of optical properties induced by the rapid thermal annealing.
文摘The effect of rapid thermal annealing on the optical properties of astrained InAs/InP single quantum well structrure has been investigated in this paper.The luminescence intensity of the quantum well at 8 K was increased by a factor of 4 and 1.55 meV blue shift of the quantum well photoluminescence peak was observed after annealing at the optimal condition of 700℃ for 5 s. Furthermore,we found that the luminescence efficiency of the deep radiative levels in the samples was also affected by rapid thermal annealing.Our experimental results have demonstrated that Rapid thermal annealing significantly improves the crystalline quality of strained quantum well structures after growth and is an important way for enhancement of the performance of the laser device.
基金supported by the National Natural Science Foundation of China (51471025 and 51671020)
文摘As human improve their ability to fabricate materials, alloys have evolved from simple to complex compositions, accordingly improving functions and performances,promoting the advancements of human civilization. In recent years, high-entropy alloys（HEAs） have attracted tremendous attention in various fields. With multiple principal components, they inherently possess unique microstructures and many impressive properties, such as high strength and hardness, excellent corrosion resistance, thermal stability, fatigue,fracture, and irradiation resistance, in terms of which they overwhelm the traditional alloys. All these properties have endowed HEAs with many promising potential applications.An in-depth understanding of the essence of HEAs is important to further developing numerous HEAs with better properties and performance in the future. In this paper, we review the recent development of HEAs, and summarize their preparation methods, composition design, phase formation and microstructures, various properties, and modeling and simulation calculations. In addition, the future trends and prospects of HEAs are put forward.
