期刊文献+
共找到4篇文章
< 1 >
每页显示 20 50 100
凝汽器与低压缸排汽室喉部的焊接 被引量:1
1
作者 朱明 《华中电力》 2002年第5期55-56,60,共3页
凝汽器和低压缸排汽室喉部的焊接,对焊接变形的控制要求很高,只有采取正确的焊接工艺,同时严格监视和控制焊接变形,才能将由焊接引起的相对垂直位移差保持在允许的范围内,从而得到满意的效果。
关键词 低压缸 排汽室喉部 焊接 轮机
下载PDF
汽轮机高中压排汽腔室参数化设计方法研究 被引量:1
2
作者 李猛 杨锐 《热力透平》 2021年第1期34-38,共5页
高中压排汽腔室结构复杂,但影响流动损失的结构较少,可简化成轴对称的腔室形式。基于参数化建模,使用拉丁超立方抽样方法生成样本库,然后采用CFD方法计算所有样本点的气动性能,最后结合响应面分析方法拟合出了流动损失随各参数的变化规... 高中压排汽腔室结构复杂,但影响流动损失的结构较少,可简化成轴对称的腔室形式。基于参数化建模,使用拉丁超立方抽样方法生成样本库,然后采用CFD方法计算所有样本点的气动性能,最后结合响应面分析方法拟合出了流动损失随各参数的变化规律。结果表明:采用三阶多项式拟合效果较好,标准差为0.071,拟合度相关系数为0.85;根据响应面拟合的多项式,可快速准确地评估出腔室的性能,省去了CFD仿真等繁琐步骤;同时基于该多项式,根据参数取值范围,也可快速优化腔室结构。研究成果可为汽轮机高中压腔室快速化设计提供参考。 展开更多
关键词 轮机 高中压 样本库分析
下载PDF
BN4.5-1.25/0.15汽轮机主蒸汽压力及温度低于额定规范的运行分析
3
作者 邹建田 于英鳌 《水泥技术》 2017年第4期86-88,92,共4页
我公司有一条2500t/d熟料生产线,装有一台BN4.5-1.25/0.15汽轮发电机组。汽轮机主蒸汽由SP、AQC两台余热锅炉供给,汽轮机补汽由闪蒸器供给。在实际运行中,闪蒸器供出的蒸汽压力低于汽轮机的要求,不能进入汽轮机。汽轮机负荷的大小是由... 我公司有一条2500t/d熟料生产线,装有一台BN4.5-1.25/0.15汽轮发电机组。汽轮机主蒸汽由SP、AQC两台余热锅炉供给,汽轮机补汽由闪蒸器供给。在实际运行中,闪蒸器供出的蒸汽压力低于汽轮机的要求,不能进入汽轮机。汽轮机负荷的大小是由两台余热锅炉决定的,汽轮机负荷随回转窑运转工况的波动而波动。由于回转窑运转工况的波动,汽轮机经常在主蒸汽压力、温度低于额定规范的工况下运行。 展开更多
关键词 主蒸压力 轮发电机组 运转工况 余热锅炉 闪蒸器 主蒸流量 排汽室 抽气器
下载PDF
Energy and environmental life-cycle assessment of passenger car electrification based on Beijing driving patterns 被引量:4
4
作者 WANG He Wu ZHANG Xiao Bin OUYANG Ming Gao 《Science China(Technological Sciences)》 SCIE EI CAS CSCD 2015年第4期659-668,共10页
This paper examines the energy and environmental benefits within the whole life cycle shifting from traditional gasoline vehicles to electrified advanced vehicles under regional real-world driving behaviors. The advan... This paper examines the energy and environmental benefits within the whole life cycle shifting from traditional gasoline vehicles to electrified advanced vehicles under regional real-world driving behaviors. The advance vehicles focus on family passenger cars and include battery electric vehicles (BEVs), plug-in hybrid electric vehicles (PHEVs), and hybrid electric vehicles (HEVs). The GREET (greenhouse gases, regulated emissions, and energy use in transportation) model is adopted with regional circumstances modifications, especially the UF (utility factors) of PHEVs. The results show that the electrified vehicles offer great benefits concerning energy consumption, greenhouse gas (GHG) emissions as well as urban Particulate Matter 2,5 (PMz.s) emissions. Compared to conventional gasoline vehicles, the life-cycle total energy reduction for advance vehicles is 51% to 57%. There is little difference on energy reduction among the HEVs, PHEVs and BEVs, with the energy mix shifting from petroleum to coal for the stronger electrification. The reductions of GHG emissions are 57% for HEV, 54% to 48% for PHEVs with 10 miles to 40 miles CD range, and 40% for BEV. The life-cycle and local PM2.5 emissions are discussed separately. The life-cycle PM2.5 emissions increase with vehicle electrification and reach a maximum for the BEV which are 5% higher than the conventional vehicle (CV). However, electric vehicles can shift PM2.5 emissions from vehicle operation to upstream operations and help mitigate PM2.5 emissions in urban areas. The local emissions of PHEVs and BEVs can be reduced by 37% to 81% and 100% compared with CVs. 展开更多
关键词 electric vehicle greenhouse gas emissions PM2.5 emissions Beijing driving pattern
原文传递
上一页 1 下一页 到第
使用帮助 返回顶部